2006 HONDA ACCORD HYBRID Owners Manual

µµ
The childproof door locks are
designed to prevent children seated
in the rear f rom accidentally opening
the rear doors. Each rear door has a
lock lever near the edge. When the
lock lever is pushed down, the door
cannot be opened f rom the inside
regardless of the position of the lock
tab. To open the door, pull the lock
tab up, and use the outside door
handle. Press this button once to
lock all doors. Some exterior and
interior lights will f lash. The doors
do not lock if they are not f ully
closed or the key is in the ignition
switch.
When you push LOCK twice within 5
seconds, you will hear a beep to
verify that the security system is
active. Pressthisbuttononce
to unlock the driver’s door. Push it
twice to unlock the other doors.
The ceiling light (if the ceiling light
switch is in the center position) will
come on when you press the
UNLOCK button. If you do not open
any door, the light stays on f or about
30 seconds, then f ades out. If you
relock the doors with the remote
transmitter before 30 seconds have
elapsed, the light will go of f
immediately.
You cannot lock the doors with the
remote transmitter if they are not
f ully closed or the key is in the
ignition switch.
Remote Transmitter
Childproof Door L ocks
LOCKUNL OCK
Childproof Door L ocks, Remot e T ransmit t er
80
LEVER
LOCK
BUTTON
UNLOCK
BUTTON
PANIC
BUTTON LED
TRUNK
RELEASE
BUTTON
——y

y
('
yy

µµ Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
Af ter the doors automatically relock,
the security system will be active.
Pressthisbuttonfor
about 1 second to attract attention;
thehornwillsoundandtheexterior
lights will f lash f or about 30 seconds.
To cancel panic mode, press any
other button on the remote
transmitter, or turn the ignition
switch to the ON (II) position.
Press this
button f or about 1 second to open
the trunk. You cannot open the trunk
if the key is in the ignition switch. Battery type: CR1616 If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock.
Remote Transmitter
PA NIC
T RUNK REL EA SE Remote Transmitter Care Replacing the Transmitter
Battery
Inst rument s and Cont rols
81
——y

y
('
yy

´
To replace the battery:
Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
Separate the transmitter by prying
its middle seam with your
f ingernail. Inside the transmitter, separate
the inner cover f rom the keypad
by releasing the two tabs on the
cover.
Remove the old battery from the
back of the inner cover, and note
the polarity. Make sure the
polarity of the new battery is the
same ( side f acing down), then
insert it into the back of the cover.
Install the parts in reverse order.
1.
2.
3.
4.
5.
As required by the FCC:
This device complies with Part 15 of theFCC rules. Operation is subject to thef ollowing two conditions: (1) This devicemay not cause harmf ul interf erence, and(2) this device must accept anyinterf erence received, includinginterf erence that may cause undesiredoperation.
Changes or modif ications not expresslyapproved by the party responsible f orcompliance could void the user’sauthority to operate the equipment.
This device complies with IndustryCanada Standard RSS-210.Operation is subject to the f ollowing twoconditions: (1) this device may not causeinterf erence, and (2) this device mustaccept any interf erence that may causeundesired operation of the device.
Remote Transmitter
82
SCREW BATTERY
TAB
——y

y
('
yy

Pull up on the trunk release lever
located to the lef t of the driver’s
seat.Lockthetrunkreleaseleverwith
your master key to prevent someone
f rom opening the trunk. If they need
to lock/unlock the doors or drive
your vehicle, give them your valet
key.
You can open the trunk in either of
the following ways:
Press and hold the trunk release
button on the remote transmitter. To close the trunk, press down on
the trunk lid.
See page f or cargo loading and
weight limit inf ormation. Keep the
trunk lid closed at all times while
driving to avoid damaging the lid,
and to prevent exhaust gas from
getting into the interior. See
on page .
158
49
Trunk
Carbon
Monoxide Hazard
Inst rument s and Cont rols
83
Pull
TRUNK RELEASE LEVER MASTER
KEY
——y


y
('
yy

As a saf ety f eature, your vehicle has
a release lever on the trunk latch so
the trunk can be opened f rom the
inside.To open the trunk, push the release
lever to the lef t.
To use the console lid as an armrest,
slide it to the desired position.
Make sure the passenger’s hands or
fingersareawayfromthearmrest
bef ore moving it.
For more inf ormation about child
saf ety, see page .
35
Emergency T runk Opener A rmrest
Trunk, Armrest
84
RELEASE LEVER
——y

y
('
yy

µ
See pages f or important saf ety
inf ormation and warnings about how toproperly position seats and seat-backs. 13
15
The controls f or the adjustable
driver’s power seat are on the
outside edge of the seat bottom. You
can adjust the power seat with the
ignition switch in any position. Make
all seat adjustments bef ore you start
driving.
Moving the long horizontal switch
adjusts the seat bottom in several
directions. The seat bottom adjusts
in the direction you move the switch.
The short vertical switch adjusts the
seat back angle.
Both f ront seats are equipped with
seat heaters. The driver’s seat has
heaters in both the seat-back and
seat cushion, but because of the
sensors f or the side airbag system,
there is no heater in the passenger’s
seat-back. The ignition switch must
be in the ON (II) position to use the
heaters.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters even on the LO
setting. It can weaken the battery,
causing hard starting. Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
Follow these precautions whenever
you use the seat heaters: In LO, the heater runs continuously.
It does not cycle with temperature
changes. In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat temperature drops. After the seat reaches a comfortable
temperature, select LO by pushing
the back of the switch. This will keep
the seat warm.
Adjusting the Driver’s Seat
Seat Heaters
Seat Heaters, Seats
Inst rument s and Cont rols
85
——y

y
('
yy

To adjust the seat forward and
backward, pull up on the lever under
the right side of the seat cushion’s
f ront edge. Move the seat to the
desired position and release the lever.
Trytomovetheseattomakesureit
is locked in position.
Moves the seat
f orward and backward.
Moves the f ront of the
seat up or down and
the rear of the seat up
or down.
Raises or lowers the
seat.
Adjusts the seat-back
angle f orward or
backward.
To change the lumbar support, move
the lever on the right side of the
seat-back forward or backward.
Keep moving the lever f orward or
backward until you f ind a suitable
position. Adjusting the Passenger’s Seat
Driver’s L umbar Support
Seats
86
——y

y
('
yy

To change the seat-back angle, pull
up on the lever on the outside of the
seat bottom.Your vehicle is equipped with head
restraints in all seating positions to
help protect you and your
passengers f rom whiplash and other
injuries.They are most ef f ective when you
adjust them so the back of the
occupant’s head rests against the
center of the restraint.
The f ront and rear head restraints
adjust f or height. You need both
hands to adjust the restraint. Do not
attempt to adjust it while driving. To
raise it, pull upward. To lower the
restraint, push the release button
and push the restraint down.See page f or important saf ety
inf ormation and a warning about how toproperly position the head restraints. 15
Head Restraints
Seats
Inst rument s and Cont rols
87
RELEASE BUTTON
——y

y
('
yy