2006 MERCEDES-BENZ E WAGON adding oil

317 Operation
Engine compartment
Checking engine oil level with the con-
trol system (E 500, E 55 AMG)
When checking the oil level

the vehicle must be parked on level
ground


with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least 5 minutes with
the engine turned off


with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off
To check the engine oil level via the multi-
function display, do the following:

Switch on the ignition (
page 36).
The standard display (
page 155) should
appear in the multifunction display.

Press button k or j on the mul-
tifunction steering wheel until the fol-
lowing message is seen in the
multifunction display:One of the following messages will
subsequently appear in the multifunc-
tion display:


Engine oil level
ok


Add 1.0 Qt.
to reach max. oil level(Canada:
1.0 Liter
)


Add 1.5 Qts.
to reach max. oil level(Canada:
1.5 Liters
)


Add 2.0 Qts.
to reach max. oil level(Canada:
2.0 Liters
)

If necessary, add engine oil.
For adding engine oil, see (
page 319).
For more information on engine oil, see the
“Technical data” section (
page 482) and
(
page 485).
Other display messages
If the SmartKey or KEYLESS-GO start/stop
button* is not in position 2, the following
message will appear:
Switch ignition on
to check engine oil level
Switch on the ignition (
page 36).
If you see the message:
Observe waiting period
iIf you want to interrupt the checking
procedure, press buttonk orj
on the multifunction steering wheel.


319 Operation
Engine compartment
1Oil dipstick
2Upper (max) mark
3Lower (min) mark
To check the engine oil level with the oil
dipstick, do the following:
Open the hood (
page 315).

Pull out oil dipstick1.

Wipe oil dipstick1 clean.

Fully insert oil dipstick1 into the
dipstick guide tube.

Pull out oil dipstick1 again after
approximately 3 seconds to obtain ac-
curate reading.
The oil level is correct when it is be-
tween the lower (min) mark3 and
upper (max) mark2 of oil dipstick1.

If necessary, add engine oil.
For adding engine oil, see “Adding en-
gine oil”.
For more information on engine oil, see
“Fuels, coolants, lubricants etc.”
(
page 482).
For more information on messages in the
multifunction display concerning engine
oil, see the “Practical hints” section
(page 383).Adding engine oiliThe filling quantity between the upper
and lower marks on the oil dipstick is
approximately 2.1 US qt. (2.0 l).
!Only use approved engine oils and oil
filters required for vehicles with
Maintenance System (U.S. vehicles) or
FSS PLUS (Canada vehicles). For a
listing of approved engine oils and oil
filters, refer to the Factory Approved
Service Products pamphlet in your ve-
hicle literature portfolio, or contact an
authorized Mercedes-Benz Center.
Using engine oils and oil filters of spec-
ification other than those expressly
required for the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada
vehicles), or changing of oil and oil filter
at change intervals longer than those
called for by the Maintenance System
(U.S. vehicles) or FSS PLUS (Canada
vehicles) will result in engine damage
not covered by the Mercedes-Benz
Limited Warranty.

320 OperationEngine compartmentE350
E500

Unscrew filler cap1 from filler neck.

Add engine oil as required. Be careful
not to overfill with oil.
Be careful not to spill any oil when adding.
Avoid environmental damage caused by oil
entering the ground or water.

Screw filler cap1 back on filler neck.
For more information on engine oil, see the
“Technical data” section (
page 482) and
(
page 485).
Transmission fluid level
The transmission fluid level does not need
to be checked. If you notice transmission
fluid loss or gear shifting malfunctions,
have an authorized Mercedes-Benz Center
check the transmission.
!Excess oil must be siphoned or drained
off. It could cause damage to the
engine and catalytic converter not
covered by the Mercedes-Benz Limited
Warranty.

502 IndexEngine
Belt layout 469
Block heater* (Canada only) 356
Cleaning 364
Compartment 315
Malfunction indicator lamp 375, 400
Maximum engine speed 471
Message in the display 375, 400
Number 468, 492
Starting 50
Starting with KEYLESS-GO* 51
Tachometer 25
Technical data 470
Turning off with KEYLESS-GO* 61
Turning off with the SmartKey 61
Engine compartment
Hood 315
Engine coolant see Coolant
Engine malfunction indicator lamp 375,
400Engine oil
Adding 319
Additives 485
Changing 319
Checking level (Control system) 317
Checking level (Dipstick) 318
Consumption 316
Filler neck 320
Messages in display 317, 405
Recommended engine oils and oil
filter 485
Viscosity 492
Engine oil level 314
ESP
®
93, 492
Four wheel electronic traction system
with ESP
®
99
Messages in display 388
Warning lamp 373
ETD 492
Safety guidelines 70
Exterior rear view mirrors
Parking position 178F
Factory, SmartKey with
KEYLESS-GO* 114
Filler neck, Engine oil 320
First aid kit 419
Flat tire 440
Lowering the vehicle 450
Mounting the spare wheel 445, 447
Preparing the vehicle 440
Sealing tires with TIREFIT 440
Spare wheel 445
TIREFIT kit 440
Flexible Service System see FSS
Floormats 280
Fluids
Automatic transmission fluid 482
Brake fluid 483
Capacities 482
Engine coolant 483
Engine oil 482
Power steering fluid 483
Windshield washer and headlamp
cleaning system 484
Fog lamps 146
Messages in display 409
Replacing bulbs 433