AUDIO
ccii
1Ejecting a CD
(See page ccxii for details.)
2Function buttons
1 — 6: Station selector buttons
(See page ccviii for details.)
SCAN: Scan tuning
(See page ccix for details.)
P.SCAN: Preset scan tuning
(See page ccix for details.)
3Display of functions in TAPE or CD mode
:DOLBY NR
(See page ccx for details.)
: Rewinding or reversing
(See page ccx or ccxvi for details.)
: Fast forwarding
(See page ccx or ccxvi for details.)
RPT: Automatic repeat
(See page ccxi or ccxvi for details.)
:CD selection
(See page ccxiv for details.)
RAND: Random access
(See page ccxvii for details.)
SCAN: Scan selection
(See page ccxv for details.)
4CD slot
(See page ccxii for details.)
5Automatic Sound Levelizer (ASL)/Mute
(See page cciv or ccvi for details.)
6TUNE/AUDIO CONTROL knob
(See page ccv for details.)
7 :Side change
(See page ccx for details.)
8Mode selectors
(See page cciv for details.)
9Stopping and ejecting a cassette tape
(See page ccix for details.)
10Turning the system on and adjusting the volume
(See page cciii for details.)
11Cassette tape slot
(See page ccix for details.)
12Radio mode: Seek tuning
(See page ccviii for details.)
TAPE mode: Direct access to a desired program
(See page ccxi for details.)
CD mode: Direct access to a desired program
(See page ccxvi for details.)
AUDIO
ccv
In the “TAPE” or “CD” mode, the applicable functions are
shown in the lowest part of the display. Push the switch
just below to turn on each function.
(b) Tone and balance
How good an audio program sounds to you is largely
determined by the mix of the treble, mid−range, and bass
levels. In fact, different kinds of music and vocal programs
usually sound better with different mixes of treble, mid −range
and bass.
A good balance of the left and right stereo channels and of the
front and rear sound levels is also important.
Keep in mind that if you are listening to a stereo recording or
broadcast, changing the right/left balance will increase the
volume of one group of sounds while decreasing the volume
of another.Each time you push the “AUDIO CONTROL” knob, the
display changes as in the following. To adjust the tone and
balance, turn the knob.
BAS: Adjusts low− pitched tones.
MID: Adjusts mid− pitched tones.
TRE: Adjusts high− pitched tones.
FAD: Adjusts the sound balance between the front and rear
speakers.
BAL: Adjusts the sound balance between the right and left
speakers.
AUDIO
ccxviii
Audio remote controls
The switches are installed on the left side of the steering wheel.
“MODE” switch: Use this switch to turn on or off the audio
system, or change the audio mode.
To turn on the system, push the switch briefly. To turn off the
system, push and hold the switch until you hear a beep.
To change the audio mode, turn on the system and push the
switch briefly. If a tape or CD is not inserted, the “T APE” or
“CD” mode is skipped.
“
+” switch: Use this switch to adjust the volume.
To increase the volume, push the “+” side. To decrease the
volume, push the “–” side. The volume continues to increase
or decrease while the switch is being pressed. (a) When the radio mode is selected
“
” switch: Use this switch for seek tuning or to select a
preset station.
To select a preset station, push this switch briefly. The
station you assigned to a switch on the audio system will be
selected.
To seek a station, push and hold this switch until you hear
a beep. The radio will begin seeking up or down for a station,
and will stop on reception.
(b) When the “TAPE” mode is selected
“
” switch: Use this switch to fast forward or rewind the
tape or for automatic program selection.
To skip forward or reward for automatic program selection,
push this switch briefly. When automatically selecting a
program, you can skip up to 9 programs at a time. See page
ccxi for details.
To fast forward or rewind the tape, push this switch until you
hear a beep. To stop fast forwarding or rewinding, push the
same side on the switch briefly.