2006 LEXUS LX470 door lock

INTERIOR EQUIPMENT
69
INTERIOR LIGHTS
Front
14X081
To turn on the interior light, slide the switch.
With the switch in the “DOOR” position, the light comes on
when any door is opened or when the ignition key is turned to
“LOCK”. After all the doors are closed, the light remains on for
about 15 seconds and then goes out.*
However, in the following cases, the light goes out
immediately:
1. All the doors are closed when the ignition key is in “ACC” or
“ON” position.
2. The ignition key is turned to “ACC” or “ON” when the light
is still on.
3. All the doors are locked when the light is still on. 4. One door is closed with the lock button pushed in while the
other doors are locked.
NOTE: * The interior lights can be set not to come on or the
duration of lighting can be changed. Ask your Lexus dealer
for details.
Rear
14X002
To turn on the interior light, slide the switch.
With the switch in the “DOOR” position, the light comes on
when the rear door or back door is opened. The light goes out
immediately when the rear door and back door are closed.

INTERIOR EQUIPMENT
71
IGNITION SWITCH LIGHT
14X004a
For easy access to the ignition switch, the ignition switch
light comes on when any of the doors are opened.
The light remains on for about 15 seconds and goes out after
all the doors are closed. However, the light goes out
immediately when all the doors are locked or the ignition key
is in the “ACC” or “ON” position.
CLOCK
14X500
The digital clock indicates the time when the ignition key
is at the “ACC” or “ON” position. To reset the hour, press
the “H” button. To reset the minutes, press the “M”
button. To adjust the time to the nearest hour, press the
“:00” button.
For example, if the “:00” button is pressed when the time is
between 9:30 − 9:59 or between 10:01 − 10:29, the time will
change to 10:00.
If the electrical power source has been disconnected from the
clock, the time display will automatically be set to 1:00.
When the headlight switch is in the first or second click stop,
you can also adjust the brightness of the display using the
instrument panel light control dial.

INTERIOR EQUIPMENT
76
GLOVE BOX
14X007a
 1Unlock 2Open 3Lock
To open the glove box door, pull the lever. To lock the
glove box door, insert the master key and turn it
clockwise.
With the tail lights on, the glove box light will come on when the
glove box door is open.
CAUTION
To reduce the chance of injury in case of an accident or
a sudden stop, always keep the glove box door closed
while driving.
GARAGE DOOR OPENER
The garage door opener ( Universal
Transceiver) is manufactured under license from
HomeLink
 and can be programmed to operate garage
doors, gates, entry doors, door locks, home lighting
systems, and security systems, etc.
(a) Programming the HomeLink
14X517
 1 Buttons 2Indicator light
The HomeLink
 in your vehicle has 3 buttons and you can
store one program for each button.
To ensure correct programming into the HomeLink
, install a
new battery in the hand −held transmitter prior to programming.

INTERIOR EQUIPMENT
79
Programming an entrance gate /
Programming all devices in the Canadian
market
1. Decide which of the 3 HomeLink buttons you want to
program.
2. Place your hand −held gate/device transmitter 25 to 75 mm
(1 to 3 in.) away from the surface of the HomeLink
.
Keep the indicator light on the HomeLink
 in view while
programming.
3. Press and hold the selected HomeLink
 button.
4. Continuously press and release (cycle) the hand−held
gate/device transmitter button every two seconds until step 5
is complete.
5. When the indicator light on the HomeLink
 changes from a
slow to a rapid flash after 20 seconds, you can release both
buttons.
6. Test the operation of the HomeLink
 by pressing the newly
programmed button. Check to see if the gate/device operates
correctly.
7. Repeat steps 1 through 6 for each remaining HomeLink

button to program another device.
Programming other devices
To program other devices such as home security systems,
home door locks or lighting, contact your authorized Lexus
dealer for assistance.
Reprogramming a button
Individual HomeLink buttons c annot be erased, however, to
reprogram a single button, follow the procedure “Programming
the HomeLink
”.
(b) Operating the HomeLink
To operate the HomeLink, press the appropriate HomeLink
button to activate the programmed device. The HomeLink
indicator light should come on. The HomeLink continues to
send the signal for up to 20 seconds as long as the button is
pressed.

EXTERIOR EQUIPMENT
94
15X004a
2. To remove the fuel tank cap, turn the cap slowly
counterclockwise, then pause slightly before removing it.
The removed cap can be stored on the back side of the fuel
filler door.
It is not unusual to hear a slight swoosh when the cap is
opened. When installing the cap, turn the cap clockwise until
you hear a click.
If the cap is not tightened securely, the malfunction indicator
lamp comes on. Make sure the cap is tightened securely.
The indicator lamp goes off after driving several times. If the
indicator lamp does not go off, contact your Lexus dealer as
soon as possible.
CAUTION
 Make sure the cap is installed securely to prevent fuel
spillage in the event of an accident.
 Use only a genuine Lexus fuel tank cap for
replacement. It is designed to regulate fuel tank
pressure.

EXTERIOR EQUIPMENT
95
MOON ROOF
15X016e
 1Open 2Close
To slide open the moon roof, push the “SLIDE” switch on
the rear side. The moon roof will open and stop partway
30 mm (1.2 in.) from the fully opened position. When you
push the switch again, the moon roof will open fully. To
stop partway, push the same switch or push the “TILT”
switch while the moon roof is moving.
As driving with the moon roof opened fully will cause wind
throbs, we recommend you to drive with the moon roof partway
30 mm (1.2 in.) from the fully opened position.
To operate the moon roof, the ignition key must be in the “ON”
position.
The sun shade can be opened or closed manually. However,
if you open the moon roof, the sun shade will be opened with
the moon roof. To close the moon roof, push the switch on the front side.
The moon roof will fully close. To stop partway, push the
same switch or “TILT” switch.
15X017e
 1
Tilt up 2Lower
To tilt up the rear end of the moon roof, push the “TILT”
switch on the “UP” side. The rear end of the moon roof will
tilt up fully. To stop partway, push the same switch or
“SLIDE” switch.
To lower it, push the switch on the opposite side of the
“UP” side. The rear end of the moon roof will fully close.
To stop partway, push the same switch or “SLIDE” switch.
Retained accessory power: Even if the ignition key is turned
to the “ACC” or “LOCK” position with all the doors closed, t\
he
moon roof can be operated until either of the front doors is
opened (or for about 45 seconds).

EXTERIOR EQUIPMENT
96
Operating the moon roof from outside the
vehicle
The moon roof can be closed or opened using a key.*
Insert the ignition key into the key hole on the driver’s
door.
To close the moon roof: Turn the key in the locking direction
and hold it.
After the door is locked, the moon roof begins to close. To stop
in the middle, return the key.
To open the moon roof: Turn the key in the unlocking
direction and hold it.
After the door is unlocked, the moon roof begins to open. To
stop in the middle, return the key.
NOTE: *This feature can be deactivated, or sliding
open/close or tilting up/down can be selected. Ask your
Lexus dealer for details.
Jam protection function
If something gets caught into the roof opening during closing
operation, the moon roof stops and is open.
If the moon roof receives a strong impact, this function may
work even if nothing is caught.
If the battery terminal is disconnected or the
battery is run down
The moon roof may not operate automatically and the jam
protection function will not operate correctly after you
reconnect, replace or recharge the battery with the moon roof
slide −opened or tilted up. In any of these cases, you should
return the moon roof to normal. To normalize the moon roof,
push and hold the “SLIDE” switch or “TILT” switch on the front
side until the moon roof is closed completely.
Make sure the moon roof opens and closes automatically. If
the moon roof cannot be operated properly, have it checked by
your Lexus dealer.

EXTERIOR EQUIPMENT
98
REAR STEP BUMPER
15X600b
The rear step bumper is for rear end protection and easier
stepup loading.
CAUTION
Do not allow more than one person to get on the rear
step bumper at a time. It is designed for only one
person.
 Never drive the vehicle with anyone on the rear step
bumper.
RUNNING BOARD LIGHTS
15x019b
Lighting the running board and the ground helps you
easily to get in and out of the vehicle in the night.
When you unlock any door with a key or wireless remote
control, the lights come on and go out after about 15 seconds
automatically.
Opening any door lights up the lights and closing it goes out
them after 15 seconds. However, if the door remains open, the
lights automatically go out after about 30 minutes.