2006 HONDA INSIGHT key

µ
If you are not wearing a seat
belt in crash, you could be thrown
f orward and crush the child
against the dashboard. If you are
wearing a seat belt, the child can
be torn f rom your arms and be
seriously hurt or killed.
If they do, they
could be very seriously injured in a
crash. Leaving children without
adult supervision is illegal in most
states and Canadian provinces,
and can be very hazardous.
For example, a small child lef t in a
vehicle on a hot day can die f rom
heatstroke. A child lef t alone with
the key in the ignition switch can
accidentally set the vehicle in
motion, possibly injuring
themselves or others.
During a crash, the
belt could press deep into the child
and cause serious or fatal injuries.
Children who play in vehicles can
accidentally get trapped inside.
Teach your children not to play in
or around vehicles. Even very young
children learn how to unlock
vehicle doors, turn on the ignition
switch, and open the hatch, which
can lead to accidental injury or
death.
Additional Saf ety Precautions
Protecting Children General Guidelines
Never hold a small child on your
lap.
Never let two children use thesame seat belt . Do not leave children alone in a
vehicle.
Never put a seat belt over yourself and a child.
Lock both doors and the hatchwhen your vehicle is not in use. K eep vehicle keys and remot e
transmitters out of the reach ofchildren.
28

This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your vehicle. All the essential
controls are within easy reach............................
Control Locations .42
............................
Instrument Panel .43
..........
Instrument Panel Indicators . 44
.............................................
Gauges .48
..................................
Fuel Gauge .49
...................
Temperature Gauge . 49
.....................................
Odometer .49
..............
Display Change Button . 49
.................
Current Fuel Mileage . 50
.................................
Trip Meters .50
................................
Trip Mileage .50
Segment Distance and Fuel ....................................
Mileage .51
................
Lif etime Fuel Mileage . 51
Turning Of f the Mileage ....................................
Displays .52
..................
Battery Level Gauge . 53
................
Charge/Assist Gauge . 53
Controls Near the Steering ...........................................
Wheel .54
.
Windshield Wipers and Washers . 55
...........
Turn Signal and Headlights . 56
........
Instrument Panel Brightness . 57
.................
Hazard Warning Button . 57
.................
Rear Window Def ogger . 58
...............................
Keys and Locks .59 ........................
Immobilizer System .60
................................
Ignition Switch .61
......................................
Door Locks .62
................................................
Hatch .63
.......................
Remote Transmitter .64
.................................................
Seats .66
..............................
Power Windows .67
.............................................
Mirrors .68
.................................
Parking Brake .69
...........
Interior Convenience Items . 70
.................................
Storage Box .71
.........................
Beverage Holder .71
....................................
Glove Box .71
...........
Accessory Power Socket . 71
.................................
Interior Lights .72
Instruments and Controls
Inst rument s and Cont rols
41

This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or the LOCK
(0) position.
This indicator comes on with the
high beam headlights. For more
inf ormation, see page .
This indicator comes on f or a f ew
seconds when you turn the ignition
switch to the ON (II) position. It will
then go of f if you have inserted a
properly-coded ignition key. If it is
not a properly-coded key, the
indicator will blink, and the engine
will not start (see page ).
On Canadian models, this indicator
comes on with reduced brightness
when the daytime running lights
(DRL) are on (see page ).
This indicator comes on when you
turn the ignition switch to the ON
(II) position with the headlight
switch of f and the parking brake set.
It should go of f if you turn on the
headlights or release the parking
brake. If it comes on at any other
time, it means there is a problem
withtheDRL.Theremayalsobea
problem with the high beam
headlights. This indicator comes on as a
reminder that you must ref uel soon.
This indicator comes on if either
door or the hatch is not closed
tightly. When the indicator comes on, there
is about 1.00 US gal (3.8
)of fuel
remaining in the tank bef ore the
reading reaches E. There is a small
reserve of f uel remaining in the tank
when the f uel gauge reading does
reach E.
56
56 60
Canadian models only
Instrument Panel Indicators
High Beam Indicator Immobilizer System
Indicator
‘‘Daytime Running
Lights’’ Indicator Low Fuel Indicator
Door and Hatch Open
Indicator
46

µµµ
Push down on the
lever to signal a lef t turn and up to
signal a right turn. To signal a lane
change, push lightly on the lever,
and hold it. The lever will return to
center when you release it or
complete a turn. Push the lever
f orward until you hear a click to turn
on the high beams. The blue high
beam indicator will come on (see
page ). Pull the lever back to
return to the low beams.
The headlights revert to normal
operation when you turn them on
with the switch. With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to the ON (II)
position and release the parking
brake. They remain on until you turn
the ignition switch of f , even if you
set the parking brake. To f lash the high beams, pull the
lever back lightly, then release it.
The high beams will stay on as long
as you hold the lever back.
Turn Signal
OFF
Parking and interior lights
Headlights on
High Beams
Flashhighbeams Turning the
switch to the position turns on
the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the position turns on the
headlights. If you leave the lights on
with the key removed from the
ignition switch, you will hear a
reminder tone when you open the
driver’s door.
1.
2.
3.
4.
5.
6. 46
Turn Signal
High Beams
(Canadian Models) Daytime Running L ights
Headlights On
Turn Signal and Headlights
56

The master key fits all the locks on
your vehicle.The valet key works only in the
ignition and the door locks. You can
keep the glove box and the hatch
locked when you leave your vehicle
and the valet key at a parking f acility.
Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a lost key replaced. Use
only Honda-approved key blanks.
These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity. Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The keys do not contain batteries.
Do not try to take them apart.
Keys and Locks
Inst rument s and Cont rols
59
KEY
NUMBER
TAG VALET
KEY
(GREY)
MASTER
KEYS
(BLACK)

When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on f or
a f ew seconds, then go of f . If the
indicator starts to blink, it means the
system does not recognize the
coding of the key. Turn the ignition
switch to the LOCK (0) position,
remove the key, reinsert it, and turn
the ignition switch to the ON (II)
position again. The immobilizer system protects
your vehicle f rom thef t. If an
improperly-coded key (or other
device) is used, the engine’s f uel
system is disabled.If you have lost your key and cannot
start the engine, contact your dealer. Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle undrivable. If the system repeatedly does not
recognize the coding of your key,
contact your dealer. The system may not recognize your
key’s coding if another immobilizer
key or other metal object (i.e. key
f ob) is near the ignition switch when
you insert the key.
As required by the FCC:This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Immobilizer System
60

µ
µ
µ µ
The ignition switch has f our
positions: LOCK (0), ACCESSORY
(I), ON (II), and START (III). If the f ront wheels are turned, the
anti-thef t lock may make it dif f icult
to turn the key. Firmly turn the
steering wheel to the lef t or right as
you turn the key.
You can
operate the audio system and the
accessory power socket in this
position.
This is the normal key
position when driving. Several of the
indicators on the instrument panel
come on as a test when you turn the
ignition switch f rom the
ACCESSORY (I) to the ON (II)
position. You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or the
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper.
If your vehicle has an automatic
transmission, the shif t lever must be
in Park bef ore you can remove the
key f rom the ignition switch.
You can insert or
remove the key only in this position.
To turn the key to the LOCK (0)
position, push it in slightly. If your
vehicle has an automatic
transmission, the shif t lever must
also be in park. Use this position
only to start the engine. The switch
returns to the ON (II) position when
you let go of the key.
Ignition Switch
A CCESSORY (I)
ON (II)
LOCK (0) ST A RT (III)
Inst rument s and Cont rols
61
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control of the
vehicle.
Remove the key from the
ignition switch only when
parked.

The doors can also be locked and
unlocked f rom the outside with the
key.
Each door has a lock tab next to the
inside door handle. Push the tab in to
lock the door, and pull it out to
unlock.
To lock the passenger’s door when
getting out of the vehicle, push the
lock tab in and close the door. To
lock the driver’s door, pull the door
handle and push the lock tab in.
Release the handle, then close the
door.
The master door lock switch allows
control of both door and hatch locks
f rom the driver’s door. Push the
switch down to lock both doors and
the hatch, and up to unlock the
driver’s door. Door L ocks
Power Door L ocks
Door L ocks
62
LOCK TAB
MASTER DOOR LOCK SWITCH Unlock
Lock