2006 KIA Optima run flat

 Keep the engine in tune and follow the
recommended periodic maintenance
schedule.
This will increase the life of all parts
and lower your operating costs.
 Do not use the air conditioner
unnecessarily.
 Slow down when driving on rough
roads.
 For longer tire life and better fuel
economy, always keep the tires
inflated to the recommended
pressures.
 Maintain a safe distance from other
vehicles to avoid sudden stops. This
will reduce wear on brake linings and
pads and save fuel because extra fuel
is required to accelerate back to
driving speed.
 Do not carry unnecessary weight in
the vehicle. Do not rest your foot on the brake
pedal while driving. This can cause
needless wear, possible damage to
the brakes, and poor fuel economy.
 Improper wheel alignment causes the
tires to roll at excessive angles,
which results in faster tire wear. It
takes more power to overcome this
improper alignment, which wastes
fuel.
 Open windows at high speeds can
reduce fuel economy.
 Crosswinds and headwinds reduce
fuel economy. To help offset some of
this loss, slow down when driving in
these conditions.
Keeping a vehicle in good operating
condition is important both for
economy and safety.
Therefore, have an Authorized Kia
Dealer perform scheduled inspections
and maintenance.
DRIVING TIPS
5-6
WARNING - Engine OFF
Motion
Never turn the engine off to
coast down hills or anytime the
vehicle is in motion. The power
steering and power brakes will
not function without the engine
running. Instead, downshift to
any appropriate gear for engine
braking effect.
MS-CNA-Eng 5 New.qxd 7/25/2005 5:21 PM Page 6

IF YOU HAVE A FLAT
TIRESTORING THE SPARE
TIRE, JACK AND TOOLSThe spare tire, tool bag, jack and jack
handle are stored in the trunk
compartment. Move the carpeting out of
the way to reach this equipment.
TO REMOVE THE JACK:Turn the jack socket counterclockwise.
TO REMOVE SPARE TIRE:Turn the tire hold-down wing bolt
counterclockwise.
Store the tire in the reverse order of
removal.
To prevent the jack, jack handle, and
tool bag from “rattling” while the
vehicle is in motion, store them properly.
6-19
MMSA6013
MMSA6014A
MMSA6012
Tool bag
spare tireJack
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 19

CHANGING TIRESJACKING INSTRUCTIONSThe jack is provided for emergency tire
changing only. Follow jacking
instructions to reduce the possibility of
personal injury.
TIRE REPLACEMENT1. Park on a level surface and set the
parking brake firmly.
2. Set the automatic transaxle in P
(Park), or shift the manual transaxle
into R (Reverse).
3. Activate the hazard warning flasher.
4. Remove the wheel lug nut wrench,
jack, jack handle, and spare tire from
the vehicle.
5. Block both the front and rear of the
wheel that is diagonally opposite the
jack position.
IN CASE OF EMERGENCY
6-22
MMSA6015Flat tire
Wheel block
WARNING - Changing
Tires
Never attempt vehicle repairs
or a tire change in the traffic
lanes of a public road or
highway. Always move the
vehicle completely off the
road and onto the shoulder
before trying to change a tire.
If you cannot find a firm, level
place off the road, call a
towing service company for
assistance.
Be sure to use the correct
front or rear jacking
positions on the vehicle;
never use the bumpers or
any other part of the vehicle
for jack support.
Never allow any portion of
your body to get beneath the
vehicle while using the jack.
Do not start or run the engine
while the vehicle is
supported by the jack.
MS-CNA-Eng 6.QXD 7/25/2005 5:13 PM Page 22

MAINTENANCE
7-36TRUNK ROOM LIGHT BULB
REPLACEMENT (IF EQUIPPED)1. Remove the trunk room lamp cover
using flat blade screw driver.
2. After replacement of bulb, install the
cover.
LUBRICANT
SPECIFICATIONSRECOMMENDED
LUBRICANTSTo help achieve proper engine and
powertrain performance and durability,
use only lubricants of the proper quality.
The correct lubricants also help promote
engine efficiency which results in
improved fuel economy.
Engine oils labeled Energy Conserving
Oil are now available. Along with other
additional benefits, they contribute to
fuel economy by reducing the amount of
fuel necessary to overcome engine
friction. Often, these improvements are
difficult to measure in everyday driving,
but in a year’s time they can offer
significant cost and energy savings.
MMSA7031
MS-CNA-Eng 7.QXD 7/25/2005 5:09 PM Page 36