2006 HONDA CIVIC COUPE bulb

This indicator normally comes on f or
a f ew seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, there is a problem with the
ABS. If this happens, have your
vehicle checked at a dealer. With
this indicator on, your vehicle still
has normal braking ability but no
anti-lock f unction. For more
inf ormation, see page .The lef t or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle f lash.
This indicator comes on brief ly when
you turn the ignition switch to the
ON (II) position. It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine’s f uel system will be
disabled (see page ).
204 235
75
Instrument Panel Indicators
Anti-lock Brake System
(A BS) Indicator
Turn Signal and Hazard Warning
Indicators
Immobilizer System
Indicator
Inst rument s and Cont rols
59
——y

y
(+yy

Theheadlightswereproperlyaimed
when your vehicle was new. If you
regularly carry heavy items in the
trunk, readjustment may be required.
Adjustment should be done by your
dealer or other qualif ied mechanic.Your vehicle has halogen headlight
bulbs. When replacing a bulb, handle
it by its base, and protect the glass
f rom contact with your skin or hard
objects. If you touch the glass, clean
it with denatured alcohol and a clean
cloth.
Open the hood.
To change a bulb on the driver’s
side, remove the coolant tube f rom
the two clips, then remove the
reserve tank f rom its holder by
pulling it straight up.
1.
Lights
Headlight A iming
Replacing a Headlight BulbHigh Beam Headlight
232
COOLANT
TUBE
CLIP
Halogen headlight bulbs get very hot
when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
——y
y
(+yy

Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb. Insert the new bulb into the hole,
and turn it one-quarter turn clock-
wise to lock it in place.
Remove the bulb by turning it
about one-quarter turn
counterclockwise. Remove the electrical connector
f rom the bulb by pushing on the
tab to unlock it, then slide the
connector of f the bulb. (Driver’s side)
Put the tube back in the clips and
install the reserve tank back in
place, making sure its bottom tab
is in the holder.
2.
3. 4.
5.
6.
7.
CONT INUED
Lights
Maint enance
233
TAB
BULB
CONNECTOR
HOLDER
——y
y
(+yy

To change the driver’s side bulb,
start the engine, turn the steering
wheel all the way to the right, and
turn of f the engine. To change the
passenger’s side bulb, turn the
steering wheel to the lef t. Remove the electrical connectorf rom the bulb by pushing on the
tab to unlock it, then slide the
connector of f the bulb.Remove the bulb f rom the
headlight assembly by turning it
one-quarter turn counterclockwise.
Insert the new bulb into the hole,
and turn it one-quarter turn clock-
wise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the headlights to test the
new bulb.
Use a Phillips head screwdriver to
remove the screw from the inner
f ender, and pull the inner f ender
cover back. Reinstall the inner f ender cover.
Then reinstall the screw and
tighten it securely.
2.
1.
3.4.
5.
6.
7.
8.
Lights
L ow Beam Headlight
234
SCREW
——y
y
(+yy

Remove the bulb f rom the socket
by pushing the bulb in and turning
it counterclockwise until it unlocks.
Install the new bulb in the socket.
Turn it clockwise to lock it in place.
Insert the socket back into the
headlight assembly. Turn it
clockwise to lock it in place.
Turn on the lights to make sure
the new bulb is working.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
To change the driver’s side bulb,
start the engine, turn the steering
wheel all the way to the right, and
turn of f the engine. To change the
passenger’s side bulb, turn the
steering wheel to the lef t.
Use a Phillips head screwdriver to
remove the screw from the inner
f ender, and pull the inner f ender
cover back.
Reinstall the inner f ender cover.
Then reinstall the screw and
tighten it securely.
4.
5.
6.
7.
8.
3. 2.
1.
Lights
Replacing the Front Side Marker/
Parking/Turn Signal Light Bulb
Maint enance
235
——y
y
(+yy

Open the trunk.Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Remove the screw in the center of
the fastener on the side of the
trunk lining. Pull the lining back. Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Turn on the lights to make sure
the new bulb is working.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Put the f astener into the hole on
the side of the trunk lining.
Reinstall the screw.
Determine which of the f our bulbs
is burned out: stop/taillight, back-
up light, side marker light, or turn
signal light.
Remove the socket by turning it
one-quarter turn counterclockwise.
1. 2.
3.4.
5.
6.
7.
8.
Replacing Rear Bulbs
Lights
236
FASTENER
——y



y
(+yy

If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle.
Reinstall the cover, and tighten its
holding clips securely. Reinstall the socket. Turn it
clockwise until it locks. Make sure
the new bulb is working. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
Open the trunk, then remove the
holding clips f rom the cover, and
remove the cover.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.
2. 1.
3.
4.
5.
CONT INUED
On DX and LX models
Replacing a High-mount Brake
Light Bulb Cleaning the Seat Belts
Lights, Cleaning the Seat Belts
Maint enance
237
SOCKETBULB LOOP
——y

y
(+yy

CONT INUED
...
Accessories and Modif ications .186
ACCESSORY (Ignition Key
.......................................
Position) .76
............
Accessory Power Sockets .104
................
Adding Engine Coolant .224
....................
Additives, Engine Oil .221
.......
Adjusting the Steering Wheel .73
.........
Advice f or Pregnant Women .16
...............................
Airbag (SRS) .9,21
..............
Air Conditioning System .110
.........................................
Usage .113
.......................
Air Pressure, Tires .242
.......................
Alcohol in Gasoline .180
......................................
Antif reeze .224
Anti-lock Brakes (ABS)
...............................
Indicator .59, 204
...................................
Operation .204
..............
Anti-thef t, Audio System . 172
Anti-thef t Steering Column ..............................................
Lock .76
................................
Audio System .115
.....
Auto Door Locking/Unlocking . 78
...
Automatic Seat Belt Tensioners . 19
.............
Automatic Speed Control . 175..............
Automatic Transmission . 198
..........................
Capacity, Fluid .278
...............
Checking Fluid Level . 228
.......................................
Shif ting .198
Shif t Lever Position ...............................
Indicators .198
................
Shif t Lever Positions . 198
....................
Shif t Lock Release . 201
Battery Charging System ...........................
Indicator .57, 263
............................
Jump Starting .259
..............................
Maintenance .248
............................
Specif ications .279
..............................
Bef ore Driving .179
....................................
Belts,Seat .8,18
.........................
Beverage Holders .103
..................................
Booster Seats .47
Brakes ...........
Anti-lock System (ABS) . 204
.............
Break-in, New Linings . 180
....................
Bulb Replacement .236
...........................................
Fluid .230 .......................................
Parking .101
..........................
System Design .203
.................
System Indicator . 58,265
........................
Wear Indicators .203
.............................
Braking System .203
.................
Break-in, New Vehicle . 180
..
Brightness Control, Instruments . 71
........................
Brights, Headlights .70
Bulb Replacement ..........................
Back-up Lights .236
..............................
Brake Lights .236
................
Front Parking Lights . 235
........
Front Side Marker Lights . 235
.................................
Headlights .232
.........
High-mount Brake Light . 237
............................
Specif ications .279
....................
Turn Signal Lights . 235
..............................
Bulbs, Halogen .232
............................
Capacities Chart .278
.............
Carbon Monoxide Hazard . 50
.............................
Carrying Cargo .188
Index
A
B
C
INDEX
I
——y
y
(+yy