Page 257 of 514

256 Controls in detailSoft topOpening the soft top
1Soft top, opening
Before pulling on the soft top switch, you
must make sure:
the parking brake is engaged
(page 50)
the luggage cover is latched, see
“Latch luggage cover” (
page 262)
the trunk lid is closed
the ignition is switched on (
page 36)
Pull up on the soft top switch as indi-
cated by the arrow1 until the soft top
is completely lowered into its trunk
storage compartment.
During the opening procedure the mul-
tifunction display shows the message Top in operation
.
If the opening procedure is finished,
the multifunction display will briefly
show the message Top open
.
If you continuously pull on the soft top
switch, the windows will close.
However, the windows can also be
closed/opened later on, for more informa-
tion see “Opening and closing all side win-
dows with the soft top switch”
(
page 254), or see “Opening and closing
the windows” (
page 249).
iThe soft top cannot be opened using
the soft top switch when the roll bars
have been released. The roll bars need
to be lowered before the soft top can
be operated again using the soft top
switch. If the roll bars have released
and the soft top is closed, contact an
authorized Mercedes-Benz Center to
have the roll bars lowered. Do not at-
tempt to lower the roll bars manually
with the soft top closed. Lowering the
roll bars manually with the soft top
closed may impair the function of the
roll bars (
page 423).
If the roll bars have released and the
soft top is open, you can lower the roll
bars manually (
page 424) or contact
an authorized Mercedes-Benz Center
to have the roll bars lowered.
Page 258 of 514
257 Controls in detail
Soft top
Closing the soft top
1Soft top, closing
Before pressing the soft top switch, you
must make sure:
the parking brake is engaged
(page 50)
the trunk lid is closed
the ignition is switched on (
page 36)
iFor safety reasons, the soft top cannot
be opened while driving.
Make sure the soft top is dry before you
open it. Otherwise water may enter the
trunk interior.!To prevent mildew, the soft top must be
dry before lowering it into the storage
compartment.
Do not lower a frozen soft top until
thawed and dry. Lowering a frozen soft
top may result in damage not covered
by the Mercedes-Benz Limited
Warranty.
Warning!
G
Do not place anything on the soft top com-
partment cover.
The soft top compartment cover must never
be used by any persons as a seat bench.
Raising of the roll bars could result in seri-
ous personal injury.
Page 259 of 514

258 Controls in detailSoft top
Press the soft top switch as indicated
by the arrow1 until the soft top is
completely closed and locked.
During the closing procedure the multi-
function display shows the message Top in operation
.
If the soft top is closed and locked, the
multifunction display will briefly show
the message
Top closed
.
If you continuously press on the soft
top switch the windows will close.
However, the windows can also be
closed/opened later on, for more informa-
tion see “Opening and closing all side win-
dows with the soft top switch”
(
page 254) or see “Opening and closing
the windows” (
page 249).
iFor safety reasons, the soft top cannot
be closed while driving.
iThe soft top cannot be closed using the
soft top switch when the roll bars have
been released. The roll bars need to be
lowered before the soft top can be op-
erated again using the soft top switch.
If the roll bars have released and the
soft top is open, you can lower the roll
bars manually (
page 424) or contact
an authorized Mercedes-Benz Center
to have the roll bars lowered.
Warning!
G
To prevent possible accidents, drive the ve-
hicle only with the soft top either completely
closed and locked, or fully lowered into its
storage compartment.
If the soft top does not completely open or
close, a warning sounds. In the multifunc-
tion display you will see K, and the mes-
sage
Top being lowered
appears. After
about 15 seconds the roof hydraulics lose
pressure.
Properly lock the soft top (page 259) be-
fore continuing to drive.
Page 260 of 514

259 Controls in detail
Soft top
Locking the soft top after raising/low-
ering
If the soft top is not properly locked, lock it
as described below.Unlocked status noticed when stopped
Switch on the ignition (
page 36).
To lock the soft top in its fully closed
position, press soft top switch.
The message
Top closed
will be shown
in the multifunction display.
or:
To lock the soft top in its fully opened
position, pull up on the soft top switch.
The message
Top open
will be shown in
the multifunction display.Unlocked status noticed while driving
Stop the vehicle.
Leave the ignition switched on.
To lock the soft top in its fully closed
position, press soft top switch.
The message
Top closed
will be shown
in the multifunction display.
or:
To lock the soft top in its fully opened
position, pull up on the soft top switch.
The message
Top open
will be shown in
the multifunction display.
Warning!
G
The soft top is not fully closed and locked or
not fully opened if:
the message
Top in operation
is
shown in the multifunction display
a warning sounds for 10 seconds and
the message
Lock top
is shown in the
multifunction display when starting to
drive
To prevent possible accidents, drive the ve-
hicle only with the soft top either completely
closed and locked, or fully lowered into its
storage compartment.
Warning!
G
Stop the vehicle in a safe location or as soon
as i t is s afe t o do s o and lo ck the s of t to p be -
fore continuing to drive. You could other-
wise endanger yourself and others.
Page 261 of 514

260 Controls in detailSoft top
Opening and closing the soft top with the SmartKey
The windows will also be opened or closed
when you operate the soft top with the
SmartKey.
Aim transmitter eye of the SmartKey or
SmartKey with KEYLESS-GO* at the
driver’s outside door handle. The
SmartKey or SmartKey with
KEYLESS-GO* must be in close proxim-
ity to the driver’s outside door handle.
Warning!
G
If the soft top does not completely open or
close, the roof hydraulics will lose pressure
and the soft top is lowered
after approximately seven minutes
when the ignition is switched on.
after approximately 15 seconds when
the ignition is switched off.
Shortly before the soft top is lowered, a
warning will sound. In the multifunction dis-
play you will see K, and the message
Top
being lowered
appears.
Properly lock the soft top (
page 259)
before continuing to drive.
Warning!
G
Before operating the soft top, make sure no
persons can be injured by the moving parts
(roll bar, soft top frame, and soft top com-
partment cover) due to negligence.
Hands must never be placed near the roll
bar, soft top frame, upper windshield area,
shelf behind roll bar, or soft top storage
compartment while the soft top is being
raised or lowered. Serious personal injury
may occur.
If potential danger exists, release the re-
spective button on the SmartKey. This im-
mediately interrupts the raising or lowering
procedure. You then can operate Œ to
lower or ‹to raise the soft top away
from the danger zone.
Page 262 of 514

261 Controls in detail
Soft top
Opening (Summer opening feature)
Press and hold button Œ until the
soft top is completely open.
The windows and soft top begin to
open after approximately one second.
During the opening procedure the mul-
tifunction display shows the message Top in operation
.
If the opening procedure is finished,
the multifunction display will briefly
show the message Top open
.
Release transmit button Œ to inter-
rupt procedure.
Make sure the soft top is fully opened.Closing (Convenience feature)
Press and hold button ‹until the
soft top is completely closed.
The windows and soft top begin to
close after approximately one second.
During the closing procedure the multi-
function display shows the message Top in operation
.
If the soft top is closed and locked, the
multifunction display will briefly show
the message
Top closed
.
Release transmit button ‹to inter-
rupt procedure.
Make sure all side windows and the
soft top are properly closed before leaving
the vehicle.
Warning!
G
If the soft top does not completely open or
close, a warning sounds and the soft top
switch flashes. In the multifunction display
you will see K, and the message
Top
being lowered
appears. After about
15 seconds the roof hydraulics lose pres-
sure.
Properly lock the soft top (
page 259) be-
fore continuing to drive.
Page 263 of 514
262 Controls in detailSoft topLuggage cover
The luggage cover is located in the trunk.
1Luggage cover
Open the trunk
Latch luggage cover
Pull luggage cover1 out in direction
of arrow until it engages in place.Folding back luggage cover
Press luggage cover1 in direction of
rear seat.!To prevent damage to the soft top or
luggage/cargo when lowering the roof:
load trunk only to the height of the
luggage cover
do not permit luggage/cargo to
push up the closed luggage cover
do not place anything on the shelf
behind the roll bars
do not place anything on the soft
top compartment cover
!Never place anything behind the side
nets when the luggage cover has been
folded back. You could forget about ob-
jects placed there, which could result
in damage when operating the soft top.
Page 264 of 514
263 Controls in detail
Soft top
Wind screen
The wind screen deflects drafts away from
the driver and passenger when the soft top
is lowered. It is stored in a separate stor-
age bag in the trunk.Installing
Remove the wind screen from its stor-
age bag.
1Upper section
2Lower section
Fold sections1 and2 together.3Catch
4Retainer claw
5Snap fastener
Press retainer claw4 on upper sec-
tion into snap fastener5 of lower sec-
tion.
Warning!
G
The wind screen can restrict the driver’s vi-
sion to the rear of the vehicle. To prevent a
possible accident when visibility is limited
(e.g. in darkness), the upper part of the wind
screen should be folded back.