2006 DODGE SPRINTER weight

6 INTRODUCTION
Vehicle identification number (location: on the chassis,
right hand).VEHICLE SAFETY CERTIFICATION LABEL,
SAMPLE AND LOCATION
Location: below the driver’s seat on an outward facing
position of the mounting pillar.
Incomplete vehicle certification label for chassis/cab.
(1)
Certification Label (vehicle identification number,
permissible weights) (2)

STARTING AND OPERATING 143
5
…Winter tires . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 206
Q Snow Chains . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 207
Q Fuel Requirements . . . . . . . . . . . . . . . . . . . . . . . . . 209
…Fuel Filter with Water Separator . . . . . . . . . . . 210…Diesel Fuels for Use at Very
Low Temperatures . . . . . . . . . . . . . . . . . . . . . . . 211
Q Refueling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 212
…Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 213
Q Programmed Top Speed (Optional) . . . . . . . . . . 213
Q Bleeding Diesel Fuel System . . . . . . . . . . . . . . . . . 214
Q Draining Fuel Filter with Water Separator . . . . 214
…Bleeding the Diesel Fuel System . . . . . . . . . . . 216
Q Permissible Roof Load . . . . . . . . . . . . . . . . . . . . . . 216
Q Loading the Vehicle . . . . . . . . . . . . . . . . . . . . . . . . 216
…Tire and Loading Information . . . . . . . . . . . . . 217
Q Trailer Towing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 221
…Trailer Hitches (Optional) . . . . . . . . . . . . . . . . . 222
…Electrical Connections (Optional) . . . . . . . . . . 222
…Vehicle and Trailer Weights and Ratings . . . . 222
…Trailer Tongue Load . . . . . . . . . . . . . . . . . . . . . 223
…Loading a Trailer . . . . . . . . . . . . . . . . . . . . . . . . 223…Checking Weights of Vehicle and Trailer . . . . 224
…Attaching a Trailer . . . . . . . . . . . . . . . . . . . . . . . 224…Towing a Trailer . . . . . . . . . . . . . . . . . . . . . . . . . 225
…Parking a Trailer . . . . . . . . . . . . . . . . . . . . . . . . . 227
Q Emissions Control System
(Catalytic Converter) . . . . . . . . . . . . . . . . . . . . . . . 228
Q Inhalation of Exhaust Gas . . . . . . . . . . . . . . . . . . . 228
Q Fording (Wading Capability) . . . . . . . . . . . . . . . . 228
Q Body Builder Guideline . . . . . . . . . . . . . . . . . . . . . 229
…A Special Note Concerning
Vehicle Alteration . . . . . . . . . . . . . . . . . . . . . . . . 230

156 STARTING AND OPERATING
For all sensors, the minimum distance between sensor
and obstacle is 12 in (30 cm).
In the event of a malfunction, a continuous warning
signal sounds for approximately three seconds when
the vehicle is reversing
NOTE: Distance display
 "in" in USA only
 "cm" in Canada onlyLOADING THE VEHICLE
WARNING!
Do not overload the tires by exceeding the specified
vehicle capacity weight (as indicated by the label on
the base of the driver’s seat). Overloading the tires
can overheat them, possibly causing a blowout,
which could cause an accident and personal injury.
In addition, braking and stopping distances can be
significantly longer if the vehicle is overloaded.
WARNING!
Always close the sliding and rear doors when
driving.
Otherwise exhaust fumes could enter the vehicle
interior and poison you.

STARTING AND OPERATING 157
5
The handling characteristics of a vehicle when laden
are dependent on the type of load and the distribution
of the load within the vehicle.
Carrying heavy or bulky loads may alter the vehicle’s
handling characteristic.
Loading Guidelines
Please note and comply with the following information
when loading and transporting goods.
 Do not allow the load, including passengers, to
exceed the permitted gross vehicle weight or the
permitted axle loads for the vehicle. Bear in mind
that the unladen weight could be increased by
installing items of optional equipment and
accessories.
 Distribute the load uniformly. Excessive loads on
individual points of the load surface could cause
damage to the floor covering.
 Transport heavy loads between the axles near the
rear axle as low as possible in the vehicle.
 Secure any kind of load with sufficient wear and
tear-resistant load restraints. See tie-down rings.WARNING!
Unsecured or poorly secured loads, and seats that
have been removed, could move around the vehi-
cle interior uncontrollably in the event of sudden
braking, a rapid change in direction or an acci-
dent. This increases the risk of injury to occu-
pants in these situations.
Secure and position a load as described in the
following loading guidelines.
Piling up heavy objects or placing them on upper
shelves or loading them otherwise high up in the
vehicle will significantly raise the center of
gravity of the vehicle. Placing excessive loads on
individual points of the load surface or behind
the rear axle will also adversely affect the
handling characteristics of your vehicle and may
lead to loss of control over the vehicle.
Road safety and tire durability are adversely
affected if the permissible axle loads or gross
vehicle weight are exceeded due to the vehicle’s
load. Braking and stopping distances can be
significantly longer.

STARTING AND OPERATING 187
5
For more information, refer to "Important Notes on
Tire Inflation Pressure".
1 Recommended cold tire inflation pressures
NOTE: Data shown on placard are for illustration
purposes only. Tire data are specific to each vehicle
and may vary from data shown in the illustration.
Refer to placard on vehicle for actual data specific to
your vehicle.The Tire and Loading Information placard on the
driver’s door B-pillar lists the recommended cold tire
inflation pressures for all load conditions up to the
maximum permissible weight limits (GAWR). The tire
inflation pressures listed apply to the tires installed as
original equipment.
Important Notes on Tire Inflation Pressure
Tire temperature and tire inflation pressure are also
increased while driving, depending on the driving
speed and the tire load.
Tire inflation pressure changes by approximately 1.5
psi (10 kPa) per 18 °F (10 °C) of air temperature change.
WARNING!
If the tire inflation pressure drops repeatedly:
 Check the tires for punctures from foreign
objects.
 Check to see whether air is leaking from the
valves or from around the rim.

198 STARTING AND OPERATING
Maximum Tire Load
(1) Maximum tire load rating
NOTE: Data shown on tire are for illustration purposes
only. Actual data on tires are specific to each vehicle
and may vary from data shown in the illustration.The maximum tire load is the maximum weight the
tires are designed to support.
For more information on tire load rating, refer to "Tire
Size Designation, Load and Speed Rating".
For information on calculating total and cargo load
capacities, refer to "Tire and Loading Information".
WARNING!
Tires and spare tire should be replaced after 6
years, regardless of the remaining tread.
WARNING!
Do not overload the tires by exceeding the specified
load limit as indicated on the Tire and Loading
Information placard on the driver’s door B-pillar.
Overloading the tires can overheat them, possibly
causing a blowout.
Overloading the tires can also result in handling or
steering problems, or brake failure.

200 STARTING AND OPERATING
Tire Ply Material
(1) Plies in sidewall
(2) Plies under tread
NOTE: Data shown on tire are for illustration purposes
only. Actual data on tires are specific to each vehicle
and may vary from data shown in the illustration.
This marking tells you about the type of cord and
number of plies in the sidewall and under the tread.Tire and Loading Terminology
Accessory Weight
The combined weight (in excess of those standard
items which may be replaced) of automatic
transmission, power steering, power brakes, power
windows, radio, and heater, to the extent that these
items are available as factory-installed equipment
(whether installed or not).
Air Pressure
The amount of air inside the tire pressing outward on
each square inch of the tire. Air pressure is expressed
in pounds per square inch (psi), or kilopascal (kPa) or
bars.
Aspect Ratio
Dimensional relationship between tire section height
and section width expressed in percentage.
Bar
Another metric unit for air pressure. There are 14.5038
pounds per square inch (psi) to 1 bar; there are 100
kilopascals (kPa) to 1 bar.

STARTING AND OPERATING 201
5
Bead
The tire bead contains steel wires wrapped by steel
cords that hold the tire onto the rim.
Cold Tire Inflation Pressure
Tire inflation pressure when your vehicle has been
sitting for at least 3 hours or d r i v e n n o m o r e t h a n 1 m i l e
(1.6 km).
Curb Weight
The weight of a motor vehicle with standard
equipment including the maximum capacity of fuel,
oil, and coolant, and, if so equipped, air conditioning
and additional optional equipment, but without
passengers and cargo.
DOT (Department of Transportation)
A tire branding symbol which denotes the tire meets
requirements of the U.S. Department of
Transportation.
GAWR (Gross Axle Weight Rating)
The GAWR is the maximum permissible axle weight.
The gross vehicle weight on each axle must never
exceed the GAWR for the front and rear axle indicatedon the Certification Label located below the driver’s
seat on an outward facing position of the mounting
pillar.
GTW (Gross Trailer Weight)
The GTW is the weight of the trailer plus the weight of
all cargo, equipment, luggage etc. loaded on the trailer.
GVW (Gross Vehicle Weight)
The GVW comprises the weight of the vehicle
including fuel, tools, spare wheel, installed accessories,
passengers and cargo and, if applicable, trailer tongue
load. The GWV must never exceed the GWVR
indicated on the Certification Label located below the
driver’s seat on an outward facing position of the
mounting pillar.
GVWR (Gross Vehicle Weight Rating)
This is themaximum permissible vehicle weight of the
fully loaded vehicle (weight of the vehicle including all
options, passengers, fuel, and cargo and, if applicable,
trailer tongue load). It is indicated on the Certification
Label located below the driver’s seat on an outward
facing position of the mounting pillar.