2006 MERCEDES-BENZ E320CDI adding oil

321 Operation
Engine compartment
Checking engine oil level with the con-
trol system
(E 320 CDI, E 500, E 55 AMG)
When checking the oil level

the vehicle must be parked on level
ground


with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least 5 minutes with
the engine turned off


with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the multi-
function display, do the following:

Switch on the ignition (
page 36).
The standard display (
page 153) should
appear in the multifunction display.

Press button k or j on the mul-
tifunction steering wheel until the fol-
lowing message is seen in the
multifunction display:One of the following messages will
subsequently appear in the multifunc-
tion display:


Engine oil level
ok


Add 1.0 Qt.
to reach max. oil level(Canada:
1.0 Liter
)


Add 1.5 Qts.
to reach max. oil level(Canada:
1.5 Liters
)


Add 2.0 Qts.
to reach max. oil level(Canada:
2.0 Liters
)

If necessary, add engine oil.
For adding engine oil, see (
page 323).
For more information on engine oil, see the
“Technical data” section (
page 484) and
(
page 487).
Other display messages
If the SmartKey or KEYLESS-GO start/stop
button* is not in position 2, the following
message will appear:
Switch ignition on
to check engine oil level
Switch on the ignition (
page 36).
If you see the message:
Observe waiting period
iIf you want to interrupt the checking
procedure, press buttonk orj
on the multifunction steering wheel.


323 Operation
Engine compartment
1Oil dipstick
2Upper (max) mark
3Lower (min) mark
To check the engine oil level with the oil
dipstick, do the following:
Open the hood (
page 319).

Pull out oil dipstick1.

Wipe oil dipstick1 clean.

Fully insert oil dipstick1 into the
dipstick guide tube.

Pull out oil dipstick1 again after
approximately 3 seconds to obtain ac-
curate reading.
The oil level is correct when it is be-
tween the lower (min) mark3 and
upper (max) mark2 of oil dipstick1.

If necessary, add engine oil.
For adding engine oil, see “Adding en-
gine oil”.
For more information on engine oil, see
“Fuels, coolants, lubricants etc.”
(
page 484).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(page 386).Adding engine oiliThe filling quantity between the upper
and lower marks on the oil dipstick is
approximately 2.1 US qt. (2.0 l).
!Only use approved engine oils and oil
filters required for vehicles with
Maintenance System (U.S. vehicles) or
FSS PLUS (Canada vehicles). For a
listing of approved engine oils and oil
filters, refer to the Factory Approved
Service Products pamphlet in your ve-
hicle literature portfolio, or contact an
authorized Mercedes-Benz Center.
Using engine oils and oil filters of spec-
ification other than those expressly re-
quired for the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada
vehicles), or changing of oil and oil filter
at change intervals longer than those
called for by the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada
vehicles) will result in engine damage
not covered by the Mercedes-Benz
Limited Warranty.

324 OperationEngine compartmentE350
E500E320CDI

Unscrew filler cap1 from filler neck.

Add engine oil as required. Be careful
not to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.

Screw filler cap1 back on filler neck.
For more information on engine oil, see the
“Technical data” section (
page 484) and
(
page 487).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Center
check the transmission.
!Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter (Gaso-
line engine) or oxidation catalyst
(Diesel engine) not covered by the
Mercedes-Benz Limited Warranty.

506 IndexEngine
Belt layout 469
Block heater* (Canada only) 359
Cleaning 366
Compartment 319
Malfunction indicator lamp 377, 378,
403
Maximum engine speed 471
Message in the display 377, 378,
403
Number 468, 494
Starting 50
Starting with KEYLESS-GO* 51
Starting with the SmartKey 51
Tachometer 25
Technical data 471
Turning off with KEYLESS-GO* 62
Turning off with the SmartKey 62
Engine compartment
Hood 319
Engine coolant see Coolant
Engine malfunction indicator lamp 377,
378, 403Engine oil
Adding 323
Additives 487
Changing 323
Checking level (Control system) 321
Checking level (Dipstick) 322
Consumption 320
Filler neck 324
Messages in display 321, 408
Recommended engine oils and oil
filter 487
Viscosity 494
Engine oil level 318
ESP
®
94, 494
Four wheel electronic traction system
with ESP
®
100
Messages in display 391
Warning lamp 375
ETD 494
Safety guidelines 70
Exterior rear view mirrors
Parking position 176
F
Factory, SmartKey with
KEYLESS-GO* 114
Filler neck, Engine oil 324First aid kit 422
Flat tire 441
Lowering the vehicle 447
Mounting the spare wheel 441, 444
Preparing the vehicle 441
Spare wheel 441
Flexible Service System see FSS
Floormats 284
Fluids
Automatic transmission fluid 484
Brake fluid 485
Capacities 484
Engine coolant 485
Engine oil 484
Power steering fluid 485
Windshield washer and headlamp
cleaning system 486
Fog lamps 144
Messages in display 412
Replacing bulbs 435
Four wheel electronic traction system with
ESP
® see 4MATIC
4MATIC 100
Front air bags 71
Front lamps see Headlamps