2006 MERCEDES-BENZ CLS500 height adjustment

40 Getting startedAdjustingSeat adjustment
The seat adjustment switches are located
on the front doors.
1Seat fore and aft adjustment
2Backrest tilt
3Head restraint height
4Seat height
5Seat cushion tilt
Switch on the ignition (
page 36).
or

Open the respective door.Seat fore and aft adjustment

Press the switch forward or backward
in the direction of arrow1.
Adjust a comfortable seating position
that still allows you to reach the accel-
erator/brake pedal safely. The position
should be as far to the rear as possible,
consistent with ability to properly oper-
ate controls.Seat cushion tilt

Press the switch up or down in the
direction of arrow5 until your upper
legs are lightly supported.
Backrest tilt

Press the switch forward or backward
in the direction of arrow2 until your
arms are slightly angled when holding
the steering wheel.
Seat height

Press the switch up or down in the
direction of arrow4.
iThe memory function (
page 131) lets
you store the settings for the seat posi-
tion together with the setting for the
steering wheel and the exterior rear
view mirrors.
!When moving the seat, make sure
there are no items in the footwell or be-
hind the seats. Otherwise you could
damage the seats.

41 Getting started
Adjusting
Head restraint height
Press the switch up or down in the
direction of arrow3.Head restraint tilt
Manually adjust the angle of the head
restraint.

Push or pull on the lower edge of the
head restraint cushion.
For more information on seats, see “Seats”
(
page 124).
Steering wheel
Warning!
G
For your protection, drive only with properly
positioned head restraints.
Adjust head restraint so that it is as close to
the head as possible and the center of the
head restraint supports the back of the head
at eye level. This will reduce the potential for
injury to the head and neck in the event of
an accident or similar situation.
Do not drive the vehicle without the seat
head restraints. Head restraints are intend-
ed to help reduce injuries during an acci-
dent.
iAdjust the head restraint in such a way
that it is as close to the head as possi-
ble.
Warning!
G
Do not adjust the steering wheel while driv-
ing. Adjusting the steering wheel while driv-
ing could cause the driver to lose control of
the vehicle.
When leaving the vehicle, always remove the
SmartKey or the SmartKey with
KEYLESS-GO* from the starter switch, take
it with you, and lock your vehicle.
Even with the SmartKey removed from the
starter switch or the SmartKey with
KEYLESS-GO* removed from the vehicle,
the steering wheel adjustment feature can
be operated when the driver’s door is open.
Therefore, do not leave children unattended
in the vehicle, or with access to an unlocked
vehicle. Unsupervised use of vehicle equip-
ment may cause an accident and/or serious
personal injury.

48 Getting startedDriving
With a smooth motion, pull the belt
from belt outlet1.

Place the shoulder portion of the belt
across the top of your shoulder and the
lap portion across your hips.

Push latch plate2 into buckle4 until
it clicks.

If necessary, tighten the lap portion to
a snug fit by pulling shoulder portion
up.Belt outlet height adjustment
1Release button

Press release button1 and move the
seat belt height adjuster upward or
downward.
Proper use of seat belts


Do not twist the belt when fastening.


Adjust seat belt so that the shoulder
portion is located as close as possible
to the middle of the shoulder (it should
not touch the neck). Never pass the
shoulder portion of the belt under your
arm.


Position the lap belt as low as possible
on your hips (over hip joint) and not
across the abdomen.


Place the seat backrest in a nearly
upright position.


Never use a seat belt for more than one
person at a time.


Do not fasten a seat belt around a per-
son and another object at the same
time. When using a seat belt to secure
infant or toddler restraints or children
in booster seats, always follow the
child seat manufacturer’s instructions.


Check your seat belt periodically dur-
ing travel to make sure that it is proper-
ly positioned.


Make sure that the seat belt is always
fitted snugly. Take special care of this
when wearing loose clothing.

126 Controls in detailSeatsMulticontour seat*
The multicontour seat has a movable seat
cushion and inflatable air cushions built
into the backrest to provide additional lum-
bar and side support.
The seat cushion movement, backrest
cushion height and curvature can be con-
tinuously varied with switches on the right
side of the seat after turning the SmartKey
in the starter switch to position2 or press-
ing the KEYLESS-GO* start/stop button
twice.1Seat cushion depth
2Backrest bottom
3Backrest center
4Backrest side bolster adjustment

Switch on the ignition (
page 36).Seat cushion depth

Adjust the seat cushion depth to the
length of your upper leg using
switch1.
Backrest contour

Adjust the contour of the backrest to
the desired position using æ or
ç.

Move the backrest support to the bot-
tom by using button2 or to the center
by using button3.
Backrest side bolsters

Adjust the side bolsters so that they
provide good lateral support using
switch4.

239 Controls in detail
Driving systems

Start the engine (
page 49).

Press the damping button1 until the
desired suspension style is set.Vehicle level control
Your vehicle automatically adjusts its ride
height to


increase vehicle safety


reduce fuel consumption
The following vehicle chassis ride heights
can be selected:


Normal


Raised
The vehicle chassis ride height is raised or
lowered according to the selected level
setting and to the vehicle speed:


At a speed exceeding approximately
68 mph (110 km / h) with normal level
set or exceeding 75 mph (120 km / h)
with raised level set, the ride height is
reduced automatically. The table on
the next page provides an overview of
the vehicle levels.


With decreasing speed, the ride height
is again raised to the normal level.
Select the raised level only when required
by current driving conditions. Otherwise


handling may be impaired


fuel consumption may increase
!If you have selected the Comfort sus-
pension tuning (
page 238), the vehi-
cle lowers slightly when you lock it
within approximately 60 seconds after
switching off the engine. When parking,
make sure that your vehicle cannot
come into contact with other objects,
such as a curb, while lowering. Your ve-
hicle could otherwise be damaged.
iThe selected suspension style is stored
in memory, even after the SmartKey is
removed from the starter switch.
iThese height adjustments are so small
that you may not notice any change.Warning!
G
To help avoid personal injury, keep hands
and feet away from wheel housing area, and
stay away from under the vehicle when low-
ering the vehicle chassis.

485 Index
Front seats
Heating* 128
FSS (Canada vehicles) 339
FSS (Flexible Service System) 474
Fuel 291
Fuel reserve warning lamp 358
Premium unleaded gasoline 291
Fuel consumption statistics
After start 171
Since last reset 171
Fuel filler flap 290
Locking 290
Opening 290
Unlocking 290
Fuel requirements 466
Fuel tank
Filler flap 290
Fuels, coolants, lubricants etc. 461
Fuse box in trunk 442
Fuses 441
Fuse chart 441
Fuse extractor 441
Replacing 441
Spare fuses 441G
Garage door opener* 270
Gasoline see Fuel 291
GAWR 332
Gear range 474
Automatic transmission 181
Limiting 181
Shifting into optimal 183
Gear selector lever
Cleaning 349
Position 178
Global
Locking 101
Locking with KEYLESS-GO* 107
Unlocking 100
Unlocking with KEYLESS-GO* 107
Global Positioning System (GPS) 474
Glove box 251
Good visibility 191
GPS 474
Gross Axle Weight Rating see GAWR
Gross Vehicle Weight Rating see GVWR
Gross Vehicle Weight see GVW
GVW 332
GVWR 333H
Hands-free microphone 29
Hard plastic trim items, cleaning 349
Hazard warning flasher 140
Head restraint
Active head restraint 74, 124
Head restraints
resetting activated 407
Headlamps
Automatic headlamp mode 135
Bi-Xenon* 472
Cleaning lenses 346
Cleaning system* 191
Deactivating 59
Headliner, cleaning 350
Heated seats* 128
Height adjustment
Head restraints 41
Steering wheel 41
Vehicle level 239
High beam flasher 53, 138
High beam headlamps
Replacing bulbs 415
Switching on 53, 138
High mounted brake lamp 412

490 IndexParktronic* 475
Cleaning system sensors 347
Malfunctioning 245
Warning sounds 245
Parts service 444
Passenger compartment
Interior lighting 141
Interior rear view mirror 44
Main fuse box 442
Parcel net in the front passenger
footwell 254
Passenger safety see occupant safety 64
Pedals 279
Phone number*
Redialing 175
Plastic parts, cleaning 349
Poly-V-belt drive 475
Layout 447
Positions (Memory function*)
Recalling from memory 132
Storing into memory 132
Potential problems associated with
underinflated and overinflated
tires 321
Power assistance 280
Power outlet 259Power seat
Adjusting backrest tilt 40
Adjusting head restraint height 41
Adjusting head restraint tilt 41
Adjusting seat cushion tilt 40
Adjusting seat height 40
Memory function 131
Seat fore and aft adjustment 40
Power tilt/sliding sunroof 219
Messages in display 392
Opening/closing 219
Opening/closing in an
emergency 406
Stopping 220
Synchronizing 221
Power train 476
Power washer 343
Power windows 214
Automatic opening/automatic
closing 216
Cleaning 347
Operating 214
Rear door window, Blocking
operation 82
Side windows 214
Synchronizing 216Practical hints 352
Problems
While driving 56
With vehicle 17
Product information 9
Production options weight 333
Program mode selector switch 476
Automatic transmission 182
PSI 333
PULSE function (Massage function) 128
Push-start see Tow-start
R
Radio
Selecting satellite radio stations*
(USA only) 154
Selecting stations 153
Radio transmitters 287
Range (distance to empty) 172
Rear door window
Blocking operation 82
Rear fog lamp
Switching on 138
Rear lamp 412
Rear lamps see Tail lamps