2006 Lexus GS430 brake light

00/06/06
Warning Display
If there is trouble somewhere in the dynamic radar cruise control while th\
e vehicle −to− vehicle distance control mode is on, the “CRUISE”
indicator light in the instrument cluster flashes, the master warning light comes \
on and the warning tone sounds, and one or mo re of the
warning messages will appear on the multi −information display.
If a warning message appears on the display, take the appropriate measure referring to Section 3 −1, “Owner’s Manual”.
 Approach Warning
Dynamic radar cruise control and approach warning do not operate when the vehicl\
e ahead is at a stop
or is driving much slower than your vehicle. Use caution for the vehicle at the end of the line in heavy
traffic or at the tollgate, the vehicle at a stop and the very slow vehicle.
If your vehicle approaches the vehicle ahead because of insufficient braking when the vehicle ahead deceler-
ates abruptly or when another vehicle cuts in ahead of you, the multi −information display flashes and beeps.
Depress the brake pedal to slow down, ensuring sufficient vehicle −to− vehicle distance.
Warning message
“CLEAN RADAR SENSOR”
 “CRUISE NOT AVAILABLE”
 “CHECK CRUISE SYSTEM”
If any warning message shown above appears, the preset
speed automatically cancels out.
Master Warning
Light
Warning
Message
”CRUISE” Indicator
Light
5

Depress the accelerator or brake pedal to attain the desired speed.
 Press the control lever downward in the “– SET” direction and r\
elease it.
This sets the vehicle at that speed.
If a vehicle is detected ahead of you: Your cruising speed changes in proportion to the speed
of the vehicle ahead to maintain an appropriate distance from your vehic\
le to the vehicle ahead.
If there was no vehicle ahead, your cruising speed will be gradually inc\
reased up to the preset speed.
If no vehicle is detected ahead of you: Your cruising speed is
maintained at the preset speed.
 Cancelling
To stop the operation: Push the “ON −OFF” button to turn off.
To stop the operation temporarily:
Pull the control lever in the “CANCEL” direction.
To resume follow −up cruising or cruising at fixed speed,
press the control lever upward and release it.
00/06/06
 Operation Procedure
The operation procedure is shown as follows. For the detailed information,\
see Section 3− 1 in the “Owner’s Manual”.
 Setting
 Push the “ON−OFF” button to turn on the system. The “CRUISE” indicator light in the instrument cluster co\
mes on and “RADAR
READY” appears on the multi −information display.
See Owner’s Manual for Complete Information.
6