2006 KIA Magnetis lock

DOOR LOCKS MANUAL DOOR LOCKSOPERATING DOOR LOCKS -
WITH KEY• Both front doors can be locked and
unlocked with the key.
• Turn the key to the left to lock and to
the right to unlock the door.
• Once a door is unlocked, it may be
opened by pulling the door handle.
OPERATING DOOR LOCKS-
WITHOUT KEYTo lock a door without the key, push the
inside door lock button to the “LOCK”
position and close the door.
3-9
MMSA3001
MMSA3002 LOCK UNLOCK
✻
NOTICE
Always remove the ignition key,
engage the parking brake, close all
windows and lock all doors when
leaving your vehicle unattended.
CAUTION
The transponder in your ignition
key is an important part of the
immobilizer system. It is designed
to give years of trouble free service,
however you should avoid exposure
to moisture, static electricity and
rough handling. Immobilizer
system malfunction could occur.
CAUTION
Do not change, alter or adjust the
immobilizer system because it
could cause the immobilizer system
to malfunction and should only be
serviced by an authorized Kia
dealer.
Malfunctions caused by improper
alterations, adjustments or
modifications to the immobilizer
system are not covered by your
vehicle manufacturer warranty.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 9

OPERATING DOOR LOCKS
FROM INSIDE THE VEHICLE• To lock a door, push the door lock
button to the “LOCK” position.
• To unlock a door, push the door lock
button to the “UNLOCK” position.
• To open a door, pull the door handle
towards the middle of your vehicle.
The door ajar warning light will
illuminate if a door is not fully closed.
Close the door completely and the light
will go out.
POWER DOOR LOCKS
(IF EQUIPPED)The power door lock switch is located on
the driver’s armrest. If any door is open
when the switch is depressed, the door
will remain locked when closed.
KNOWING YOUR VEHICLE
3-10
MMSA3004
UNLOCKLOCK
MMSA3003
UNLOCK
RED MARK
LOCK
WARNING
Never leave children or animals
unattended in the vehicle. An
enclosed vehicle can become
extremely hot and depleted of
oxygen, causing death or
severe injury to children or to
animals who cannot escape the
vehicle.
CAUTION
The doors should always be fully
closed and locked while the vehicle
is in motion to prevent accidental
opening of the doors. Locked doors
will also discourage potential
intruders when the vehicle stops or
slows.✻
NOTICE
When the door is locked, the red
mark on the switch is not visible.
✻
NOTICE• Pushing the front portion of the
driver’s door lock switch will
cause all vehicle doors to lock.
• Pushing the rear portion of the
switch will cause all vehicle
doors to unlock.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 10

3-11
REAR DOOR CHILD
SAFETY LOCKThe child safety lock is provided to help
prevent children from accidentally
opening the rear doors from inside the
vehicle.
• To lock a rear door so that it cannot
be opened from the inside, push the
child safety lock located on the rear
edge of the door to the “LOCKED”
position before closing the door.
• To open a rear door while the child
safety lock is engaged, push the door
lock button to the “UNLOCK”
position (red mark is visible) then
pull the outside door handle.
WINDOWSPOWER WINDOWS The ignition switch must be in the ON
position for power windows to operate.
Each door has a power window switch
that controls the door’s window.
However, the driver has a power window
lock switch which can cancel the
operation of the three passenger window
switches.✻
NOTICE
To prevent the power window fuse
from malfunctioning and the power
window system from being
damaged, do not open or close
more than two windows at the
same time.
WARNING - Rear Door
Locks
If children accidentally open the
rear doors while the vehicle is
in motion, they could fall out
and be seriously or fatally
injured. To prevent children
from opening the rear doors
from the inside, the rear door
safety locks should be used
whenever children are in the
vehicle.
MMSA3005
LOCKFREE
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 11

DRIVER’S DOOR POWER
WINDOW CONTROLSAll windows can be opened or closed
using the power window master control
on the driver’s door. To open a window,
press down on the corresponding power
window switch. To close a window, pull
up on the corresponding power window
switch.
DRIVER’S WINDOW
AUTOMATIC-DOWN WINDOW
SWITCHThe driver’s window has an “Automatic-
Down” feature. To activate the express-
down feature, momentarily depress the
front of the switch to the second detent
position. To cancel this feature, pull up
on the front of the switch and then
release it.DRIVER’S POWER WINDOW
SWITCHThe driver’s power window switch
provides two (2) separate window-down
functions.
• Depressing the driver’s power
window switch completely, automa-
tically lowers (Automatic-Down) the
driver’s window. To cancel this
function, pull up on the front of the
switch and release it.• Depressing the driver’s power
window switch partially (to the first
detent) provides precise control of the
window-down position.
To raise/close the driver’s window,
pull up on the power window switch.
POWER WINDOW TIMER
(IF EQUIPPED)The power windows can be operated for
approximately 30 seconds after the
ignition key is removed or turn to the
ACC or LOCK position. However, if the
front doors are opened, the power
windows cannot be operated even within
the 30 seconds after the ignition key
removal.
KNOWING YOUR VEHICLE
3-12
MMSA3004
Power window master controlPower window lock switch
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 12

POWER WINDOW LOCK
SWITCH FEATUREThe driver can disable the power window
switches on all passenger doors by
depressing the power window lock switch
located on the driver’s door to ON. When
the power window lock switch is ON, the
driver’s master control can not operate the
passenger door power windows either.
PASSENGER DOOR POWER
WINDOW CONTROLSTo open a window, press the front portion
of the switch down. To close a window,
pull the front portion of the switch up.
3-13
MMSA3006
WARNING - Power
Windows
 Keep the power window lock
switch on the driver’s door in
the ON (depressed) position
except when someone is
operating a passenger door
window. Serious injury can
result from unintentional
window opera-tion, especially
to children.
 Always double check to make
sure all arms, hands, and other
obstructions are safely out of
the way before closing a
window.✻
NOTICE
If you experience buffeting and
pulsation (wind shock) with either
side window open, you should open
the opposite window slightly to
reduce the condition.
WARNING - Passengers
Do not allow children to play
with the power windows. They
may seriously injure
themselves or others.
MMSA3004
Power window lock switch
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 13

SEATS
FRONT SEAT ADJUSTMENTMOVING THE FRONT SEAT
FORWARD AND BACKWARDTo move the seat forward or backward;
1. Pull the seat slide adjustment lever
under the front edge of the seat
cushion up and hold it.
2. Slide the seat to the position you
desire.
3. Release the lever and make sure the
seat is locked in place.
KNOWING YOUR VEHICLE
3-14
MMSA3007
WARNING - Drivers
 Never adjust the driver’s seat
or seatback when the vehicle
is moving. Doing so could
cause loss of control, and
serious personal injury or
death.
 Do not allow packages or
other objects to interfere with
the normal position of a
seatback. These objects may
prevent the seatback from
locking, which could result in
serious injury or death in the
event of a sudden stop or
collision.
 Always drive and ride with
your seatback upright and
the lap portion of the safety
belt snug and low across the
hips.
 Children can be killed or
injured by the passenger air
bag. The back seat is the
safest place for children 12
and under. Make sure all
children use seat belts or
child seats.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 14

ADJUSTING THE FRONT
SEATBACK RECLINERTo recline the seatback;
1. Lean forward slightly and lift up on
the seatback recline lever located on
the outside of the seat, toward the rear.
2. Lean back on the seat and adjust the
back of the seat to the position you
desire.
3. Release the lever and make sure the
seatback is locked in place. (The
lever MUST return to its orginal
position for the seatback to lock.)
3-15
MMSA3008
CAUTION
Do not place anything under the
front seats. Loose objects might
interfere with the seat slide
mechanism or possibly roll out
from under the seat and interfere
with the operation of the brake,
clutch or accelerator foot pedals.
WARNING - Passengers
To reduce the risk of sliding
under the lap portion of the
lap/shoulder belt, and potentially
suffering serious personal injury
or death in the event of a
collision, do not use the front
seatback in a reclined position
while the vehicle is in motion. If a
seat is reclined, the occupant’s
hip could slide under or out of
the lap portion of the
lap/shoulder belt during a
collision. If that occurs, the
occupant may no longer be
properly restrained, and the
safety belt could apply restraint
forces to the unprotected
abdomen resulting in serious
personal injury or death.
Therefore, keep the seatbacks in
a comfortably upright position
whenever the vehicle is in
motion.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 15

ADJUSTING SEAT FORWARD
AND BACKWARDPull the control knob forward or
backward to move the seat forward or
backward to the desired position.
Release the knob and then the seat will
lock at that position.
1. Reclining Control Knob
2. Sliding and Height Adjusting Control
Knob
3-17
MMSA3011
WARNING
 Never attempt to adjust the
seat while the vehicle is
moving. This could result in
loss of control, and an
accident causing death,
serious injury, or property
damage.
 Do not sit or lean
unnecessarily close to the
airbag to get better
protection during its deploy-
ment in case of an accidents.
 Sit at least 10 inches (250
mm) away form the steering
wheel while driving the
vehicle to avoid injury during
air bag deployment in an
accident.
WARNING
To ensure the seat is locked
securely, attempt to move the
seat forward or backward
without using the control knob.
MS-CNA-Eng 3.QXD 7/25/2005 5:17 PM Page 17