2006 Lexus GS430 air filter

cm2
Maintenance procedures for the engine, chassis,
body, electrical system, and more, are clearly
explained and illustrated.
Periodic maintenance and tuneup
Periodic maintenance and tuneup helps to prevent small
problems from growing into larger ones later on. The repair
manual outlines exactly what maintenance is required and
clearly explains how to do the work yourself stepbystep.
Areas covered include such things as spark plug replacement,
valve clearance adjustment and engine oil and filter
replacement.
Where to obtain the Repair Manual
The repair manual for GS430, GS300 may be purchased from
any Lexus dealer or call the Material Distribution Center. To
purchase the repair manual, please contact your Lexus dealer
or the Material Distribution Center tollfree at
18006222033.

AIR CONDITIONING
259
1 Driver side temperature display (in degrees
Fahrenheit or Centigrade)
2 Passenger side temperature display (in degrees
Fahrenheit or Centigrade)
3 “DUAL” (temperature setting mode change) switch
4 “A/C” switch
5 Air flow control switches
6 Fan speed control switches
7 Air conditioning operation screen display button
8 “TEMP” (driver side temperature control) buttons
(At the independent mode that display shows
“DUAL”; mainly for driver and secondarily for front
passenger)
(At the linked mode that display does not show
“DUAL”; for driver)
9 “OFF” button
10 “AUTO” button
11 Micro dust and pollen filter button
12 Windshield air flow button
13 Air intake control button
14 “PASSENGER TEMP” (passenger side temperature
control) buttons
(Only for the independent mode that display shows
“DUAL”; mainly for front passenger and
secondarily for driver)
The automatic air conditioning automatically maintains
the set temperature.
In the automatic operation mode, the air conditioning selects
the most suitable fan speed, air flow, air intake and on −off of
the air conditioning according to the temperature.
The engine switch must be selected in “IG −ON” mode.
“CLIMATE”: Push this button to display switches for
automatic air conditioning control.
NOTICE
To prevent the battery from being discharged, do not
leave the air conditioning on longer than necessary
when the engine is not running.

AIR CONDITIONING
269
When the windshield air flow button is pushed while operating
in automatic mode, the air conditioning is set to operate and the
OUTSIDE AIR mode is set. This is to clean up the front view
more quickly. If you want
to return the setting to the
RECIRCULATED AIR mode, push the air intake control button
once again.
Touch the “A/C” switch for dehumidified heating or cooling.
This setting clears the front view more quickly.
If you push the windshield air flow button once again while in
the windshield air flow mode, the mode then returns to the last
mode used.
CAUTION
Do not use the windshield air flow button during cooled
air operation in extremely humid weather. The
difference between the temperature of the outside air
and that of the windshield could cause the outer surface
of the windshield to fog up blocking your vision.
(c) Micro dust and pollen filter
This vehicle is equipped with a micro dust and pollen filter
mode. When this mode is activated, air from the vents will
remove pollen on the driver and passengers.
Use this mode to remove pollen quickly carried by the
driver or passengers or through the window in the days
with much pollen.
G21073
Push the micro dust and pollen filter button.
The indicator light comes on and RECIRCULATED AIR mode
is turned on. Air is delivered from the instrument panel vents
to the areas near the driver and passengers to remove pollen
on them. When the interior is purified sufficiently with fresh air
after about 3 minutes, this mode will be turned off automatically
and the indicator light will go out.

AIR CONDITIONING
270However, when the outside temperature is low, the indicator
light
comes on and the “A/C” switch turns on, but the air intake
control remains the same. When the interior is purified
sufficiently with fresh air after about 1 minute, this mode will be
turned off automatically and the indicator light will go out, but
the “A/C” switch remains on.
When the micro dust and pollen filter is activated, this mode will
be turned off by pushing any of the following buttons:
 Micro dust and pollen filter button
 “A/C” button
 Windshield air flow button
The indicator light will go out when the mode is turned off.
INFORMATION
 Use and push the windshield air flow button to
remove the fog on the windshield in rainy days.
 Fresh air is delivered even when the micro dust and
pollen filter button is turned off.
(d) Operating tips
To help cool down the interior after parking in the hot sun,
drive for the first few minutes with the windows open. After
the excess heat has blown away, close the windows.
 Make sure the air inlet grilles in front of the windshield are
not blocked by leaves or other obstructions.
 If air flow control is not satisfactory, check the dashboard
vents and rear vents. (See (e) “Center vents, side vents and
rear vents”.)
 Only humid days, do not blow cold air on the windshield.
The windshield could fog up because of the difference in air
temperature on the inside and outside of the windshield.
 Keep the area under the front seats clear to allow air to
circulate throughout the vehicle.
 On cold days, set the fan speed to high for a minute to help
clear the intake ducts of snow or moisture. This can reduce
the amount of fogging on the windows.
 When driving on dusty roads, close all windows. If dust
thrown up by the vehicle is still drawn into the vehicle after
closing the windows, it is recommended that the air intake
control button be set to the OUTSIDE AIR mode to take in
the fresh air and the fan speed selector to any setting except
OFF.

AIR CONDITIONING
275
(f) Replacing the air conditioning filter
G21011
The air conditioning filter information label is placed in the
glove box as shown and indicates that a filter has been
installed.
The air conditioning filter, in addition to removing odors,
prevents dust and pollen from entering the vehicle through the
air conditioning vent.
G21012
The air conditioning filter is behind the glove box.
The air conditioning filter may clog after long use. The filter
may need to be replaced if the air flow of the air conditioning
and heater experiences extreme reductions in operating
efficiency, or if the windows fog up easily.
If the symptoms of air conditioning efficiency problems occur,
contact your nearest Lexus dealer to have the filter cleaned or
replaced.
To maintain the air conditioning efficiency, replace the air
conditioning filter according to the maintenance schedule. In
dusty areas or areas with heavy traffic flow, such as inner city
or desert areas, early replacement may be required. (For
scheduled maintenance information, see the “Owner’s Manual
Supplement / Scheduled Maintenance”).

AIR CONDITIONING
2761. Turn the air intake control to RECIRCULATED AIR
mode.
The filter case cannot be removed in the OUTSIDE AIR mode.
2. Turn off the engine switch.
3. When you replace the filter, be sure to turn off the fan.
G21013
4. Open
the glove box and remove the partition by pulling.
G21019
5. Pull the filter cover toward you.
G21020
6. Push the tabs and pull the filter case toward you.

AIR CONDITIONING
277
G21021
7. Take out the filter.
G21022
8. Remove the filter from the filter case.9. Inspect the filter on the surface.
If it is dirty, it should be replaced.
NOTICE
When setting the filter to the filter case, the UP marks
shown on the filter and filter case should be noted and
fitted as shown.
INFORMATION
The air conditioning filter should be installed properly
in position. The use of air conditioning with the filter
removed may cause deteriorated dustproof perfor-
mance and then affect air conditioning performance.

ELECTRICAL COMPONENTS
579
No.FUSEAMPERECIRCUIT
47 ABS
MAIN110Capacitor
48 E/GB60“FR CTRL BATT”, “ETCS” and
“ALT−S”
49 ABS150Vehicle stability control system,
“ABS MAIN1”, “ABS MAIN2”
and “ABS MTR”
50 RH J/BB30“AM2”, “DOOR FR” and “DOOR
RR”
51 VGRS40Variable gear ratio steering
system
52 MAIN30“H− LP R LWR” and “H −LP L
LWR”
53 STARTER30Starting system
54 LH J/BB30“FL DOOR”, “RL DOOR” and
“RAD No.3”
55 P/IB60Multi− port fuel injection
system/sequential multiport fuel
injection system
56 EPS80Electronic power steering
system
57 ALT150
“RH J/B− AM”, “LH J/B −AM”,
“E/G− AM”, “RR JB”, “HEATER”,
“DEFOG”, “FAN1”, “FAN2”,
“ABS2”, “ABS MOTOR”, “ABS
MAIN1”, and “ABS MAIN2”
No.FUSEAMPERECIRCUIT
58 RR J/B80
“STOP LP R”, “STOP LP L”,
“RR− B”, “RR TAIL”, “RR FOG”,
“RR− IG1”, “PSB”, and “RR
S/SHADE”
59 GLW PLG150Glow plug heater
60 RH J/BAM80
“AM1”, “OBD”, “STOP SW”, “TI
&TE”, “PWR OUTLET”, “FR
P/SEAT RH”, “STR LOCK”,
“ECU− IG RH”, “RH− IG”, “ACC”,
“CIG”, “SECURITY”, “FR
S/HTR RH”, and “AIR SUS”
61 ABS230Vehicle stability control system,
Anti− lock brake system
62 DEFOG50Rear window defogger, Noise
filter
63 FAN140Electric cooling fans
64 HEATER50Air conditioning system
65 GLW PLG250Glow plug heater
66 E/GAM60“H−LMP CLN”, “FR CTRL −AM”
and “A/C COMP”
67 LH J/
BAM80
“S/ROOF”, “FR P/SEAT LH”,
“TV”, “FR S/HTR LH”, “ECU− IG
LH”, “FR WIP”, “H −LP LVL”,
“LH− IG”, “FUEL OPEN”, “A/C”,
“PANEL”, and “LH− B”
68 FAN260No circuit
69 FR
CTRLB25“H− LP UPR” and “HORN”