6
DO-IT-YOURSELF MAINTENANCE
37
Vertical Aiming
Horizontal Aiming
G290B03E-GAT
Adjustment After Headlight Assembly Replacement
G290B01L
LW
H
H Cut-off line be checked using an aiming screen as shown in the illustration. Turn on theheadlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is parallel to the center lineof the body and is aligned with point"P" shown in the illustration.
2. Dotted lines in the illustration show
the center of the the headlights. Specifications: "H": Horizontal center line of headlights from ground.Low beam : 639 mm (25.2 in.) High beam : 619 mm (23.3 in.) "W": Distance between each headlightcenter.Low beam : 1124 mm (44.2 in.) High beam : 840 mm (33.0 in.) "L": Distance between the headlights andthe wall that the lights are testedagainst.: 3,000 mm (118 in.).
"P"
30mm (1.18 in.) Vertical line
G290A02E
5. Open the hood.
6. Draw the vertical line (through the center of each headlight beam pat-tern) and the horizontal line (through the center of each headlight beam pattern) on the aiming screen.And then, draw a horizontal paral-lel line at 30 mm (1.18 in.) underthe horizontal line.
7. Adjust each cut-off line of the low beam to the parallel line with aphillips screwdriver - VERTICAL AIMING.
8. Adjust each cut-off line of the low beam to the each vertical line with a phillips screwdriver - HORIZON-TAL AIMING. LHD
Horizontal line
Ground line
G290B01L-D
L
W
H
H Cut-off line
"P"
30mm (1.18 in.)
Vertical line
Horizontal line
Ground line
RHD
If the vehicle has had front body repair
and the headlight assembly has been replaced, the headlight aiming should
