2006 Lexus GS300 gs300

STARTING AND DRIVING
340
THREE−WAY CATALYTIC
CONVERTERS
G31042

GS430
G31043

GS300Three−way catalytic converters are emission control
devices installed in the exhaust system.
The purpose is to reduce pollutants in the exhaust gas.
CAUTION
Keep people and combustible materials away from
the exhaust pipe while the engine is running. The
exhaust gas is very hot.
Do not drive, idle or park your vehicle over anything
that might burn easily such as grass, leaves, paper or
rags.
NOTICE
A large amount of unburned gases flowing into the
three−way catalytic converter may cause it to overheat
and create a fire hazard. To prevent this and other
damage, observe the following precautions:
Use only unleaded gasoline.
Do not drive with an extremely low fuel level; running
out of fuel could cause the engine to misfire, creating
an excessive load on the three−way catalytic
converter.
Do not allow the engine to run at idle speed for more
than 20 minutes.

STARTING AND DRIVING
358“4” (fourth range): The most suitable gear is automatically
selected between first and fourth gears according to vehicle
speed and driving conditions. In the “4” (fourth range)
position, the automatic transmission system will select the
most suitable gear to handle current running conditions
such as hill climbing, hard towing, etc.
“3” (third range): The most suitable gear is automatically
selected between first and third gears according to vehicle
speed and driving conditions. This range is best used when
stronger engine braking is necessary.
“2” (second range): First or second gear will automatically
be selected according to vehicle speed and driving
conditions. This range is to be used when engine braking
stronger than that of the “3” (third range) position is
necessary.
“1” (first range): This gear is fixed in first regardless of
vehicle speed or driving conditions. This range is to be used
when maximum engine braking is necessary.
If you attempt to downshift the transmission when it is not
possible to downshift due to high vehicle speed, a warning tone
sounds twice.Maximum allowable speeds
To get on a highway or to pass slower traffic, maximum
acceleration may be necessary. Make sure you observe the
following maximum allowable speeds in each range:
range km/h (mph)
GS430:1 57 (35)
2 97 (60)
3 141 (88)
range km/h (mph)
GS300 (2WD):1 54 (33)
2 93 (58)
3 137 (85)
range km/h (mph)
GS300 (4WD):1 52 (32)
2 90 (56)
3 131 (81)
NOTICE
Do not downshift if you are going faster than the
maximum allowable speed for the next lower range.

STARTING AND DRIVING
360When the cruise control is being used, even if you downshift
from “D” or “6” (sixth range) to “5” (fifth range), engine
braking will not be enabled because the cruise control is not
cancelled. For vehicle speed reduction, see page 394.
Vehicles with the dynamic radar cruise control —
When the cruise control is being used in the conventional
(fixed speed) cruise control mode or in the
vehicle−to−vehicle distance control mode, even if you
downshift from “D” or “6” (sixth range) to “5” (fifth range),
engine braking will not be enabled because the cruise
control is not cancelled. For vehicle speed reduction, see
pages 416 and 404.
Shift into the “4” (fourth range) position. The transmission
will downshift to fourth gear when the vehicle speed is or
becomes lower than the speed listed below and more
powerful engine braking will be enabled.
GS430193 km/h (120 mph)
GS300 (2WD)187 km/h (116 mph)
GS300 (4WD)178 km/h (111 mph)
If you drive in the “D” position: Shift the selector lever to
the “S” position and shift the lever down to the “–” position
once to select “4” (fourth range). However, when you move
the lever to the “S” position while the AI shifting control is
operating, the first shift range will be “5” (fifth range), “4”
(fourth range) or “3” (third range) because the suitable shift
range is selected depending on the driving condition.
If you drive in the “S” position: Shift the selector lever
down to the “–” position to select the “4” (fourth range).When the cruise control is being used, even if you downshift
from “D” or “5” (fifth range) to “4” (fourth range), engine
braking will not be enabled because the cruise control is not
cancelled. For vehicle speed reduction, see page 394.
Vehicles with the dynamic radar cruise control —
When the cruise control is being used in the conventional
(fixed speed) cruise control mode or in the
vehicle−to−vehicle distance control mode, even if you
downshift from “D” or “5” (fifth range) to “4” (fourth range),
engine braking will not be enabled because the cruise
control is not cancelled. For vehicle speed reduction, see
pages 416 and 404.
Shift into the “3” (third range) position. The transmission will
downshift to third gear when the vehicle speed is or
becomes lower than the speed listed below and more
powerful engine braking will be enabled.
GS430144 km/h (90 mph)
GS300 (2WD)135 km/h (84 mph)
GS300 (4WD)129 km/h (80 mph)
If you drive in the “D” position: Shift the selector lever to
the “S” position and shift the lever down to the “–” position
twice to select the “3” (third range). However, when you
move the lever to the “S” position while the AI shifting control
is operating, the first shift range will be “5” (fifth range), “4”
(fourth range) or “3” (third range) because the suitable shift
range is selected depending on the driving condition.
If you drive in the “S” position: Shift the selector lever
down to the “–” position to select “3” (third range).

STARTING AND DRIVING
361 Shift into the “2” (second range) position. The transmission
will downshift to second gear when the vehicle speed is or
becomes lower than the speed listed below and more
powerful engine braking than that of the “3” (third range)
position will be enabled.
GS43099 km/h (62 mph)
GS300 (2WD)93 km/h (58 mph)
GS300 (4WD)89 km/h (55 mph)
If you drive in the “D” position: Shift the selector lever to
the “S” position and shift the lever down to the “–” position
three times to select “2” (second range).
If you drive in the “S” position: Shift the selector lever
down to the “–” position to select “2” (second range).
Shift into the “1” (first range) position. The transmission will
downshift to first gear when the vehicle speed is or becomes
lower than the speed listed below and maximum engine
braking will be enabled.
GS43037 km/h (23 mph)
GS300 (2WD)38 km/h (23 mph)
GS300 (4WD)36 km/h (22 mph)
If you drive in the “D” position: Shift the selector lever to
the “S” position and shift the lever down to the “–” position
four times to select “1” (first range).
If you drive in the “S” position: Shift the selector lever
down to the “–” position to select “1” (first range).
CAUTION
Be careful when downshifting on a slippery surface.
The abrupt change in engine speed could cause the
vehicle to skid or spin.

STARTING AND DRIVING
419 GS300—The slip indicator light comes on for a few seconds
when the engine switch is selected in “IG−ON” mode.
If the indicator light does not come on when the engine switch
is selected in “IG−ON” mode, contact your Lexus dealer.
Traction control off mode
(two−wheel drive models only)
G31008
If your wheels get stuck in a ditch when you are driving on
a severe off road and sand, turn off the traction control
system. This system that controls engine performance
interferes with the process of freeing your wheels.
To turn off: Push “TRAC OFF” switch.
The slip indicator light will come on.
The vehicle stability control system is always activated even if
the traction control system is turned off.GS430 only—When the vehicle speed exceeds about 50 km/h
(30 mph) even if the traction control system is turned off, the
system turns on automatically.
To turn on: Push “TRAC OFF” switch once again.
The slip indicator light will go off.
In the following cases, contact your Lexus dealer:
The slip indicator light does not come on when the engine
switch is selected in “IG−ON” mode.
The slip indicator light remains on after the engine is started
(GS430), or remains on after the engine switch is selected
in “IG−ON” mode (GS300).
The slip indicator light comes on in the normal driving mode
while driving.

STARTING AND DRIVING
420
Traction control system failure warning
G31039

1
GS430 2
GS300
If the traction control system malfunctions, the slip
indicator light (two−wheel drive models only) and brake
system warning light (yellow) come on. At this time, the
above message appears. (GS430 only—In some cases,
the multi−information display shows either “CHECK VSC”
or “CHECK ECB” only.)
If the message appears, the traction control system, vehicle
stability control system and hill−start assist control system do
not work. Although it is no problem to continue driving, have
your vehicle checked by your Lexus dealer as soon as
possible.
VEHICLE STABILITY CONTROL
SYSTEM
The vehicle stability control system helps provide
comprehensive control of the systems such as anti−lock
brake system, traction control, engine control, etc. This
system automatically controls the brakes and engine to
help prevent the vehicle from skidding when cornering on
a slippery road surface or operating steering wheel
abruptly.
This system activates when the vehicle speed is about more
than 15 km/h (9 mph).
You may hear a sound in the engine compartment for a few
seconds just after the vehicle begins to move. This means that
the system is in the self−check mode, but does not indicate a
malfunction.

STARTING AND DRIVING
421
CAUTION
Do not rely excessively on the vehicle stability
control system. Even if the vehicle stability control
system is operating, you must always drive carefully
and attentively to avoid serious injury. Reckless
driving will result in an accident. If the slip indicator
light blinks, sounding an alarm, special care should
be taken while driving.
Only use tires of specified size. The size,
manufacturer, brand and tread pattern for all 4 tires
should be the same. If you use the tires other than
specified, or different type or size, the vehicle
stability control system may not function correctly.
When replacing the tires or wheels, contact your
Lexus dealer.
In situations where the road surface is covered with
ice or snow, your vehicle should be fitted with snow
tires or tire chains.
G31038

Slip indicator light
If the vehicle is going to skid during driving, the slip indicator
light blinks and an alarm sounds intermittently. Special care
should be taken while driving.
GS430—The slip indicator light comes on when the engine
switch is selected in “IG−ON” mode. The light goes off when
the engine is started.
GS300—The slip indicator light comes on for a few seconds
when the engine switch is selected in “IG−ON” mode.
If the indicator light does not come on when the engine switch
is selected in “IG−ON” mode, contact your Lexus dealer.

STARTING AND DRIVING
422
Vehicle stability control failure warning
G31039

1
GS430 2
GS300
If the vehicle stability control system malfunctions, the
slip indicator light (two−wheel drive models only) and
brake system warning light (yellow) come on. At this time,
the above message appears. (GS430 only—In some
cases, the multi−information display shows either
“CHECK VSC” or “CHECK ECB” only.)
If the message appears, the vehicle stability control system,
traction control system and hill−start assist control system do
not work. Although it is no problem to continue driving, have
your vehicle checked by your Lexus dealer as soon as
possible.
HILL−START ASSIST CONTROL
SYSTEM
The hill−start assist control system assists you in starting
to move up a steep or slippery hill. When you start to move
up the hill slope, the system helps to prevent the vehicle
from rolling backward in the interval while you move your
foot from the brake pedal to the accelerator pedal.
CAUTION
Do not rely excessively on the hill−start assist control
system. The vehicle may not be able to start
smoothly on road surfaces or off−road surfaces such
as extremely steep slopes or icy roads, on which
sliding can occur very easily.
Do not use the hill−start assist control system to stop
the vehicle. This system is not designed for stopping
the vehicle on an uphill slope.