2006 LEXUS LX470 length

DRIVING TIPS
325
Trailer towing tips
When towing a trailer, your vehicle will handle differently
than when not towing. The three main causes of
vehicletrailer accidents are driver error , excessive speed
and improper trailer loading. Keep these in mind when
towing:
 Before starting out, check the operation of the lights and all
vehicle −trailer connections. After driving a short distance,
stop and recheck the lights and connections. Practice
turning, stopping and backing with a trailer in an area away
from traffic until you learn the feel.
 Backing with a trailer is difficult and requires practice. Grip
the bottom of the steering wheel and move your hand to the
left to move the trailer to the left. Move your hand to the right
to move the trailer to the right. (This procedure is generally
opposite to that when backing without a trailer.) Also, just
turn the steering wheel a little at a time, avoiding sharp or
prolonged turning. Have someone guide you when backing
to reduce the risk of an accident.
 Because stopping distance may be increased,
vehicle− to−vehicle distance should be increased when
towing a trailer. For each 16 km/h (10 mph) of speed, allow
at least one vehicle and trailer length between you and the
vehicle ahead. Avoid sudden braking as you may skid,
resulting in jackknifing and loss of control. This is especially
true on wet or slippery surfaces.
 Avoid jerky starts or sudden acceleration. 
Avoid jerky steering and sharp turns. The trailer could hit
your vehicle in a tight turn. Slow down before making a turn
to avoid the need of sudden braking.
 Remember that when making a turn, the trailer wheels will
be closer than the vehicle wheels to the inside of the turn.
Therefore, compensate for this by making a larger than
normal turning radius with your vehicle.
 Crosswinds and rough roads will adversely affect handling
of your vehicle and trailer, causing sway. Pay attention to
the rear from time to time to prepare yourself for being
passed by large trucks or buses, which may cause your
vehicle and trailer to sway. If swaying happens, firmly grip
the steering wheel and reduce speed immediately but
gradually. Never increase speed. If it is necessary to
reduce speed, brake slowly. Steer straight ahead. If you
make no extreme correction with the steering or brakes,
your vehicle and trailer will stabilize.
 Be careful when passing other vehicles. Passing requires
considerable distance. After passing a vehicle, do not
forget the length of your trailer and be sure you have plenty
of room before changing lanes.
 In order to maintain efficient engine braking and electrical
charging performance, do not use overdrive. T ransmission
must be “4” position.

DRIVING TIPS
327
HOW TO SAVE FUEL AND MAKEYOUR VEHICLE LAST LONGER
Improving fuel economy is easy − just take it easy. It will help
make your vehicle last longer, too. Here are some specific tips
on how to save money on both fuel and repairs:
 Keep your tires inflated at the correct pressure. Check
the pressure every two weeks, or at least once a month.
Underinflation causes tire wear and wastes fuel.
 Do not carry unneeded weight in your vehicle. Excess
weight puts a heavier load on the engine, causing greater
fuel consumption.
 Avoid lengthy warmup idling. Once the engine is
running smoothly, begin driving − but gently. Remember,
however, that on cold winter days this may take a little
longer.
 Accelerate slowly and smoothly. Avoid jackrabbit starts.
 Avoid long engine idling. If you have a long wait and you
are not in traffic, it is better to turn off the engine and start
again later.
 Avoid engine overrevving. Use a gear position suitable
for the road on which you are traveling. 
Avoid continuous speeding up and slowing down.
Stop−and−go driving wastes fuel.
 Avoid unnecessary stopping and braking. Maintain a
steady pace. Try to time the traf fic signals so you only need
to stop as little as possible or take advantage of through
streets to avoid traffic lights. Keep a proper distance from
other vehicles to avoid sudden braking. This will also
reduce wear on your brakes.
 Avoid heavy traffic or traffic jams whenever possible.
 Do not rest your foot on the brake pedal. This causes
premature wear, overheating and poor fuel economy.
 Maintain a moderate speed on highways. The faster you
drive, the greater the fuel consumption. By reducing your
speed, you will cut down on fuel consumption.
 Keep the front wheels in proper alignment. Avoid hitting
the curb and slow down on rough roads. Improper
alignment not only causes faster tire wear but also puts an
extra load on the engine, which, in turn, wastes fuel.
 Keep the bottom of your vehicle free from mud, etc.
This not only lessens weight but also helps prevent
corrosion.

IN CASE OF AN EMERGENCY
380Tips for entering a phone number using the dial and store
commands:

Say the entire 7 −, 10− or 11−digit number and wait for the
system to respond. You do not need to say “Dial”, “Store”,
or “Verify” after the phone number.
 If you want to enter a number that is not 7 −, 10− or 11 −digit,
use the digit dial or digit store commands.
 Do not pause between the digits. If there is a long pause
between digits, the system may think that you have finished
saying the entire number.
 The system does not recognize the words “Hundred” or
“Thousand”. Instead, you must say each digit. For
example, a number starting with “1 −800 ..” is pronounced
“one−eight−zero−zero...”.
 The system often works better when the digits are combined
smoothly into a single phrase. Try saying the entire phone
number more rapidly.
 If problems continue when saying the entire phone number,
try using the digit dial or digit store commands to enter one
digit at a time.
Say each one of the syllables in the word clearly. Do not omit
any of the syllables.
Be sure to articulate each sound in the word. The voice
recognition system can have trouble recognizing a
word when
final consonants are not pronounced. It may be helpful to
emphasize the final consonant.
If the system is confusing 2 commands that are similar (e.g.
“Dial” and “Redial”), be sure to pronounce the distinction.\
In
this example, “Redial” may be recognized better if the first
syllable is emphasized and slightly lengthened.
Avoid clipping short words and syllables. Instead, try
lengthening the short words and syllables, and slow down your
overall speech rate a little. You can also try lengthening
different syllables of the word.
Try speaking louder. When there is a lot of background noise,
the system has more trouble hearing your speech. If, however,
you find that you are speaking so loud that you are stressing
your voice, speaking somewhat quieter but with clear
pronunciation may help.

BODY
463
SPECIFICATIONS
– DIMENSIONS AND WEIGHTSOverall length
4890 mm (192.5 in.)
Overall width1940 mm (76.4 in.)
Overall height1850 mm (72.8 in.)*
Wheelbase2850 mm (112.2 in.)
Tread – Front – Rear1620 mm (63.8 in.)
1615 mm (63.6 in.)
Vehicle capacity weight (occupants + cargo)545 kg (1200 lb.)
Towing capacity (trailer weight + cargo weight)2948 kg (6500 lb.)
*: Unladen vehicle
– FUEL TANK
Capacity
96 L (25.4 gal., 21.1 lmp.gal.)