2006 MERCEDES-BENZ C230 cooling

373 Practical hints
What to do if …
Display symbol
Display message
Possible cause/consequence
Possible solution
•
Coolant
Stop, engine off!
The poly-V-belt could be broken.

Stop the vehicle in a safe location and
immediately turn off the engine.

Check the poly-V-belt.
If it is broken:

Do not continue to drive. Otherwise the engine will
overheat due to an inoperative water pump which
may result in damage to the engine. Notify an au-
thorized Mercedes-Benz Center.
If it is intact:

Do not continue to drive the vehicle with this mes-
sage displayed. Doing so could result in serious
engine damage that is not covered by the
Mercedes-Benz Limited Warranty.

Observe the coolant temperature gauge in the in-
strument cluster (
page 24).

Drive immediately to the nearest authorized
Mercedes-Benz Center.
Coolant
Visit workshop.
The cooling fan for the coolant is
malfunctioning.

Observe the coolant temperature gauge in the in-
strument cluster (
page 24).

Have the fan replaced as soon as possible.

441 Technical data
Fuels, coolants, lubricants, etc.
Model
Capacity
Fuels, coolants, lubricants, etc.
Power steering
approx. 1.1 US qt (1.0 l)
MB Power Steering Fluid (Pentosin
CHF 11S)
Front wheel hubs
approx. 2.1oz (60g)
each
High temperature roller bearing grease
Brake system
0.5 US qt (0.5 l)
MB Brake Fluid (DOT 4+)
Cooling system
approx. 7.5 US qt (7.1 l)
MB 325.0 Anticorrosion/antifreeze
agent
Fuel tank
including
a reserve of
16.4 US gal (62.0 l)
2.1 US gal (8.0 l)
Premium unleaded gasoline:
Minimum Posted Octane 91
(Avg. of 96 RON/86 MON)
Air conditioning system
R-134a refrigerant and special PAG lubri-
cant oil (never R-12)
Windshield washer
3.2 US qt (3.0 l)
MB Windshield Washer Concentrate
1
Windshield washer and headlamp
cleaning system*
6.4 US qt (6.0 l)
1Use MB Windshield Washer Concentrate “S” and water for temperatures above freezing point or MB Windshield Washer Concentrate “S” and commercially available
premixed windshield washer solvent/antifreeze for temperatures below freezing point. Follow suggested mixing ratios (page 448).

444 Technical dataFuels, coolants, lubricants, etc.In areas where carbon deposits may be
encountered due to lack of availability of
gasolines which contain these additives,
Mercedes-Benz recommends the use of
additives approved by us for use on
Mercedes-Benz vehicles. Refer to Factory
Approved Service Products pamphlet for a
listing of approved product(s). Follow
directions on product label.
Do not blend other fuel additives with fuel.
This only results in unnecessary cost and
may be harmful to engine operation.
Damage or malfunction resulting from
poor fuel quality or from blending
additional fuel additives other than those
tested and approved by us for use on
Mercedes-Benz vehicles listed in the
Factory Approved Service Products
pamphlet are not covered by the
Mercedes-Benz Limited Warranty.
Fuel requirements
Only use premium unleaded fuel:

The octane number (posted at the
pu mp ) m ust b e 91 m i n. It is an a ve ra ge
of both the Research (R) octane num-
ber and the Motor (M) octane number:
(R+M)/2. This is also known as the
ANTI-KNOCK INDEX.
Unleaded gasoline containing oxygenates
such as ethanol, IPA, IBA and TBA can be
used provided the ratio of any one of these
oxygenates to gasoline does not
exceed 10%; MTBE must not exceed 15%.
The ratio of methanol to gasoline must not
exceed 3% plus additional cosolvents.
Using mixtures of ethanol and methanol is
not allowed. Gasohol, which contains 10%
ethanol and 90% unleaded gasoline, can
be used.
These blends must also meet all other fuel
requirements, such as resistance to spark
knock, boiling range, vapor pressure, etc.
Coolants
The engine coolant is a mixture of water
and anticorrosion/antifreeze, which
provides:

Corrosion protection


Freeze protection


Boiling protection (by increasing the
boiling point)
The cooling system was filled at the factory
with a coolant providing freeze protection
to approximately -22°F (-30°C) and
corrosion protection.
If the antifreeze mixture is effective
to -22°F (-30°C), the boiling point of the
coolant in the pressurized cooling system
is reached at approx. 266°F (130°C).

445 Technical data
Fuels, coolants, lubricants, etc.
The coolant solution must be used
year-round to provide the necessary corro-
sion protection and increase boil-over
protection. Refer to Maintenance Booklet
for replacement interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Maintenance Booklet is only applicable
if MB 325.0 anticorrosion/antifreeze
solution or other Mercedes-Benz approved
products of equal specification (see
Factory Approved Service Products
pamphlet) are used to renew the coolant
concentration or bring it back up to the
proper level.To provide important corrosion protection,
the solution must be at least 45%
anticorrosion/antifreeze [equivalent to
freeze protection to approx. -22°F
(-30°C)].
If you use a solution that is more than 55%
anticorrosion/antifreeze [freeze
protection to approx. -49°F (-45°C)], the
engine temperature will increase due to
the lower heat transfer capability of the
solution. Therefore, do not use more than
this amount of anticorrosion/antifreeze.If the coolant level is low, water and
MB 325.0 anticorrosion/antifreeze should
be used to bring it up to the proper level
(have cooling system checked for signs of
leakage). Please make sure the mixture is
in accordance with label instructions.
The water in the cooling system must meet
minimum requirements, which are usually
satisfied by normal drinking water. If you
are not sure about the water quality,
consult an authorized Mercedes-Benz
Center.

455 Index
A
ABS 25, 87, 449
Indicator lamp 350
Messages in display 360
Accelerator position,
automatic transmission* 165
Accessory weight 331
Accident
In case of 56
Active head restraints
see Head restraints
Additional turn signals 398
Air bags 63
Children 64
Front passenger front air bag off
indicator lamp 27, 80, 356
Front, Driver 67
Front, Passenger 67
Passenger 67
Safety guidelines 66
Side impact (front and rear*) 68
Window curtain 68
Air conditioning refrigerant 442Air conditioning system
Automatic climate control*
(Canada only) 186
Climate control 176
Air conditioning, Cooling
Automatic climate control*
(Canada only) 196
Climate control 183
Air distribution
Automatic climate control*
(Canada only) 190
Climate control 180
Air pressure see Tire inflation pressure
Air recirculation mode
Automatic climate control*
(Canada only) 192
Climate control 182
Air vents, Front
Automatic climate control*
(Canada only) 187
Climate control 177
Air vents, Rear
Automatic climate control*
(Canada only) 198
Climate control 185Air volume
Automatic climate control*
(Canada only) 191
Climate control 180
Alignment bolt (vehicle tool kit) 408, 449
Anticorrosion/antifreeze 446, 447
Antiglare, Rear view mirror 170
Anti-theft systems 93
Anti-theft alarm system* 93
Immobilizer 93
Tow-away alarm* 95
Aquaplaning see Hydroplaning
Armrest 258
Ashtrays 261
Aspect ratio 331
ATF (Automatic transmission fluid) 300
AUDIO menu (Control system) 136
Audio system 199
Audio and telephone, operation 199
Button and soft key operation 202
CD changer* with MP3 218
CD operation 216