Page 76 of 467

▫Exterior Mirrors Folding Feature...........86
▫Electronic Power Mirrors — If Equipped......87
▫Electric Rear Window Defroster And Heated
Sideview Mirrors — If Equipped...........88
▫Trailer Towing Mirrors — If Equipped.......88
Hands–Free Communication (UConnect™)
— If Equipped..........................90
▫Operation............................92
▫Phone Call Features....................98
▫UConnect™ System Features.............101
▫Advanced Phone Connectivity............105
▫Things You Should Know About Your
UConnect™ System....................107
Seats................................113▫40-20-40 Front Seat....................114
▫Reclining Seats.......................115
▫Adjustable Head Restraints..............115
▫Manual Rotary Lumbar Support Adjustment
— If Equipped.......................116
▫Power Seats — If Equipped..............117
▫Heated Seats — If Equipped.............118
To Open And Close The Hood.............119
Lights...............................121
▫Interior Lights.......................121
▫Battery Saver........................122
▫Headlamp Delay......................123
▫Headlights, Parking Lights, Panel Lights.....123
76 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 114 of 467
40-20-40 Front Seat
As the name implies, the seat is divided into 3 segments.
The outboard seat portions are each 40% of the total
width of the seat. The back of the center portion (20%)
easily folds down to provide an armrest/center storage
compartment (if equipped).Each outboard seat is independently adjustable forward
or backward and is equipped with a back recliner. The
manual seat adjustment handle is found at the front edge
of each seat cushion. Pull up on the handle and slide the
seat to get the most comfortable position.
WARNING!
Adjusting a seat while the vehicle is moving is
dangerous. The sudden movement of the seat could
cause you to lose control. The seat belt might not be
properly adjusted and you could be injured. Adjust
any seat only while the vehicle is parked.
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 116 of 467
To lower the head restraint, push in the button and then
push down on the head restraint.Manual Rotary Lumbar Support Adjustment — If
Equipped
Rotating the lumbar control knob on the left side of the
driver’s seatback and on the right side of the passenger’s
seatback increases or decreases the lumbar support.
Manual Lumbar Adjustment
116 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 118 of 467
control seat height. Change the seat angle by using the
two toggle switches, tilting it up or down.Heated Seats — If Equipped
The heated seat switches are located in the instrument
panel under the climate controls.
Each heated seat switch has two settings (HI and LOW).
Press the switch once to obtain High heat level, then
press the switch again to obtain Low heat level. Pressing
Tilt Adjustment
Heated Seat Switches
118 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Page 389 of 467

WARNING!
The warning words “DO NOT OPEN HOT” on the
radiator pressure cap are a safety precaution. Heat
causes pressure to build up in the cooling system. To
prevent scalding or injury, do not remove the pres-
sure cap.
Hoses And Vacuum/Vapor Harnesses
Inspect surfaces of hoses and nylon tubing for evidence
of heat and mechanical damage. Hard or soft spots,
brittle rubber, cracking, tears, cuts, abrasions, and exces-
sive swelling indicate deterioration of the rubber.
Pay particular attention to those hoses nearest to high
heat sources such as the exhaust manifold. Inspect hose
routing to be sure hoses do not come in contact with any
heat source or moving component which may cause heat
damage or mechanical wear.Insure nylon tubing in these areas has not melted or
collapsed.
Inspect all hose connections such as clamps and cou-
plings to make sure they are secure and no leaks are
present.
Components should be replaced immediately if there is
any evidence of wear or damage that could cause failure.
Brake System
Power Disc Brakes (front and rear)
Disc brakes do not require adjustment; however, several
hard stops during the break-in period are recommended
to seat the linings and wear off any foreign material.
Brake Master Cylinder
The fluid level of the master cylinder should be checked
when performing under the hood service, or immedi-
ately if the brake system warning lamp indicates system
failure.
MAINTAINING YOUR VEHICLE 389
7
Page 463 of 467

Seat Belts.......................... 33,34,72
Adjustable Upper Shoulder Anchorage........ 41
And Pregnant Women................... 45
Child Restraint....................... 57,69
Extender............................. 45
Front Seat............................ 34
Pretensioners.......................... 43
Reminder............................ 169
Seats.............................. 113,114
Adjustment.......................... 113
Child ............................... 69
FoldingFloor ......................... 156
Heated.............................. 118
Lumbar Support....................... 116
Power.............................. 117
Reclining ............................ 115
Security Alarm (Theft Alarm)............. 29,171
Selection of Coolant (Antifreeze)............. 418
Sentry Key............................. 13Service Assistance....................... 444
Service Contract......................... 446
Service Manuals........................ 448
Setting the Clock.....................176,196
Shift Speeds........................... 286
Shifting ............................... 280
Automatic Transmission................. 280
Manual Transmission................... 285
Transfer Case......................... 289
Transfer Case, Shifting into Transfer
Case Neutral (N)..................... 342
Transfer Case, Shifting out of Transfer
Case Neutral (N)..................... 343
Shoulder Belt Upper Anchorage.............. 41
Shoulder Belts........................... 34
Side Airbag............................. 54
Signals, Turn........................... 125
SkidPlates ............................. 82
Snow Chains (Tire Chains)................. 314
INDEX 463
10