2006 HONDA CIVIC COUPE ECO mode

µ
µ
µ µ
µ
µ
µ µ µ
Push the right lever up or down to
select a position. MIST
OFF
INT Intermittent
LO Low speed
HI High speed
Windshield washers The wipers run at high
speed until you release the lever.
The wipers are not activated.
The wipers operate every
f ew seconds. In low speed and high
speed, the wipers run continuously.
The wipers run at high speed.The wipers run at low speed.
The length of the wiper interval is
varied automatically according to the
vehicle’s speed.
Vary the delay by turning the INT
TIME ring. If you turn it to the
shortest delay, the wipers change to
low speed when the vehicle speed
exceeds 12 mph (20km/h). Pull the
wiper control lever toward you, and
hold it. The washers spray until you
release the lever. The wipers run at
low speed, then complete one more
sweep after you release the lever.
1.
2.
3.
4.
5.
6.
OnEXandSimodelsinU.S.,andLX, EXandSimodelsinCanada
Windshield Wipers and Washers
MIST
OFF
INT
HI LO Windshield Washer
Inst rument s and Cont rols
69
——y
y
(+yy

If the system repeatedly does not
recognize the coding of your key,
contact your dealer.
Do not attempt to alter this system
or add other devices to it. Electrical
problems could result that may make
your vehicle undrivable.
If you have lost your key and cannot
start your engine, contact your
dealer.
The system may not recognize your
key’s coding if another immobilizer
key or other metal object (i.e. key
f ob) is near the ignition switch when
you insert the key. When you turn the ignition switch to
the ON (II) position, the immobilizer
system indicator should come on
brief ly, then go of f . If the indicator
starts to blink, it means the system
does not recognize the coding of the
key. Turn the ignition switch to the
LOCK (0) position, remove the key,
reinsert it, and turn the ignition
switch to the ON (II) position again. The immobilizer system protects
your vehicle f rom thef t. If an
improperly-coded key (or other
device) is used, the engine’s f uel
system is disabled.
These keys contain electronic
circuits that are activated by the
immobilizer system. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The keys do not contain batteries.
Do not try to take them apart.
CONT INUED
On DX model (except Canadian DX-G)
Immobilizer System
Keys and Locks, Immobilizer System
Inst rument s and Cont rols
75
——y
y
(+yy

The auto door locking f eature has
two or three possible settings,
depending on the transmission type
(A/T or M/T):Make sure the shif t lever is in
Park (P), and close the driver’s
door.
Turn the ignition switch to the ON
(II) position.Set the parking brake.
Push and hold the brake pedal,
then move the shift lever out of
Park (P).
Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, move the shif t
lever to Park (P), and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
Close the driver’s door.
Turn the ignition switch to the ON
(II) position.
The doors lock when the vehicle
speed reaches 9 mph (15 km/h).
On vehicles with automatic
transmission, the doors lock
whenever you move the shif t lever
out of the Park position.
The auto door locking is
deactivated all the time.
This is the def ault setting when
the vehicle leaves the f actory.
1.
2. 1. 3.
4.
5.
6.
2.
Locks both doors when the vehicle’s
speed reaches about 9 mph (15 km/h).
On vehicles with automatic transmission On vehicles with manual transmission
CONT INUED
Door L ocks
To activate either auto door lockmode:A uto Door L ocking
Inst rument s and Cont rols
79
——y
y
(+yy

Open the driver’s door.
On vehicles with automatic
transmission, make sure the shif t
lever is in Park (P).
Turn the ignition switch to the ON
(II) position.
Set the parking brake.Pushandholdthefrontof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
The auto door unlocking f eature has
two or three of these possible
settings, depending on the
transmission type (A/T or M/T):
The driver’s door unlocks
whenever you turn the ignition
switch to the LOCK (0) position.
On vehicles with automatic
transmission, the driver’s door
unlocks when you move the shif t
lever to the Park position.
This is the def ault setting when
the vehicle leaves the f actory. The auto door unlocking is
deactivated all the time.
4.
5.
1.
2.
3.
CONT INUED
Door L ocks
To turn the auto door lock modes off:A uto Door Unlocking
Inst rument s and Cont rols
81
——y
y
(+yy

Turn the ignition switch to the ON
(II) position. Make sure the shif t lever is in
Park (P), and close the driver’s
door.Set the parking brake.
Push and hold the brake pedal,
then move the shift lever out of
Park (P).
Pushandholdtherearof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, move the shif t
lever to Park (P), and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
Close the driver’s door.
Turn the ignition switch to the ON
(II) position.
Pushandholdtherearof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about
5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition switch to the LOCK (0)
position within 5 seconds. Set the parking brake.
1.
2. 3.
4.
5.
6.
1.
2.
3.
4.
5.
On vehicles with automatic transmission
Unlocks the driver’s door when the
ignition switch is out of the ON (II)position. On vehicles with manual transmission
Door L ocks
To activate either auto door unlock
mode:
82
——y
y
(+yy

Unlocks driver’s door when the shiftlever is moved to Park (P).On vehicles with automatic transmissiononly
Make sure the shif t lever is in
Park (P), and close the driver’s
door.
Turn the ignition switch to the ON
(II) position.
Set the parking brake. Pushandholdtherearof the
master door lock switch on the
driver’s door. You will hear a
clicking sound, and af ter about 5
seconds, you will hear another
clicking sound.
Release the switch, and turn the
ignition switch to the LOCK (0)
position within 5 seconds.
Open the driver’s door.
On vehicles with automatic
transmission, make sure the shif t
lever is in Park (P).
Turn the ignition switch to the ON
(II) position.
Set the parking brake.
1.
2.
3. 4.
5.
1.
2.
3.
CONT INUED
Door L ocks
To turn the auto door unlock modesoff:
Inst rument s and Cont rols
83
——y
y
(+yy

µ
µ
CONT INUED
The ceiling light (if the ceiling light
switch is in the center position) and
the spotlights (if the switch is in the
Door position on EX and Si models)
will come on when you press the
UNLOCK button. If you do not open
either door within 30 seconds, the
lights f ade out. If you relock the
doors with the remote transmitter
bef ore 30 seconds have elapsed, the
lightsgoesoff immediately.
If you do not open either door within
30 seconds, the doors automatically
relock, and the security system sets
(onU.S.LX,EX,andSimodels).You
cannot unlock it if the key is in the
ignition switch.
Press this button once
to unlock the driver’s door. Push it
twice to unlock the passenger’s door.
Some exterior lights will f lash twice
each time you push the button.
Press this button once to
lock both doors. Some exterior lights
will f lash once. When you push
LOCK twice within 5 seconds, you
will hear a beep to verify that the
doors are locked and that the
security system has set (on U.S. LX,
EX and Si models). You cannot lock
the doors if either door is not f ully
closed or the key is in the ignition
switch.
U.S.:LX,EX,Si
Canada: DX-G, LX, EX, Si
Remote Transmitter
UNL OCK
LOCK
Inst rument s and Cont rols
85
UNLOCK
BUTTON LOCK
BUTTON
TRUNK
RELEASE
BUTTON
PANIC
BUTTON LED
U.S. EX and Si models
UNLOCK
BUTTON LOCK
BUTTON
PANIC
BUTTON LED
U.S.: LX Canada: DX-G, LX, EX, Si
——y
y
(+yy

µ
µ
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616
To replace the battery:Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Press this
button f or about 1 second to open
the trunk. You cannot open the trunk
if the key is in the ignition switch.
Pressthisbuttonfor
about 2 seconds to attract attention:
the horn will sound, and the exterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
1.
OnU.S.EXandSimodels
Remote Transmitter
Replacing the Transmitter
Battery
T RUNK REL EA SE
PA NICRemote Transmitter Care
86
SCREW
U.S. EX and Si models are shown.
——y
y
(+yy