2006 HONDA ACCORD SEDAN starting the engine

This section covers the more
common problems that motorists
experience with their vehicles. It
gives you inf ormation about how to
safely evaluate the problem and what
to do to correct it. If the problem has
stranded you on the side of the road,
you may be able to get going again.
If not, you will also f ind instructions
on getting your vehicle towed.......................
Compact Spare Tire .238
....................
Changing a Flat Tire .239
.............
If the Engine Won’t Start . 243
Nothing Happens or the Starter Motor Operates ............................
Very Slowly .243
The Starter Operates ................................
Normally .244
................................
Jump Starting .245
..............
If the Engine Overheats . 248
.........
Low Oil Pressure Indicator . 250
..........
Charging System Indicator . 251
.......
Malf unction Indicator Lamp . 251
.......................
Readiness Codes .252
...............
Brake System Indicator . 253
..................
Closing the Moonroof . 254
......................
Emergency Towing .255
..............................................
Fuses .257
..............................
Fuse Locations .260
Taking Care of the Unexpected
T aking Care of t he Unexpect ed
237
——y
y
(yy

Diagnosing why the engine won’t
start falls into two areas, depending
on what you hear when you turn the
ignition switch to the START (III)
position: When
you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound or series of clicks, or
nothing at all.
Store the wheel cover or center
cap in the trunk. Make sure it does
not get scratched or damaged. You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
faster than normal, but the engine
does not start up and run.
You
hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
Turn the ignition switch to the ON
(II) position. Turn on the
headlights, and check their
brightness. If the headlights are
very dim or do not come on at all,
the battery is discharged. See on page .
Check the transmission interlock.
If you have a manual transmission,
the clutch pedal must be pushed
all the way to the f loor or the
starter will not operate. With an
automatic transmission, it must be
in Park or neutral.
Check these things:
21.
245
CONT INUED
If the Engine Won’t StartNothing Happens or the Starter
Motor Operates Very Slowly
Jump Starting
Changing a Flat Tire, If the Engine Won’t Start
T aking Care of t he Unexpect ed
243
Loose items can fly around the
interior in a crash and could
seriously injure the occupants.
Store the wheel, jack, and tools
securely before driving.
——y
y
(yy

In this case, the starter motor’s
speed sounds normal, or even faster
than normal, when you turn the
ignition switch to the START (III)
position, but the engine does not run.Are you using the proper starting
procedure? Refer to on page .
Are you using a properly coded
key? An improperly coded key will
cause the immobilizer system
indicator in the instrument panel
to blink rapidly (see page ). Do you have fuel? Check the fuel
gauge; the low fuel indicator m
ay
not be working.
There may be an electrical
problem, such as no power to the
fuel pump. Check all the fuses
(see page ).
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is dis-
charged or the connections are
corroded. Check the condition of
the battery connections (see page ). You can then try jump
starting the vehicle from a booster
battery (see page ). Turn the ignition switch to the
START (III) position. If the
headlights do not dim, check the
condition of the fuses. If the fuses
areOK,thereisprobably
something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualified mechanic to
determine the problem (see on page ). Ifyoufindnothingwrong,youwill
need
a qualified mechanic to find the
problem. See
on page .
255
234 245 169
75 257
255
If theEngineWon’tStart
T he Starter Operates Normally
Starting the
Engine
Emergency T owing Emergency T owing
244
——yy
(yy

µ
´
´
Connect the second jumper cable
to the negative ( ) terminal on
the booster battery. Connect the
other end to the grounding strap
as shown. Do not connect this
jumper cable to any other part of
the engine.
Connect one jumper cable to the
positive ( ) terminal on your
battery. Connect the other end to
the positive ( ) terminal on the
booster battery.
4.
3.
Jump Starting
246
4-cylinder models
BOOSTER
BATTERY
6-cylinder models
——yy
(yy

Immediately turn of f all electrical
accessories. Try not to use other
electrically operated controls such as
the power windows. Keep the engine
running; starting the engine will
discharge the battery rapidly.
Go to a service station or garage
where you can get technical
assistance.
If the charging system indicator
comes on brightly when the engine
is running, the battery is not being
charged. If the indicator comes on while
driving, it means one of the engine’s
emission control systems may have a
problem. Even though you may f eel
no dif f erence in your vehicle’s
perf ormance, continued operation
may cause serious damage.
CONT INUED
Malf unction Indicator L amp
Charging System Indicator
Charging System Indicator, Malf unction Indicator L amp
T aking Care of t he Unexpect ed
251
CHARGING SYSTEM INDICATOR
MALFUNCTION INDICATOR LAMP
——y
y
(yy

If the indicator remains on or the
fu el cap was not loose or missing,
have the vehicle checked by the
dealer as soon as possible. If
your vehicle’s battery has been
disconnected or gone dead, these
conditions to set the codes again.
If
you have recently refueled your
vehicle, the cause of this indicator
coming on could be a loose or
missing fuel fill cap. Check the cap
or replace it. Tightening the cap will
not make the indicator turn off
days of norm al driving. Your
vehicle has certain ‘‘readiness
codes’’ that are part of the on-board
diagnostics for the emissions
systems. In some states, part of the
emissions testing is to make sure
these codes are set. If they are not
set, the test cannot be completed. To
check if they are set, turn the
ignition switch to the ON (II)
position, without starting the engine.
The malfunction indicator lamp will
come on for 20 seconds. If it then
goes off, the readiness codes are set.
If it blinks five times, the readiness
codes are not set. If possible, do not
take your vehicle for a state
emissions test until the readiness
codes are set. Ref er to for more
info rmation (see page ).275
Readiness Codes
State
Emissions T esting
Malf unction Indicator L amp
252
If you keep driving with the
Malf unction Indicator Lamp on, you
can damage your vehicle’s emissions
controls and engine. Those repairs may
not be covered by your vehicle’s
warranties. This indicator may also
come on with the ‘‘D’’ indicator.
——yy
(yy
immediately; it can take several
codes are erased. It can take several
days of driving under various

CONT INUED
BatteryCharging System ...........................
Indicator . 58, 251
............................
Jump Starting .245
..............................
Maintenance .234
............................
Specif ications .267
..............................
Bef ore Driving .153
........................................
Belts, Seat .10
Brakes
...........
Anti-lock System (ABS) .180
.............
Break-in, New Linings .154
...........................................
Fluid .215
.........................................
Parking .99
.........................
System Indicator .59
........................
Wear Indicators .179
.............................
Braking System .179
........................
Break-in, New Car .154
..
Brightness Control, Instruments .72
........................
Brights, Headlights .70
Bulb Replacement
..........................
Back-up Lights .223
..............................
Brake Lights .223
................
Front Parking Lights .221
.................................
Headlights .218 ............................
Specif ications .267
............
Turn Signal Lights . 221, 222
..............................
Bulbs, Halogen .218
....................................
Accessories .162
ACCESSORY (Ignition Key
.......................................
Position) .76
...............
Accessory Power Socket .99
....................
Additives, Engine Oil .205
...................................
Airbag (SRS) .11
..........
Airbag System Components .23
............................
Air Conditioning .105
.........................................
Usage .107
.......................
Air Pressure, Tires .228
Anti-lock Brakes (ABS)
...............................
Indicator . 59, 180
...................................
Operation . 180
.
Anti-thef t Steering Column Lock .78
........
Audio System . 114, 122, 131, 135
.............
Automatic Speed Control . 145
..............
Automatic Transmission . 173
..........................
Capacity, Fluid .266
.......................................
Shif ting .173
.
Shif t Lever Position Indicator . 173
................
Shif t Lever Positions . 173
....................
Shif t Lock Release . 176 ............................
Capacities Chart .266
.............
Carbon Monoxide Hazard . 52
.............................
Carrying Cargo .164
..............
CAUTION, Explanation of . ii
...................................
CD Changer .128
.......................................
CD Player .122
..........................
CD Pocket, Center .99
........................
Certif ication Label .264
............................................
Chains .232
....................
Changing a Flat Tire .239
Changing Oil ........................................
How to .206
......................................
When to .193
...
Charging System Indicator . 58,251
............
Checklist, Bef ore Driving . 168
..................
Childproof Door Locks . 78
Index
AB
C
INDEX
I
——
y

y
(yy