2006 DODGE DAKOTA clock

the windshield, and the demister outlets located at the
edge of each side of the instrument panel.
Blower Control
The rotary knob on the left of
the control panel is the
blower control. Turn the knob
clockwise to one of the four
positions to obtain the blower
speed you desire. To turn the
blower off, turn the knob to
the far left position.
Temperature Control
The rotary knob at the center
of the control panel controls
the temperature of the inte-
rior air. You can choose your
degree of comfort by rotating
the knob. The coldest tem-
perature setting is to the ex-
treme left (blue region) and
the warmest setting is to the
extreme right (red region) of
the rotation.
Circulation
The cab is designed with features to promote outside air
circulation. There are grilles in the cab back panel. These
are air exhausters that provide the means for regular
exchange of cab air.
INSTRUMENT PANEL AND CONTROLS 191
4

WARNING!
The jack is designed as a tool for changing tires only.
The jack should not be used to lift the vehicle for
service purposes, unless suitable supports are placed
under the vehicle as a safety measure. The vehicle
should be jacked on a firm level surface only. Avoid
ice or slippery areas.
Removing The Spare Tire
Remove the spare tire before attempting to jack the truck.
Attach the wheel wrench to the jack extension tube. Insert
the tube through the access hole in the rear bumper and
into the winch mechanism tube. Rotate the wheel wrench
handle counterclockwise until the spare tire is on the
ground with enough cable slack to allow you to pull it
out from under the vehicle. When the spare is clear, tilt
the retainer at the end of the cable and pull it through the
center of the wheel. Steps for Removing the Spare Tire
•Remove the jack from the stowage compartment using
the supplied finger assist tool.
•Remove the finger assist tool from jack and set aside
until jack is stowed.
•Assemble the jack tools.
•Locate the tire carrier access hole on the rear bumper.
•Place assembled jack tool extension rod into the access
hole in the direction of the arrow on the bumper trim.
•Rotate the tool counterclockwise to release and lower
the spare tire to the ground so that it can be pulled
from under the vehicle.
•Rotate clockwise to stow the spare tire.
286 WHAT TO DO IN EMERGENCIES

Preparations
Park the vehicle on a firm level surface, avoiding ice or
slippery areas. Set the parking brake and place the gear
selector in PARK (automatic transmission). On Four
Wheel Drive vehicles, shift the transfer case to the “4L”
position.
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off
the road to avoid the danger of being hit when
operating the jack or changing the wheel.
•Turn on the Hazard Warning Flasher.
•Block both the front and rear
of the wheel diagonally oppo-
site the jacking position. For
example, if the right front
wheel is being changed, block
the left rear wheel.
•Passengers should not remain in the vehicle when the
vehicle is being jacked.
Instructions
1. Lower and remove the spare wheel, jack, and tools
from stowage.
2. Using the wheel wrench, loosen, but do not remove,
the wheel nuts by turning them counterclockwise one
turn while the wheel is still on the ground.
3. When changing a front wheel, place the jack under the
frame rail behind the wheel. Locate the jack as far
forward as possible on the straight part of the frame prior
WHAT TO DO IN EMERGENCIES 289
6

Before raising the wheel off the ground, make sure that
the jack will not damage surrounding truck parts and
adjust the jack position as required.
4. By rotating the wheel wrench clockwise, raise the
vehicle until the wheel just clears the surface.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle unstable and cause an accident. It could
slip off the jack and hurt someone near it. Raise the
vehicle only enough to remove the tire.
5. Remove the wheel nuts and pull the wheel off. Install
the spare wheel and wheel nuts with the cone shaped end
of the nuts toward the wheel. Lightly tighten the nuts. To
avoid risk of forcing the vehicle off the jack, do not fully
tighten the nuts until the vehicle has been lowered.
NOTE: Do not oil wheel studs. For chrome wheels, do
not substitute with chrome plated wheel nuts.
6. Using the wheel wrench, finish tightening the nuts in
a crisscross pattern. If in doubt about the correct tight-
ness, have them checked with a torque wrench by your
dealer or at a service station.
Right Rear Jacking Location
WHAT TO DO IN EMERGENCIES 291
6

6. Reverse procedure for installation of bulbs and hous-
ing.
License Lamps
1. Using a screw driver pry black rubber housing from
the bumper. 2. Rotate the socket 1/4 turn counterclockwise.
Removing Housing From Bumper
Rotating Socket
MAINTAINING YOUR VEHICLE 353
7

3. Pull bulb from socket.
4. Reverse procedure for installation.Fog Lamps
1. Disconnect connector from fog lamp by raising wire
harness lock tab and pulling on wire harness connector.
2. Rotate fog lamp bulb 1/4 turn counterclockwise and
pull to remove from fog lamp housing.
3. Reverse Procedure to install.
Pulling Bulb From Socket
354 MAINTAINING YOUR VEHICLE

Center High Mounted Stop Light............ 350
Center Seat Storage Compartment ............ 143
Certification Label ....................... 258
Changing A Flat Tire ..................... 284
Charging .............................. 293
Chart, Tire Sizing ........................ 231
Child Restraint ........................ 57,59
Child Restraint Tether Anchors .............60,65
Child Restraint with Automatic Belts ........... 37
Child Seat .............................. 62
Circuit Breakers ......................... 337
Climate Control ......................... 189
Clock ........................... 159,162,170
Compact Disc (CD) Maintenance ............. 188
Compact Spare Tire ...................... 242
Compass .............................. 129
Compass Calibration ..................... 129
Compass Variance ....................... 130
Computer, Trip/Travel .................... 126 Console, Floor
.......................... 142
Console, Overhead ....................... 125
Contract, Service ........................ 384
Converter, Catalytic ...................... 256
Coolant (Antifreeze) ...................... 324
Coolant Pressure Cap ..................... 323
Cooling System ......................... 320
Adding Coolant (Antifreeze) .............. 323
Coolant Capacity ...................... 355
Coolant Level ......................... 324
Disposal of Used Coolant ................ 321
Drain, Flush, and Refill .................. 321
Inspection ........................... 320
Points to Remember .................... 324
Radiator Cap ......................... 323
Selection of Coolant (Antifreeze) ......322,355,356
Temperature Gauge ..................... 152
Cruise Control (Speed Control) .............. 121
Cup Holder ............................ 144
392 INDEX

And Pregnant Women................... 39
Child Restraint ....................... 57,59
Extender ............................. 39
Front Seat ............................ 31
Inspection ............................ 72
Pretensioners .......................... 37
Reminder ............................ 153
Seats ................................. 105
Adjustment .......................... 105
Heated .............................. 110
Lumbar Support ....................... 107
Reclining ............................ 106
Security Alarm (Theft Alarm) .............26,154
Selection of Coolant (Antifreeze) ............. 356
Selection of Oil ......................... 310
Sentry Key (Immobilizer) ................... 10
Sentry Key Programming ................... 12
Service and Maintenance .............307,360,361
Service Assistance ....................... 382 Service Contract
......................... 384
Service Manuals ........................ 386
Setting the Clock .................. 160,162,170
Shift Speeds ........................... 210
Shifting Automatic Transmission ................. 204
Manual Transmission ................... 209
Transfer Case ......................... 211
Transfer Case, Shifting into Transfer Case Neutral (N) ..................... 274
Transfer Case, Shifting out of Transfer Case Neutral (N) ..................... 276
Shoulder Belt Upper Anchorage .............. 36
Shoulder Belts ........................... 31
Signals, Turn ..................... 1 17,152,348
Snow Chains (Tire Chains) ................. 247
Snow Plow ............................ 272
Snow Tires ............................ 249
Spare Tire ....................... 242,243,286
402 INDEX