2006 MERCEDES-BENZ E WAGON clock

425 Practical hints
Unlocking/locking in an emergency
Locking the vehicle
If you are unable to lock the vehicle with
the SmartKey or SmartKey with
KEYLESS-GO*, do the following:
Close the passenger door, the rear
doors and the tailgate.

Press the central locking switch in the
center console (
page 128).

Check to see whether the locking
knobs on the doors have moved down.

If necessary, push them down
manually.
Except for the driver’s door, the vehicle
should now be locked.1Locking

Remove the mechanical key out of the
SmartKey (
page 424).

Insert the mechanical key into the
driver’s door lock until it stops.

Turn the mechanical key clockwise to
position1.
The driver’s door is locked.
Fuel filler flap emergency release
1Release knob
Remove right-side tail trim.

Turn release knob1 clockwise (ar-
row).
The fuel filler flap can know be opened.

427 Practical hints
Opening/closing in an emergency
Opening/closing in an emergency
Power tilt/sliding sunroof*
You can open or close the tilt/sliding sun-
roof manually should an electrical malfunc-
tion occur.
The tilt/sliding sunroof drive is located be-
hind cover1 of the interior overhead
light.
1Cover
Remove the SmartKey from the starter
switch.

Press on cover1 in direction of the ar-
row to release it.2Hole
3Crank

Take crank3 out of the glove box.

Insert crank3 through hole2.

Turn crank3 clockwise to:

slide sunroof closed


raise sunroof at the rear

Turn crank3 counterclockwise to:

slide sunroof open


lower sunroof at the rear
iDo not disconnect the electrical con-
nectors.
iTurn crank3 slowly and smoothly.
The tilt/sliding sunroof must be syn-
chronized after being operated manual-
ly (
page 238).

434 Practical hintsReplacing bulbsReplacing bulbs for front lamps
1Housing cover for low beam halogen or
Bi-Xenon* headlamp2Bulb socket for high beam head-
lamp/high beam flasher bulb
3Bulb socket for parking and standing
lamp bulb
4Bulb socket for low beam headlamp
bulb (halogen headlamps only)
5Bulb socket for turn signal lamp bulb
Before you start to replace a bulb for a
front lamp, do the following first:

Turn the exterior lamp switch to
positionM (
page 143).

Open the hood (
page 315).Low beam bulb (halogen headlamps
only)

Turn housing cover1 counterclock-
wise and remove it.

Turn bulb socket4 with the bulb
counterclockwise and remove it.

Pull the bulb out of bulb socket4.

Press the new bulb gently into bulb
socket4.

Place bulb socket5 back into the
lamp and turn it clockwise until it en-
gages.

Align housing cover1 and turn it
clockwise until it engages.
Warning!
G
Do not remove the cover1 for the
Bi-Xenon* headlamp. Because of high
voltage in Bi-Xenon* lamps, it is dangerous
to replace the bulb or repair the lamp and its
components. We recommend that you have
such work done by a qualified technician.

435 Practical hints
Replacing bulbs
High beam bulb/high beam flasher
bulb (halogen headlamps)/high beam
flasher bulb (Bi-Xenon* headlamps)
Turn bulb socket2 with the bulb
counterclockwise and remove it.

Pull the bulb out of bulb socket2.

Press the new bulb gently into bulb
socket2.

Place bulb socket2 back into the
lamp and turn it clockwise until it en-
gages.Front turn signal lamp bulb

Turn bulb socket5 with the bulb
counterclockwise and remove it.

Press gently onto the bulb and turn
counterclockwise out of bulb
socket5.

Press the new bulb gently into bulb
socket5 and turn clockwise until it
engages.

Place bulb socket5 back into the
lamp and turn it clockwise until it en-
gages.
Parking and standing lamp bulb

Turn bulb socket3 with the bulb
counterclockwise and remove it.

Pull the bulb out of bulb socket3.

Press the new bulb gently into bulb
socket3.

Place bulb socket3 back into the
lamp and turn clockwise until it engag-
es.Additional turn signal lamp bulbs
The additional turn signal lamps in the
exterior rear view mirrors have LEDs.
If a malfunction occurs or LEDs fail to func-
tion, the entire turn signal unit must be re-
placed. Have the turn signal unit replaced
by an authorized Mercedes-Benz Center.
Front side marker lamp bulbs
Since replacing the side marker lamp bulbs
is a technically highly demanding process,
we recommend you have the side marker
lamp bulbs replaced by an authorized
Mercedes-Benz Center.

450 Practical hintsFlat tire
Press0 on electric air pump switch 2.

Turn the SmartKey in the starter switch
to position0.

If the tire pressure is above 51 psi
(3.5 bar), release excess tire pressure
using the vent screw.

Detach the electric air pump.

Store the electrical plug 3 and the air
hose 4 behind the flap 1 and place
the electric air pump back in the desig-nated storage space underneath the
cargo compartment floor
(
page 419).
Lowering the vehicle

Lower vehicle by turning crank coun-
terclockwise until vehicle is resting ful-
ly on its own weight.

Remove the jack.
1-5 Wheel bolts

Tighten the five wheel bolts evenly, fol-
lowing the diagonal sequence illustrat-
ed (1 to 5), until all bolts are tight.
Observe a tightening torque of 96 lb-ft
(130 Nm).Before storing the jack, it should be fully
collapsed, with handle folded in (storage
position).

Store the jack and the other vehicle
tools in the designated storage space
underneath the cargo compartment
floor (
page 419).
Warning!
G
Follow recommend inflation pressures.
Do not overinflate tires. Overinflating tires
can result in sudden deflation (blowout) be-
cause they are more likely to become punc-
tured or damaged by road debris, potholes,
etc.
Do not underinflate tires. Underinflated tires
wear unevenly, adversely affect handling
and fuel economy, and are more likely to fail
from being overheated.
Warning!
G
Have the tightening torque checked after
changing a wheel. The wheels could come
loose if they are not tightened to a torque of
96 lb-ft (130 Nm).iWrap the damaged wheel in the protec-
tive film that comes with the spare
wheel and put the wheel in the cargo
compartment.
Do not activate the tire pressure moni-
toring system* until the depressurized
tire is no longer in the vehicle.


455 Practical hints
Batteries

Reinstall the charged battery. Follow
the previously described steps in re-
verse order.
Reconnecting the battery
Turn off all electrical consumers.

Remove SmartKey from starter switch.

Connect the positive lead and fasten its
cover.

Connect the negative lead.
Batteries contain materials that can harm
the environment if disposed of improperly.
Large 12 volt storage batteries contain
lead. Recycling of batteries is the preferred
method of disposal. Many states require
sellers of batteries to accept old batteries
for recycling.
!The battery, its filler caps and the bat-
tery ventilation tube must always be se-
curely installed when the vehicle is in
operation.
!Never invert the terminal connections!
iThe following procedures must be car-
ried out following any interruption of
battery power (e.g. due to reconnec-
tion):

Set the clock (
page 170)
(see COMAND operator’s manual).


Resynchronize the ESP
®
(
page 388).


Resynchronize the side windows
(page 233).


Resynchronize the tilt/sliding sun-
roof* (
page 238).

499 Index
Center console
Lower part 28
PASS AIR BAG OFF indicator
lamp 381
Upper part 27
Centigrate see Temperature display mode
Central locking
Automatic 127, 176
Locking/unlocking from inside 128
Central locking switch 128
Certification label 468
Checking
Oil level 316
Children in the vehicle 77
Air bags 68
Blocking of rear window operation 89
Indicator lamp, front passenger front
air bag
Infant and child restraint systems 78
LATCH-type child seat anchors 88
Occupant Classification System (OCS)
Cigarette lighter 278Climate control system
4-zone automatic climate
control 214
Air conditioning refrigerant 485
Air conditioning, Cooling 212, 227
Air distribution 208, 222
Air recirculation mode 210, 224
Air volume 209, 223
Automatic mode 206, 220
Control panel, Rear 213, 229
Deactivating system 206, 219
Dual-zone automatic climate
control 202
Front defroster 209, 223
Maximum cooling MAX COOL 224
Rear climate control 229
Residual engine heat (REST) 228
Clock 25, 170
Setting time 171
Cockpit 22, 491
Cockpit Management and Data System
see COMAND
Cold tire inflation pressure 350
Collapsible tire 478
Collapsible wheel chock 423
COMAND 492COMAND see separate COMAND operat-
ing instructions
Combination switch 54, 147
Control system 155, 492
Multifunction display 155
Multifunction steering wheel 156
Resetting to factory default 166
Control system menus 158, 159
AUDIO 161
Distronic* 163
NAV* 163
Settings 165
Standard display 161
TEL* 181
Trip computer 180
Vehicle status message memory 164
Control system submenus 157
Convenience 177
Instrument cluster 168
Lighting 172
Time/Date 170
Vehicle 176
Controller Area Network see CAN system
Convenience submenu
Setting parking position for exterior
rear view mirror 178

500 IndexCoolant
Anticorrosion/antifreeze mixing ratio
and quantity 489
Capacities 483
Checking coolant level 321
Messages in display 400, 401, 402
Temperature 311
Temperature indicator 152
Warning lamp 376
Cruise control 239, 492
Message in display 386
Cup holders 274
Cleaning 367
Curb weight 350
Customer Assistance Center see CAC
D
Date display, setting 171, 172
Daytime running lamp mode 144
Setting 172, 173
Deep water see Standing water
Defogging windshield 209, 224
Defrosting, Front 209, 223
Defrosting, Rear 200
Delayed shut-off
Exterior lamps 174
Interior lighting 175Department of Transportation see DOT
Diesel see Fuel
Difficulties
While driving 58
With starting 51
Digital clock see Clock
Digital speedometer 161
Dimensions, vehicle 480
Direction of rotation (tires) 327
Displays
Digital speedometer 161
Distronic* 245
Maintenance service indicator 358
Messages in display 395
Multifunction display 155
Outside temperature 155, 169
Symbol messages 395
Text messages 385
Vehicle status message memory 165
Vehicle system settings, Control
system 155
Distance to empty (Range), Trip
computer 180Distronic* 243, 492
Activating/deactivating 248
Cleaning system sensor 366
Control system 163
Distance warning function 252
Driving hints 253
Menu 247
Messages in display 386
Sensor cover 366
Warning and indicator lamps 246
Door
Entry lamps 150
Locking/unlocking, SmartKey 34,
108
Locking/unlocking, SmartKey with
KEYLESS-GO* 35, 114
Message in display 403
Opening from inside/outside 119
Remote door unlock (Tele Aid) 289
Unlocking, Mechanical key 424
Door control panel 32
Door handle 32
DOT 351, 492
Drinking and driving 301