456 Practical hintsJump starting
If the battery is discharged, the engine can
be started with jumper cables and the bat-
tery of another vehicle. Observe the follow-
ing:
Jump starting should only be performed
when the engine and catalytic
converter are cold.
Do not start the engine if the battery is
frozen. Let the battery thaw out first.
Only jump start from batteries with the
same voltage rating (12 V). Jump start-
ing with a more powerful battery could
damage the vehicle’s electrical system,
which will not be covered by the
Mercedes-Benz Limited Warranty.
Use only jumper cables with sufficient
cross-section and insulated terminal
clamps.
Always make sure the jumper cables
are not on or near pulleys, fans or other
parts that move when the engine is
started or running.
Warning!
G
Failure to follow these directions will cause
damage to the electronic components, and
can lead to a battery explosion and severe
injury or death.
Never lean over batteries while connecting
or jump starting, you might get injured.
Battery fluid contains sulfuric acid. Do not
allow this fluid to come in contact with eyes,
skin or clothing. In case it does, immediately
flush affected area with water, and seek
medical help if necessary.
A battery will also produce hydrogen gas,
which is flammable and very explosive. Keep
flames or sparks away from battery, avoid
improper connection of jumper cables,
smoking, etc.
Attempting to jump start a frozen battery
can result in it exploding, causing personal
injury.
Read all instructions before proceeding.
!Jump starting may only be performed
on the designated jump start terminals
located in the engine compartment
(page 457).
Avoid repeated and lengthy starting at-
tempts.
Do not attempt to start the engine us-
ing a battery quick charge unit.
If the engine does not run after several
unsuccessful starting attempts, have it
checked at the nearest authorized
Mercedes-Benz Center.
Excessive unburned fuel generated by
repeated failed starting attempts may
damage the catalytic converter.
Make sure the jumper cables do not
have loose or missing insulation.
Make sure the cable clamps do not
touch any other metal part while the
other end is still attached to a battery.
498 Index
Shift program mode selector
switch 189
Shift program mode selector switch,
Manual shift program E 55
AMG 194
Starting engine 50
Steering wheel gearshift control
one-touch gearshifting E 55
AMG 191
Winter program mode 189
B
Backrest 260
Folding rearward 261
Seat 41
Seat, multicontour 133
Backup lamps
Messages in display 409
Replacing bulbs 431
Bar 350
BAS 93, 491
Batteries, SmartKey
Changing 429, 430
Checking battery condition 110, 117
Batteries, SmartKey with KEYLESS-GO*
Changing 429, 430
Checking battery condition 117Batteries, Vehicle
Charging 454
Disconnecting 453
Installing 454
Jump starting 456
Messages in display 386, 395, 396
Reconnecting 455
Removing 454
Bead 350
Beverage holder see Cup holders
Bi-Xenon headlamps* see Headlamps
Block heater* (Canada only) 356
Brake Assist System see BAS
Brake fluid
Checking 313
Messages in display 399
Brake lamp
Cleaning lenses 365
Messages in display 409
Replacing bulbs 431
Brake pads
Message in display 397
Brakes 302
Warning lamp 374
Break-in period 300
Bulbs see Replacing bulbsC
CAC 491
California retail buyers and lessees, impor-
tant notice for 11
Can holder see Cup holders
CAN system 491
Capacities and recommended
fuel/lubricants 482
Cargo compartment
Fuse box 463
Tie-down rings 264
Cargo compartment cover 270
Cargo management system* 265
Belt reel 267
Cargo tie-down ring 266
Mounting elements 265
Telescoping rod 267
Cargo net 269
Cargo tie-down rings 264
Carpets, cleaning 368
Catalytic converter 310
CD player 162
