399 Practical hints
Replacing bulbs
Rear lamps Notes on bulb replacement
Only use 12 volt bulbs of the same type
and with the specified watt rating.
Switch lights off before changing a bulb
to prevent short circuits.
Always use a clean lint-free cloth when
handling bulbs.
Your hands should be dry and free of oil
and grease.
If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.
Lamp
Type
7
High mounted brake
lamp
LED
8
Brake lamp
P21W
9
Turn signal lamp
PY 21 W
a
Parking and side
marker lamp
P21/5W
b
Backup lamp
P21W
c
License plate lamps
C5W
d
Rear fog lamp (driver’s
side only), tail and
standing lamp
P21/4W
Warning!
G
Bulbs and bulb sockets can be very hot.
Allow the lamp to cool down before
changing a bulb.
Keep bulbs out of reach of children.
Halogen lamps contain pressurized gas.
A bulb can explode if you
touch or move it when hot
drop the bulb
scratch the bulb
Wear eye and hand protection.
Because of high voltage in Xenon lamps, it is
dangerous to replace the bulb or repair the
lamp and its components. We recommend
that you have such work done by a qualified
technician.
402 Practical hintsReplacing bulbsBi-Xenon* headlamp
1Housing cover for Bi-Xenon headlamp
2Housing cover for high beam flasher,
parking and standing lamp3Bulb socket for turn signal lamp bulb
4Bulb socket for high beam flasher bulb
5Bulb socket for parking and standing
lamp bulbHigh beam flasher bulb
Press the clamp on housing cover2
and remove it.
Pull the electrical connector off.
Turn bulb socket4 counterclockwise
and take out the bulb.
Insert the new bulb so that its socket
locates in the recess of the lamp
housing.
Turn bulb socket4 clockwise until it
engages.
Plug the electrical connector onto the
bulb.
Align housing cover2 and press until
it engages.
Warning!
G
Do not remove the cover1 for the
Bi-Xenon headlamp. Because of high voltage
in Bi-Xenon lamps, it is dangerous to replace
the bulb or repair the lamp and its compo-
nents. We recommend that you have such
work done by a qualified technician.
418 Practical hintsTowing the vehicle
!
To be certain to avoid a possibility of
damage to the drivetrain, however, we
recommend the drive shaft be discon-
nected at the rear axle drive flange
(vehicles with 4MATIC: disconnected at
the front and rear axle drive flanges) for
any towing beyond a short tow to a
nearby garage.
Warning!
G
If circumstances require towing the vehicle
with all wheels on the ground, always tow
with a tow bar if:
the engine will not run
there is a malfunction in the power
supply or in the vehicle’s electrical
system
as that will be necessary to adequately
control the towed vehicle.
Prior to towing the vehicle with all wheels on
the ground, make sure the SmartKey is in
starter switch position2.
If the SmartKey is left in starter switch
position0 for an extended period of time, it
can no longer be turned in the switch. In this
case, the steering is locked. To unlock,
remove SmartKey from starter switch and
reinsert.
iTo signal turns while being towed with
the hazard warning flasher in use,
switch on the ignition and activate the
combination switch for the left or right
turn signal in the usual manner – only
the selected turn signal will operate.
Upon canceling the turn signal, the
hazard warning flasher will operate
again.
463 Index
J
Jack 383
Jacking up the vehicle 407
Jump starting 415
K
Key, mechanical 389
Key, SmartKey
Batteries 101
Battery check lamp 101
Changing batteries 396
Factory setting 100
Locking/unlocking 32, 100
Locking/unlocking, Global
setting 100
Locking/unlocking, Selective
setting 100
Loss of 102
Messages in display 376
Opening and closing the power
windows 243
Opening and closing the tilt/sliding
sunroof* 243
Positions in starter switch 33Remote control 98
Starting the engine 48, 49
Turning off the engine 59
Unlocking, Trunk lid 102
Valet locking 106
Kickdown 165, 451
Kilopascal 332
L
Labels 428
Certification 428
Emission control information 428
Emission control vacuum line
routing 428
Lamp sensor
Message in display 378
Lamps, exterior 398, 399
Light sensor 378
Messages in display 377, 378, 379,
380
Lamps, indicator and warning
ABS 25, 350
Battery (SmartKey) 100
Brakes 25, 351Engine diagnostics 352, 355
Engine malfunction 25, 352–353
ESP
®
25, 354
Fog lamps 118
Front passenger front air bag off 27,
68
Fuel reserve 25, 354
High beam headlamps 25
Instrument cluster 350, 355
Low beam headlamps 25
Maintenance service indicator 338
Rear fog lamp 118
Seat belt telltale 25
SRS 25, 63, 355
Turn signals 25
Language, Setting 143
LATCH-type child seat anchors see
Children in the vehicle
Leather upholstery, Cleaning and
care of 348
License plate lamps
Messages in display 378
Replacing bulbs 399
