2006 CHRYSLER PT CRUISER battery

[x] Cancel search: battery

Page 194 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual Programming The Universal Transceiver
For best results, install a new battery in the hand held
transmitter before programming. If your garage door
opener (located in the garage) is equipped with an
an

Page 201 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual WARNING!
In an accident, there is a greater risk of being thrown
from a vehicle with an open sunroof. You could also
be seriously injured or killed. Always fasten your
seat belt properly and make sure

Page 203 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual This outlet is powered directly by the battery, regardless
of the ignition switch position. All accessories connected
to this outlet should be removed or turned off when the
vehicle is not in use, to

Page 204 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual Electrical Outlet Use With Engine Off
CAUTION!
•Many accessories that can be plugged in draw
power from the vehicle’s battery, even when not
in use (i.e. cellular phones, etc.). Eventually, if
plu

Page 205 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual CAUTION!
•Many accessories that can be plugged into the 12
volt power outlet, draw power from the vehicle’s
battery, even when not in use; i.e. cellular phones,
etc. Eventually, if plugged in long

Page 207 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual CAUTION!
•Many accessories that can be plugged in draw
power from the vehicle’s battery, even when not
in use (i.e. cellular phones, etc.). Eventually, if
plugged in long enough, the vehicle’s b

Page 230 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual •Left Rear Turn Signal Lamp Out (with a single chime)
•Right Front Turn Signal Lamp Out (with a single
chime)
•Right Rear Turn Signal Lamp Out (with a single
chime)
•RKE Battery Low (with a si

Page 281 of 464

CHRYSLER PT CRUISER 2006 1.G Owners Manual started within 3 seconds, slightly depress the accelerator
pedal while continuing to crank. If the engine fails to start
within 15 seconds, turn the ignition switch to the “OFF”
position, wait 10