2006 HONDA ACCORD COUPE ignition

In LO, the heater runs continuously.
It does not cycle with temperature
changes. In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat temperature drops.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly, because it draws
large amounts of current f rom the
battery.
If the engine is lef t idling f or an
extended period, do not use the
seat heaters, even on the LO
setting. It can weaken the battery,
causing hard starting.
Both front seats have seat heaters.
The passenger seat is only heated in
the seat bottom because of the side
airbag cutoff system. The ignition
switch must be in the ON (II)
position to use seat heaters. Push the
top of the switch, HI, to rapidly heat
up the seat. After the seat reaches a
comf ortable temperature, select LO
by pushing the bottom of the switch.
This will keep the seat warm.
On EX-L and EX-V6 models
Seat Heaters
90
SEAT
HEATER
SWITCH
——y
y
(%yy

µ
CONT INUED
Turn the ignition switch to the ON
(II) position to raise or lower either
window. To open the window, push
the switch down and hold it. Release
the switch when you want the
window to stop. Pull back on the
switchandholdittoclosethe
window.
Thewindowsoperateforupto10
minutes after you turn off the
ignition switch. Opening either door
cancels this f unction.If the MAIN switch is off, the
passenger’s windows cannot be
raised or lowered. Keep the MAIN
switch of f when you have children in
the vehicle so they do not injure
themselves by operating the
windows unintentionally. To open or close the
driver’s window, push or pull the
window switch firmly down or up to
the second detent, and release it.
The window will automatically go
down or up all the way. To stop the
window, pull or push the window
switch brief ly.
Power Windows
AUTO
Inst rument s and Cont rols
91
MAIN SWITCH
DRIVER’S WINDOW
SWITCH
Closing a power window on
someone’s hands or fingers can
cause serious injury.
Make sure your passengers are
away from the windows before
closing them.
——y
y
(%yy

The moonroof can be tilted up in the
back f or ventilation, or it can be slid
back into the roof. Use the switch
under the lef t dashboard vent to
operate the moonroof . You must
turn the ignition switch to the ON
(II) position f or the moonroof to
operate.The moonroof has a key-of f delay.
You can open and close the
moonroof f or up to 10 minutes af ter
you turn of f the ignition switch. The
key-of f delay cancels as soon as you
open either door.
To tilt up the back of the moonroof ,
press and hold the center part of the
switch ( ). To close the
moonroof , press and hold the upper
part of the switch ( ). To open
the moonroof , press and hold the
lower part of the switch ( ).
Release the switch when the
moonroof gets to the desired
position.
If equipped
Moonroof
94
MOONROOF SWITCH Close
Tilt MOONROOF SWITCH
Open
Opening or closing the
moonroof on someone’s hands
or fingers can cause serious
injury.
Make sure all hands and fingers
are clear of the moonroof
before opening or closing it.
If you try to open the moonroof in
below-f reezing temperatures, or when
it is covered with snow or ice, you can
damage the moonroof panel or motor.
——y

y
(%yy

Push or pull the adjustment knob
right, left, up, or down to move the
mirror.
When you f inish, turn the
adjustment knob to the center
(of f ) position. This turns of f the
adjustment knob to keep your
settings.
Turn the ignition switch to the ON
(II) position.
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position. Turn the adjustment knob to L
(driver’s side) or R (passenger’s
side).3.
4.
1.
2.
CONT INUED
Mirrors
A djusting the Power Mirrors
Inst rument s and Cont rols
95
ADJUSTMENT KNOB
TAB
——y
y
(%yy

The outside mirrors are heated to
remove fog and frost. With the
ignition switch in the ON (II)
position, turn on the heaters by
pressing the button. The indicator in
the button comes on as a reminder.
Press the button again to turn the
heaters off. To
apply the parking brake, pull the
lever up fully. To release it, pull up
slightly, push the button, and lower
the lever. The parking brake
indicator on the instrument panel
should go out when the parking
brake is f ully released (see page ).
If you drive without f ully releasing
the parking brake, the beeper
sounds continuously. 58
If equipped
Parking Brake
Mirrors, Parking Brake
96
PARKING BRAKE LEVER
HEATED MIRROR BUTTON
Driving the vehicle with the parking
brake applied can damage the rear
brakes and axle.
——y
y
(%yy

In this position, the sun visor can be
adjusted by moving it on its slider.
Make sure you put the sun visor
back in place when you are getting
into or out of the vehicle.Pull up the vanity mirror cover to use
it. The lights beside the mirror come
on when you pull up the cover.
These sockets are intended to supply
power f or 12 volt DC accessories
that are rated 120 watts or less (10
amps).
To use an accessory power socket,
the ignition switch must be in the
ACCESSORY (I) or ON (II) position.
None of the sockets will power an
automotive type cigarette lighter
element. When more than one
socket is being used, the combined
power rating of the accessories
should be 120 watts or less
(10 amps).
To use the sun visor, pull it down.
Whenusingthesunvisorforthe
side window, remove the support rod
f rom the clip, and swing it out.
Do not use the sun visor extension
over the inside mirror. Sun Visor Vanity Mirror
Interior Convenience Items
Inst rument s and Cont rols
101
SUN VISOR
——y

y
(%y
y

The f ront ceiling light has a two-
position switch; Door Activated and
OFF.In the Door Activated position both
ceiling lights, the light comes on
when you:
Open either door.
Unlock the driver’s door with the
master door lock switch, lock tab,
key, or the remote transmitter.
Remove the key from the ignition
switch.
Af ter both doors are closed tightly,
the light(s) dims slightly, then f ade
out in about 30 seconds.
If you do not open either door af ter
unlocking the driver’s door or
removing the key from the ignition
switch, the light(s) f ades out in
about 30 seconds.
If you leave either door open without
the key is in the ignition switch, the
ceiling light(s) will go of f af ter 3
minutes. Turn on a spotlight by pushing the
lens. Push the lens again to turn it
of f . You can use the spotlights at all
times.
On EX, EX-L, and EX-V6 models
Interior Lights
Spotlights
Inst rument s and Cont rols
103
DOOR
ACTIVATED
OFF LX and LX-V6 models
EX, EX-L, and EX-V6 models
——y

y
(%y
y

The courtesy light in each door
comes on when the door is opened,
and goes out when the door is closed.Your vehicle also has a courtesy light
in the ignition switch. This light
comesonwhenyou;
Open either door.
Unlock the driver’s door.
Remove the key from the ignition
switch.
This light f ades out about 30 seconds
af ter you close both doors.
The courtesy light between the
spotlights comes on when you turn
the parking lights on. To adjust its
brightness, turn the Select/Reset
knob on the instrument panel.On EX, EX-L, and EX-V6 models
Interior Lights
Courtesy Lights
104
IGNITION SWITCH LIGHT
DOOR LIGHT COURTESY LIGHT
——y
y
(%y
y