2006 HONDA CIVIC COUPE cooling

Pour coolant into the reserve tank.
Fill it to half way between the MAX
and MIN marks. Put the cap back
on the reserve tank.
Do not add any rust inhibitors or
other additives to your vehicle’s
cooling system. They may not be
compatible with the coolant or
engine components.
The coolant level should be up to
the base of the f iller neck. Add
coolant if it is low.
Pourthecoolantslowlyand
caref ully so you do not spill any.
Clean up any spill immediately; it
could damage components in the
engine compartment.
Put the radiator cap back on, and
tighten it fully.
Remove the radiator cap by
pushing down and turning
counterclockwise.
3. 4.
5.6.
Engine Coolant
226
RADIATOR CAP
RESERVE TANK
Si RESERVE TANK
Si
DX, Canadian DX-G, LX, EX
——y

y
(+yy

Check the condition of the wiper
blades at least every six months.
Replace them if you f ind signs of
cracking in the rubber, areas that are
getting hard, or if they leave streaks
and unwiped areas when used.
This f ilter removes the dust and
pollenthatisbroughtinfromthe
outside through the heating and
cooling system.
To replace a wiper blade:
Have your dealer replace the filter
when this service is indicated by a
maintenance message on the
inf ormation display. It should be
replaced every 15,000 miles (24,000
km) if you drive primarily in urban
areas that have high concentrations
of soot in the air, or if the f low f rom
the heating and cooling system
becomeslessthanusual.
Raise each wiper arm of f the
windshield, lif ting the driver’s side
first, then the passenger’s side.
1.
CONT INUED
On models with A/C
Wiper Blades
Dust and Pollen Filter
Dust and Pollen Filter, Wiper Blades
Maint enance
239
Do not open the hood when the wiper
arms are raised, or you will damage the
hood and wiper arms.
——y

y
(+yy

If you need to park your vehicle f or
an extended period (more than 1
month), there are several things you
should do to prepare it f or storage.
Proper preparation helps prevent
deterioration and makes it easier to
get your vehicle back on the road. If
possible, store your vehicle indoors.Fill the f uel tank.
Change the engine oil and f ilter. Block the rear wheels.
If the vehicle is to be stored f or a
longer period, it should be
supported on jackstands so the
tires are of f the ground.
Wash and dry the exterior
completely.
Cleantheinterior.Makesurethe
carpeting, floor mats, etc., are
completely dry. Cover the vehicle with a
‘‘breathable’’ cover, one made
f rom a porous material such as
cotton. Non-porous materials, such
as plastic sheeting, trap moisture,
which can damage the paint.
Leave one window open slightly (if
the vehicle is being stored
indoors). If possible, periodically run the
engine until it reaches f ull
operating temperature (the
cooling f ans cycle on and of f
twice). Pref erably, do this once a
month.
To minimize sticking, apply a
silicone spray lubricant to all door
and trunk seals. Also, apply a
vehiclebodywaxtothepainted
surfaces that mate with the door
and trunk seals. Support the f ront wiper blade
arms with a f olded towel or rag so
they do not touch the windshield. Disconnect the battery.
Leave the parking brake off. Put
the transmission in reverse
(manual) or Park (automatic).
Vehicle Storage
250
——y

y
(+yy

Put the radiator cap back on
tightly. Run the engine, and watch
the temperature gauge. If it goes
back to the red mark, the engine
needs repair (seeon page ).
If you do not see steam or spray,
leave the engine running, and
watch the temperature gauge. If
the high heat is due to overloading,
the engine should start to cool
down almost immediately. If it
does, wait until the temperature
gauge comes down to the midpoint,
then continue driving.
If the temperature gauge stays at
the red mark, turn of f the engine.
Look f or any obvious coolant leaks,
such as a split radiator hose.
Everything is still extremely hot,
so use caution. If you f ind a leak, it
must be repaired bef ore you
continue driving (see
on page ).
If you don’t f ind an obvious leak,
check the coolant level in the
radiator reserve tank (see page ). Add coolant if the level is
below the MIN mark. Start the engine, and set the
temperature control dial to
maximum heat. Add coolant to the
radiator up to the base of the f iller
neck. If you do not have the
proper coolant mixture available,
you can add plain water.
Remember to have the cooling
system drained and ref illed with
the proper mixture as soon as you
can.
If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on
tightly.
Using gloves or a large heavy
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the f irst stop. Af ter the
pressure releases, push down on
the cap, and turn it until it comes
off. If there was no coolant in the
reserve tank, you may need to add
coolant to the radiator. Let the
engine cool down until the reading
reaches the middle of the
temperature gauge or lower
bef ore checking the radiator.
7.
8. 9.
3.
4.
5.
6. 272
185 272
10.
11.
Emergency
Towing
Emergency
Towing
If theEngineOverheats
262
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.
——y

y
(+yy

...............
Gas Mileage, Improving .185
..........................................
Gasohol .180
.........................................
Gasoline .180
...........................................
Gauge .66
.....................
Low Fuel Indicator .62
................
Octane Requirement .180
........................
Tank, Ref ueling .181
................
Gas Station Procedures .181 Gauges
...
Engine Coolant Temperature .66
...............................................
Fuel .66
Gearshif t Lever Positions ..........
Automatic Transmission .198
..............
Manual Transmission .196
......................................
Glove Box .103
Gross Axle Weight Rating
.....................................
(GAWR) .189
Gross Vehicle Weight Rating .....................................
(GVWR) .189
.............
Halogen Headlight Bulbs . 232
..............
Hazard Warning Flashers . 72
Headlights ........................................
Aiming .232
............
Daytime Running Lights . 71
..................
High Beam Indicator . 61
........................
Reminder Beeper .70
........
Replacing Halogen Bulbs . 232
...................................
Turning on .70
..............................
Head Restraints .93
.............................
Heated Mirrors .101
.....................
Heating and Cooling .110 .............
High Altitude, Starting at . 194
............................
High Beam Lever .70
..............
High-mount Brake Light . 237
..
Hood, Opening and Closing the . 182
..................................................
Horn .68
...........................
Hydraulic Clutch .231
...
Identif ication Number, Vehicle . 276
..............
If the Engine Overheats . 261
..............
If the Engine Wont Start . 257
Ignition ..............................................
Keys .74
...........................................
Switch .76
............
Timing Control System . 284
........................
Immobilizer System .75
.........
Important Safety Precautions . 6
Indicators ..............
ABS (Anti-Lock Brake) . 59
Brake (Parking and Brake ....................................
System) .58
................
Charging System . 57,263
.............................
Cruise Control .61
DRL (Daytime Running ......................................
Lights) .61
..............................
Front Airbags .9 ,23
Front Seat ......................................
Adjusting .90
.....................................
Airbags .9, 23
.................................................
Fuel .180
..........
Check Fuel Cap Indicator . 66
....................................
Economy .185
......................
Fill Door and Cap .181
...........................................
Gauge .66
.....................
Low Fuel Indicator .62
................
Octane Requirement . 180
...............................
Oxygenated .180
........................
Tank, Ref ueling .181
..............................
Fuse Locations .270
.....................
Fuses, Checking the .266
Index
G HI
IV
——y
y
(+yy