2006 KIA Sorento ABS

6. Install a new bulb by inserting it
into the socket and rotating it until
it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
8. Connect the front turn signal light
electrical connector.
9. Reinstall the light assembly to the
body of the vehicle.Front Fog Light Bulb
Replacement
1. Reach your hand into the front
bumper below the fog light hous-
ing.2. Remove the socket from the hous-
ing by turning the socket counter
clockwise until the tabs on the
socket align with the slots on the
housing.
3. Remove the bulb by pulling it
straight out.
4. Install a new bulb in the socket.
5. Install the socket in the housing by
aligning the tabs on the socket with
the slots in the housing. Insert the
socket into the housing and turn
the socket clockwise.MAINTENANCE7-36
S2BLA737
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 36

Interior Lights Bulb Replacement
1. Using a flat-blade screwdriver,
gently pry the lens from the interior
light housing.
2. Remove the bulb by pulling it
straight out.
3. Install a new bulb.
4. Align the lens tabs with the interior
light housing notches and snap the
lens into place.
MAINTENANCE
7-37
DOWN
PUSHMODE
/SETUP
S2BLA738A
O
F
FDOORON
S2BLA739
OFF ON
S2BLA740S2BLA750
Doom light Map lightRear cargo area light
Door courtesy light
CAUTION
Prior to working on the Interior
Lights, ensure that the “OFF”
button is depressed to avoid
burning your fingers or receiv-
ing an electric shock.
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 37

Vanity Mirror Light
1. Using a flat-blade screwdriver,
gently pry the lens from the sunvi-
sor.
2. Remove the bulb by pulling it
straight out.
3. Install a new bulb.
4. Align the lens tabs with the light
housing notches and snap the lens
into place.Center High-Mounted Stoplight
Bulb Replacement
1. Open the rear hatch.
2. Remove the trim from the rear
hatch after removing fasteners of
the both sides on the trim.3. Separate the socket and the lens
part by pulling the socket retaining
tabs outward.MAINTENANCE7-38
S2BLA742
S2BLA743
S2BLA752
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 38

2. Loosen the light assembly retain-
ing screws with a cross-tip screw-
driver.
3. Slide the rear combination light out
to disconnect the rear combination
light assembly from the body of the
vehicle.4. Remove the socket from the
assembly by turning the socket
counter clockwise until the tabs on
the socket align with the slots on
the assembly.
5. Remove the bulb from the socket
by pressing it in and rotating it until
the tabs on the bulb align with the
slots in the socket. Pull the bulb out
of the socket.6. Insert a new bulb by inserting it
into the socket and rotating it until
it locks into place.
7. Install the socket in the assembly
by aligning the tabs on the socket
with the slots in the assembly.
Push the socket into the assembly
and turn the socket clockwise.
8. Reinstall the light assembly to the
body of the vehicle.
9. Tighten the screws.MAINTENANCE7-40
S2BLA746C
OPEN
CLOSE
S2BLA747
BL-ENG (CAN)-7.qxd 7/28/05 5:58 PM Page 40