Your Vehicle at a Glance
4
ENGINE START BUTTON
HEADLIGHTS/
TURN SIGNALSHOOD RELEASE HANDLE HORNWINDSHIELD WIPERS/
WASHERS
REMOTE AUDIO CONTROLS
CLOCK SET
BUTTONINSTRUMENT PANEL BRIGHTNESS
CRUISE CONTROLHEATING AND AIR
CONDITIONING
(P.101)
(P.122)
(P.57) (P.110) (P.103) (P.103)(P.56)
(P.82)
(P.58)
(P.54) VEHICLE STABILITY ASSIST
(VSA) SYSTEM OFF SWITCH
(P.129)
CRUISE BUTTON
——y
y
(yy
µ´
The odometer shows the total
distance your vehicle has been
driven in miles and kilometers. It is
illegal under U.S. f ederal law and
Canadian provincial regulations to
disconnect, reset, or alter the
odometer with the intent to change
the number of miles and kilometers
indicated.This trip meter shows the number of
miles or kilometers driven since you
last reset it.To reset a trip meter, display it, and
then press and hold the TRIP button
until you hear a beep and the
number resets to ‘‘0.0’’.
The select button switches the
speedometer reading between miles
per hour and kilometers per hour. It
also changes the odometer and trip
meters to read in miles or kilometers
correspondingly. To change the
readings, push the SELECT button,
and hold it until you hear a beep.
There are two trip meters: Trip A
and Trip B. Switch between these
displays by pressing the TRIP button
repeatedly. Each trip meter works
independently, so you can keep track
of two dif f erent distances.
Odometer T rip Meter
Select Button
Gauges
Inst rument s and Cont rols
51
TACHOMETER
TRIP METERSELECT BUTTON
CLOCK
CLOCK BUTTON
TRIP BUTTON
SPEEDOMETER
OUTSIDE TEMPERATURE INDICATOR
FUEL GAUGE
TEMPERATURE GAUGE
BUTTON ODOMETER/CHECK FUEL CAP INDICATORBUTTON
——y
y
(yy
´µ´µ
The inf ormation display in the
instrument panel shows you the
engine oil lif e and maintenance
service items when the ignition
switch is in the ON (II) position. This
inf ormation helps to keep you aware
of the periodic maintenance your
vehicle needs f or continued trouble-
f ree driving. Ref er to page f or
more inf ormation.
The clock displays the time with the
ignition switch in the ON (II)
position.
To set the clock:
Turn the ignition switch to the ON
(II) position.
Press and hold the CLOCK button
until the minute display blinks.
Adjusttheminutebypressingthe or button.
When you f inish the minute
adjustment, press and release the
CLOCK button. The hour display
will blink. Adjust the hour by
pressing the or button. When you f inish your adjustments,
press the CLOCK button again.
1.
2.
3. 4.
133
Gauges
Maintenance Minder Clock
54
——y
y
(yy
Î
ÎTo use the horn, press the pad around the ‘‘H’’ logo.
Controls Near the Steering Wheel
Inst rument s and Cont rols
55
REMOTE AUDIO
CONTROLS
HOOD RELEASE
HANDLEINSTRUMENT PANEL BRIGHTNESS
HEADLIGHTS/TURN SIGNALS
ENGINE START BUTTON
HORNWINDSHIELD WIPERS/WASHERS
CRUISE CONTROL
(P.57)
(P.101)
(P.122)
(P.110) (P.103 )(P.56)
(P.129)
(P.58)
VEHICLE STABILITY ASSIST (VSA)
SYSTEM OFF SWITCH
CRUISE BUTTON
(P.103) CLOCK SET BUTTON
(P.54)
HEATING AND AIR
CONDITIONING(P.82)
——y
y
(yy
´
Õ Ü
To replace the battery, remove the
round cover on the back of the
transmitter by turning it
counterclockwise with a coin. Insert
a new battery with the side facing
up. Align the mark on the cover
with the mark on the
transmitter. Set the cover in place,
andturnitclockwise.
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR2025
As required by the FCC: This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.Replacing the Transmitter
Battery
Remote Transmitter
66
BATTERY ROUND
COVER
——y
y
(yy
Install the new bulb into the
socket.
Push the socket into the light
assembly, and turn it clockwise
until it locks.Install the trunk lining, and secure
it with the fasteners. To reinstall a
f astener, reset the f astener by
pushing on the pointed end until it
pops back almost f lush with the
f ingers on the housing. Put the
f astener in the hole of the trunk
lining, and push on the center until
it locks (the center is f lush with
the head).
Turn on the lights to make sure
the new bulb is working.
If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.
Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water or isopropyl alcohol.
7.
8.
9.
10.
Lights, Cleaning the Seat Belts
Cleaning the Seat Belts
Maint enance
157
——y
y
(y
y
If there was no coolant in the
reserve tank, you may need to add
coolant to the radiator. Let the
engine cool down until the reading
reaches the middle of the
temperature gauge or lower
bef ore checking the radiator.Using gloves or a large heavy
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the f irst stop. Af ter the
pressure releases, push down on
the cap, and turn it until it comes
off.Put the radiator cap back on
tightly. Run the engine, and watch
the temperature gauge. If it goes
back to the red mark, the engine
needs repair (see
on page ).
If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on
tightly.
Start the engine, and set the
temperature control dial to
maximum heat. Add coolant to the
radiator up to the base of the f iller
neck. If you do not have the
proper coolant mixture available,
you can add plain water.
Remember to have the cooling
system drained and ref illed with
the proper mixture as soon as you
can.
9. 8.
7. 10.
11.191
Emergency
Towing
If theEngineOverheats
T aking Care of t he Unexpect ed
181
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
——y
y
(y
y
ÎÎ
Î
Î
.................................
Parking Lights .57
.............................
PGM-FI System .202
...................................
Pollen Filter .158
..........................
Power Door Locks .63
..................
Power Socket Location .77
..............................
Power Windows .68
.........
Pregnancy, Using Seat Belts .14
........................
Preparing to Drive .121
.........
Protecting Adults and Teens .10
...
Additional Safety Precautions .15
.....
Advice f or Pregnant Women .14
........................
Protecting Children .28
.....................
General Guidelines .28
.......
Protecting Larger Children . 36
.........
Protecting Small Children . 32
...................
Radiator Overheating . 179
...............
Radio/CD Sound System . 86
.................
Radio Thef t Protection . 102
...................
Readiness Codes . 183,204
..
Rear Lights, Bulb Replacement . 156
............................
Rear View Mirror .75
.................
Rear Window Def ogger . 59
................
Reclining the Seat-backs . 67.......
Recommended Shif t Speeds . 124
Recovery Vehicle, Emergency .......................................
Towing .191
........................................
Ref ueling .109
.......................
Reminder Indicators .45
.......................
Remote Transmitter .65
Replacement Inf ormation ..............
Dust and Pollen Filter . 158
................
Engine Oil and Filter . 144
..........................................
Fuses .186
................................
Light Bulbs .152
....................................
Schedule .133
...........................................
Tires .164
.............................
Wiper Blades .159
Replacing Seat Belts Af ter a ............................................
Crash .18
..........
Reporting Saf ety Def ects . 208
Reserve Tank, Engine ...............................
Coolant .112, 146
...............................
Restraint, Child .28
...........................
Reverse Lockout .124
................................
Rotation, Tire .163
..................................
Saf ety Belts .8, 16 .........
Safety Defects, Reporting . 208
.................................
Saf ety Features .7
...........................................
Airbags .9
.......................................
Seat Belts .8
.............
Saf ety Labels, Location of . 41
...............................
Saf ety Messages .ii
................................
Satellite Radio .91
.....................................
Seat Belts .8, 16
...............
Additional Information . 16
.....
Advice f or Pregnant Women . 14
Automatic Seat Belt ...............................
Tensioners .18
.....................................
Cleaning .157
......................
Lap/Shoulder Belt .17
................................
Maintenance .18
Reminder Indicator and ................................
Beeper .16, 46
...................
System Components . 16
...............
Use During Pregnancy . 14
........................
Seats, Adjusting the .67
...............................
Serial Number .194
...........................
Service Intervals .139
...........................
Service Manual .209
.........
Service Station Procedures . 109
............................
Setting the Clock .54
Index
S
R
VI
——y
y
(y
y