2006 HONDA S2000 engine oil capacity

CONT INUED
Remove the oil f ilter, and let the
remaining oil drain. A special
wrench (available from your
dealer) is required.
Open the hood, and remove the
engine oil f ill cap. Remove the oil
drain bolt and washer f rom the
bottom of the engine. Drain the oil
into an appropriate container.
Install the engine oil f ill cap. Start
the engine. The oil pressure
indicator should go out within5
seconds. If it does not, turn of f the
engine, and check your work.
Check the oil f ilter to make sure
its gasket did not stick to the
engine block. A stuck gasket could
cause an oil leak. Engine oil change capacity
(including f ilter): Refill the engine with the
recommended oil. Put a new washer on the drain bolt,
then reinstall the drain bolt.
Tighten the drain bolt to: Install a new oil f ilter according to
the instructions that come with it.
Make sure to clean of f any dirt
and dust on the connecting
surf ace of a new oil f ilter.
2. 4. 3.5.
6.
7.
8.
Changing the Oil and Filter
Maint enance
145
WASHER OIL DRAIN BOLT
OIL FILTER
33 lbf·ft (45 N·m ,4.6 kgf·m)
5.1 US qt (4.8
)
——y
y
(y
y

Î
Î
´
µ
Î
Î
Specif ications
196
Dimensions
Engine WeightsCapacities
162.0 in (4,115 mm)
68.9 in (1,750 mm)
50.6 in (1,285 mm)
94.5 in (2,400 mm)
57.9 in (1,470 mm)
59.4 in (1,510 mm) 13.2 US gal (50)
132 cu-in (2,157 cm
)
11.1 : 1 1.72 US gal (6.5
)
2.01 US gal (7.6)
5.1 US qt (4.8
)
4.8 US qt (4.5)
5.9 US qt (5.6)
1.6 US qt (1.5)
1.7 US qt (1.6)
0.78 US qt (0.74
)
0.81 US qt (0.77)
2.6 US qt (2.5)
6.3 US qt (6.0)
3.43 x 3.57 in (87.0 x 90.7 mm)
Length
Width
Height
Wheelbase
Track
See the certification label attached
to the driver’s doorjamb.Water cooled 4-stroke DOHC
VTEC 4-cylinder gasoline engine
Type
BorexStroke
Displacement
Compression ratio
Spark plugs
Spark Plug Gap 0.04 in (1.1 mm) PK22PR-L11S PFR7G-11S Including the coolant in the reserve tank and that remaining in the
engine
Reserve tank capacity:
0.16 US gal (0.6
)
Excluding the oil remaining in the engine
Gross vehicle weight rating
(GVWR)
Fuel tank
Engine coolant
Engine oil
Manual
transmission
fluid
Differential
fluid
Windshield
washer
reservoir
Front
Rear
1:
2:
NGK :
DENSO : Change
Total
Change
Total
Change
Total
Change
Total
U.S. Vehicles
Canadian
Vehicles
0mm
0.1 mm
1
2
Including filter
Without filter
——y


y
(y
y

Service Inf ormation Summary
Gasoline:
Fuel Tank Capacity:Tire Pressure (measured cold):
SpareTirePressure:
Recommended Engine Oil: Manual Transmission Fluid:
Brake Fluid:
60 psi (420 kPa , 4.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm
)
32 psi (220 kPa , 2.2 kgf/cm
)
5.1 US qt (4.8
)
Premium unleaded gasoline,
pump octane number of 91 or
higher.
Oil change capacity (including
filter):
Front:
Rear:
API premium grade 10W-30
detergent oil (see page ). Front:
Honda Manual Transmission
Fluid preferred, or an SAE 10W-30
or 10W-40 motor oil as a
temporary replacement (see page
).
Capacity:
Honda Heavy Duty Brake Fluid
DOT 3 preferred, or a DOT 3 or
DOT 4 brake fluid as a temporary
replacement (see page ). 1.7 US qt (1.6
)
143 149
151
13.2 US gal (50)
——y


y
(yy