2006 KIA Sorento warning light

Memory fuse
Your vehicle is equipped with a
“Memory Fuse”to prevent battery
discharge if your vehicle is parked
without being operated for prolonged
periods. Use the following proce-
dures before parking the vehicle for
prolonged period.1. Turn off the engine.
2. Turn off the headlights and tail
lights.
3. Open the main fuse box cover in
engine compartment and pull up
the “AUDIO FUSE 20A”. This will
change the memory fuse mode to
prevent battery discharge.IN CASE OF AN EMERGENCY6-12
S2BLA606B
CAUTION
• If the memory fuse is pulled
up from the fuse box housing,
the key reminder warning
chime, door ajar warning
chime and light, and clock will
not operate. The clock must
be reset.
 Even though the memory fuse
is pulled up, the battery can
still be discharged by opera-
tion of the headlights or other
electrical devices.
BL-ENG (CAN)-6.qxd 7/28/05 5:57 PM Page 12

8. Securely tighten the valve of the
jack. Move the jack handle up and
down until the top of the jack con-
tacts the proper point and takes on
a slight load.
Raise the vehicle until the tire just
clears the ground (approximately
1.2 in (30 mm)). Never raise the
wheel higher. Before removing the
wheel lug nuts, make sure the
vehicle is stable and that there is
no chance for it to slip or move.9. Remove the wheel lug nuts by
turning them counterclockwise,
then remove the wheel.
IN CASE OF AN EMERGENCY
6-23
JACK
S2BLC601
S2BLA621A
WARNING - Jack Location
To reduce the possibility of
injury, be sure to use only the
jack provided with the vehicle
and in the correct jack position;
never use any other part of the
vehicle for jack support.
BL-ENG (CAN)-6.qxd 7/28/05 5:57 PM Page 23

BATTERY
MAINTENANCE
7-23
WARNING
- Battery
dangers
Always read the follow-
ing instructions carefully
when handling a battery.
Keep lighted cigarettes
and all other flames or
sparks away from the
battery.
Hydrogen, which is a
highly combustible gas,
is always present in bat-
tery cells and may
explode if ignited.
Keep batteries out of the
reach of children
because batteries con-
tain highly corrosive
SULFURIC ACID. Do not
allow battery acid to
contact your skin, eyes,
clothing or paint finish.
(Continued)
(Continued)
If any electrolyte gets
into your eyes, flush
your eyes with clean
water for at least 15 min-
utes and get immediate
medical attention. If pos-
sible, continue to apply
water with a sponge or
cloth until medical atten-
tion is received.
If electrolyte gets on
your skin, thoroughly
wash the contacted area.
If you feel a pain or a
burning sensation, get
medical attention imme-
diately.
Wear eye protection
when charging or work-
ing near a battery.
Always provide ventila-
tion when working in an
enclosed space.
(Continued)
(Continued)
When lifting a plastic-cased
battery, excessive pressure
on the case may cause battery
acid to leak, resulting in per-
sonal injury. Lift with a battery
carrier or with your hands on
opposite corners.
Never attempt to charge the
battery when the battery
cables are connected.
The electrical ignition system
works with high voltage.
Never touch these compo-
nents with the engine running
or the ignition switched on.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 23

Wheel Replacement
When replacing the metal wheels for
any reason, make sure the new
wheels are equivalent to the original
factory units in diameter, rim width
and offset.
MAINTENANCE
7-29
WARNING
- Tire Inflation
Driving on worn-out tires or
mis-matched tires is very haz-
ardous. Worn-out tires reduce
braking effectiveness, steer-
ing accuracy, and traction.
You are also more likely to
have a blowout on a worn-out
tire. Replace any tire showing
signs of being worn out.
Your vehicle is equipped with
tires designed to provide for
safe ride and handling capa-
bility. Do not use a size and
type of tire and wheel that is
different from the one that is
originally installed on your
vehicle. It can affect the safety
and performance of your vehi-
cle, which could lead to han-
dling failure or rollover and
serious injury.
(Continued)
(Continued)
When replacing the tires, be
sure to equip all four tires with
the tire and wheel of the same
size, type, tread, brand and
load-carrying capacity. If you
nevertheless decide to equip
your vehicle with any
tire/wheel combination not
recommended by Kia for off
road driving, you should not
use these tires for highway
driving.
The use of any other tire size
or type may seriously affect
ride, handling, ground clear-
ance, tire clearance, and
speedometer calibration.
Replace all four tires at the
same time. Replacing tires in
part can seriously affect your
vehicle’s handling.
WARNING
A wheel that is not the correct
size may adversely affect wheel
and bearing life, braking and
stopping abilities, handling
characteristics, ground clear-
ance, body-to-tire clearance,
snow chain clearance,
speedometer calibration, head-
light aim and bumper height.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 29

BULB REPLACEMENT
Headlight Replacement
1. Open the hood.
2. Remove the light assembly from
the body of the vehicle loosening
the bolts.
MAINTENANCE
7-33
S2BLA725A Headlight
Headlight
 Front turn signal light


WARNING- Working on the lights
Prior to working on the light,
firmly apply the parking brake
and ensure that the ignition
switch is turned to the “LOCK”
position to avoid sudden move-
ment of the vehicle and burning
your fingers or receiving an
electric shock.
WARNING- Halogen Bulbs
Halogen bulbs contain pres-
surized gas that will produce
flying pieces of glass if bro-
ken.
Always handle them carefully,
and avoid scratches and abra-
sions. If the bulbs are lit, avoid
contact with liquids. Never
touch the glass with bare
hands. Residual oil may cause
the bulb to overheat and burst
when lit. A bulb should be
operated only when installed
in a headlight.
If a bulb becomes damaged or
cracked, replace it immediate-
ly and carefully dispose of it.
Wear eye protection when
changing a bulb. Allow the
bulb to cool before handling
it.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 33

EXTERIOR CAREExterior General Caution
It is very important to follow the label
directions when using any chemical
cleaner or polish. Read all warning
and caution statements that appear
on the label.Finish Maintenance
Washing
To help protect your vehicle’s finish
from rust and deterioration, wash it
thoroughly at least once a month with
lukewarm or cold water.
Pay special attention to the removal
of any accumulation of salt, dirt, mud,
and other foreign materials. Make
sure the drain holes in the lower
edges of the doors and rocker panels
are kept clear and clean.
Insects, tar, tree sap, bird droppings,
industrial pollution and similar
deposits can damage your vehicle’s
finish if not removed immediately.Even prompt washing with plain
water may not completely remove all
these deposits. A mild soap, safe for
use on painted surfaces, may be
used.
After washing, rinse the vehicle thor-
oughly with lukewarm or cold water.
Do not allow soap to dry on the finish.
MAINTENANCE
7-43
✽ ✽
NOTICEDo not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 43

Waxing
Wax the vehicle when water will no
longer bead on the paint.
Always wash and dry the vehicle
before waxing. Use good quality liq-
uid or paste wax, and follow the man-
ufacturer’s instructions. Wax all metal
trim to protect it and to maintain its
luster.
Removing oil, tar, and similar materi-
als with a spot remover will usually
strip the wax from the finish. Be sure
to re-wax these areas even if the rest
of the vehicle does not yet need wax-
ing.
MAINTENANCE7-44
WARNING
After washing the vehicle, test
the brakes while driving slowly
to see if they have been affected
by water. If braking performance
is impaired, dry the brakes by
applying them lightly while
maintaining a slow forward
speed.
WARNING- Water Washing in Engine
Compartment
Water washing in the engine
compartment may cause failure
of electrical circuits. Systems
of your vehicle could fail when
you need them. Wash your
engine compartment carefully.
Check your vehicle’s features
before driving again.
✽ ✽
NOTICE Wiping dust or dirt off the body
with a dry cloth will scratch the
finish.
 Do not use steel wool, abrasive
cleaners, or strong detergents
containing high alkaline or caus-
tic agents on chrome-plated or
anodized aluminum parts. This
may result in damage to the pro-
tective coating and cause discol-
oration or paint deterioration.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 44

A
ir Bag - Supplemental Restraint System . . . . . 3-44
Air Cleaner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-20
Antenna . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-86
Automatic Climate Control System . . . . . . . . . . . 4-79
Automatic Transmission . . . . . . . . . . . . . . . . . . . . 4-9
Automatic Transmission . . . . . . . . . . . . . . . . . . . 7-17
B
attery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-23
Brake System . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-30
Brakes and Clutch . . . . . . . . . . . . . . . . . . . . . . . 7-14
Bulb Replacement . . . . . . . . . . . . . . . . . . . . . . . 7-33
C
ruise Control . . . . . . . . . . . . . . . . . . . . . . . . . . 4-38
Cup Holder . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-78
D
efroster . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-65
Door Locks . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Electrical Circuit Protection . . . . . . . . . . . . . . . . . 6-7
Electrical Power Outlet . . . . . . . . . . . . . . . . . . . . 3-82
Emergency Starting . . . . . . . . . . . . . . . . . . . . . . . 6-4
Emission Control System . . . . . . . . . . . . . . . . . . . 5-3
Engine Compartment . . . . . . . . . . . . . . . . . . . . . . 7-8Engine Cooling System . . . . . . . . . . . . . . . . . . . 7-11
Engine Oil and Oil Filter . . . . . . . . . . . . . . . . . . . . 7-9
Exterior Care . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-43
Four Wheel Drive(4WD) . . . . . . . . . . . . . . . . . . . 4-20
Front Seat . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-13
Fuel Filler Lid . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-70
Fuel Requirements . . . . . . . . . . . . . . . . . . . . . . . . 5-2G
auges . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-43
H
azard Warning Flasher . . . . . . . . . . . . . . . . . . 4-66
Hood . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-69
How to Use This Manual . . . . . . . . . . . . . . . . . . . .1-2
If You Have a Flat Tire . . . . . . . . . . . . . . . . . . . . 6-19
Ignition Switch . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-2
Immobilizer System . . . . . . . . . . . . . . . . . . . . . . . 3-3
Instrument Cluster . . . . . . . . . . . . . . . . . . . . . . . 4-41
Instrument Panel Overview . . . . . . . . . . . . . . . . . . 2-3
Interior and Exterior Overview . . . . . . . . . . . . . . . 2-2
Interior Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-47
Interior Features . . . . . . . . . . . . . . . . . . . . . . . . . 4-67
Interior Lights . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-76
INDEX9-2
BL-ENG (CAN)-9.qxd 7/28/05 5:59 PM Page 2