2006 LEXUS LS430 display

109
2-2. Instrument cluster
2
When driving
Graphic information
Following graphic information is shown on the display
• Outside temperature display ( P.216 )
• Compass display (if equipped P.238 )
• Dynamic radar/ laser cruise control display (if equipped P.129 )
Appears when activate the system
• Lexus park assist system display (if equipped P.118 )
Appears when the system is activated
• Door ajar (with warning message P.334 )
Appears when any door is opened with the ignition s
witch is ON
position
Each time you push and hold for 1 or 2 seconds, the graphic informa-
tion changes in the following order
Compass display**
Outside temperature display Dynamic radar/
laser cruise control display**
Blank screen
**Skipped if not equipped or not activated
■Wa r n i n g m e s s a g e s
If any problem (malfunction) arises, a warning message appears on the
multi-information display. (
P. 334 )

118
2-4. Using other driving systems
Lexus park assist system
Indicators and beeps
The Lexus park assist system indicates the distance to the obstacle
according to the following chart.
Front or rear sensor
Distance to
the obstacle1. About 3.0 ft. (1 m) to about
1.5 ft. (50 cm)2. About 1.5 ft. (50 cm) to about 1.1 ft. (37.5 cm)3. About 1.1 ft.
(50 cm) to
about 0.8 ft. (25 cm)4. Less than
about 0.8 ft.
(25 cm)
Indicator bars
Flashes
BeepsFront: None
Rear: SlowMediumFastTo n e
The Lexus park assist system detects the nearby objects and their approxi-
mate distance from your vehicle, and guides you using a screen display and
al

arms when driving your vehicle at parking speeds
Turn the system on
A beep sounds and a graphic
image appears on the multi-
information display

.
Push the button once more to turn
off the system.1
1

121
2-4. Using other driving systems
2
When driving
■Objects which may not be detected
●Wires or ropes.
●Objects with a surface area too small to reflect ultrasonic waves such as a
chain-link fence.
●Sound wave absorbing objects such as cotton or snow.
●Objects with a sharp edge.
●Shorter objects.
●Tall objects with the upper part projected.
■Operating condition
The ignition switch must b
e turned to ON.
■Park assist graphics (vehicles equippe d with the Navigation system) System
The park assist graphics also appear on the n
avigation display. For details, see the
separate “Navigation System Owner’s Manual”.
■Certification for the Lexus park assist system (Canada)
This ISM device complies with Canadian ICES-001.
■Failure warnings
If a system error is detected, the master warning light comes on, 5 beeps sound, the
fo
llowing warning message appears, and gr aphic information indicates the faulty
sensor. ( P.334 )
■Customization
The volume of the beeps can be changed. ( P. 3 8 4 )

123
2-4. Using other driving systems
2
When driving
Rear view monitor system
■Displayed area
The rear view monitor system assists the driver by displaying an image of the
area behind the vehicle. The displayed image is a horizontally reversed mirror
image of the inside rear view mirror.
Rear view image is displayed when
the selector lever is in the “R” posi -
tion.
If you move the lever out of “R”
position, the screen returns to the
previous one.
The area covered by the camera is limited.
Objects which are close to either corner
of the bumper or under the bumper can-
not be seen on the screen.
The area displayed on the screen may vary
according to vehicle orientation or road
conditions.
Corner of bumper
1

125
2-4. Using other driving systems
2
When driving
CAUTION
■When using the rear view monitor system, observe these precautions to avoid an
accident that could result in death or serious injuries.
●Never depend solely on the monitor system when reversing.
●Always check visually and with the mirrors to confirm your intended path is clear.
●Depicted distances between objects and flat surfaces differ from actual dis-
tances.
●Do not use the system if the trunk is open.
■Conditions which may affect the rear view monitor system
●If the back of the vehicle is hit, the camera’s position and mounting angle may
change. See your Lexus dealer.
●Rapid temperature changes, such as when hot water is poured on the vehicle in
cold weather, may cause the system to function abnormally.
●If the camera lens is dirty, it cannot transmit a clear image. Rinse with water and
wipe with a soft cloth. If extremely dirty, wash with a mild cleanser and rinse.
●The displayed image may be darker and mo ving images may be slightly distorted
when the system is cold.

130
2-4. Using other driving systems
■Adjusting the speed setting
Increasing
Decreasing
Hold the lever until the desired
speed setting is obtained.
■Canceling and resuming the speed setting
Cancel
The preset speed is also canceled if
the brake pedal is pressed.
Resume
The system will not resume opera-
tion if the vehicle speed is less than
40 km/h (25 mph).
■ Changing the vehicle-to-vehicle distance
The setting changes each time the
button is pushed.
Long
Middle
Short
“Long” mode is selected each time
the ignition is switched ON.
A vehicle is displayed ahead if one is
detected
.
1
2
1
2
1
2
3

133
2-4. Using other driving systems
2
When driving
■Vehicle-to-vehicle distances
Select a vehicle-to-vehicle distance appropriate
to traffic conditions. The approxi-
mate vehicle-to-vehicle distance based on time interval when driving at 55 mph
(88 km/h) is sho

wn below:
If the vehicle speed is slower than 55 mph (88 km/h), the distance will be shorter
than ab
ove.
■Millimeter wave radar lase r sensor/ Laser radar sensor
The radar or laser sensor automatically detects dirt on the sensor or grill cover
(r
adar cruise control), or the sensor glass (laser cruise control). If dirt is detected, a
message is displayed on the multi-informatio n display, and the radar or laser cruise
control function is automatically cancelled.
ModeVehicle-to-vehicle distance
Long245 f t. (approx. 75 m)
Middle164 ft. (approx. 50 m)
Short100 ft. (approx. 30 m)
Vehicles with dynamic radar cruise con-
trol 
(Standard for vehicles with the Pre-Col-
lision system)
Grill cover
Sensor
Vehicles with dynamic laser cruise con-
trol
Sensor

134
2-4. Using other driving systems
■Certifications for the millimeter wave radar laser sensor/ laser radar sensor
(U.S.A.)
●Millimeter wave radar sensor
FCC WARNING: 
Changes or modifications not expressly approved by the party responsible for
com
pliance could void the user’s authority to operate the equipment. 
FCC RF exposure information: 
This device complies with the FCC RF exposure requirements.
●Laser radar sensor 
This product is a class I laser product complied with 21 C.F.R part 1040.10 and
10
40.11.
■Certifications for the millimeter wave radar laser sensor/ laser radar sensor
(Canada)
Millimeter wave radar sensor 
Operation is subject to the following two conditions;
1. this device may not c
ause interference, and
2. this device must accept any interference r
eceived, including interference that
may cause undesired operation of the device.
■If the master warning light comes on and a warning message appears on the
multi-information display
If a system malfunction occurs when the dyn
amic radar/laser cruise control is on or
in the “RADAR READY” mode, the master warning light comes on, the “CRUISE”
indicator light flashes, a warning tone so unds, and “Check Cruise System” is dis-
played. ( P.334 )