Page 144 of 532
Cargo Panel Storage System
The three cargo panels can be stored in the cargo area
using the storage strap system. To store the panels,
do the following:1. Secure the storage
strap system in the
cargo storage area by
attaching the six clips
included on the cargo
strap system to the tie
down locations on
either side of the
storage area.
Always use the storage strap system to store the
cargo panels during driving.
Before storing the cargo panels, be sure that the
latches are in the locked position. The latches are in
the locked position when they are parallel to the
front and back edge of the panel.
2-68
Page 148 of 532
7. Close both cross locks at the center of the strap
system to secure tightly.
Panels 3, 2, 1 Loaded
2-72
Page 149 of 532
Reinstalling the Cargo Cover Panels
To reinstall a cargo panel do the following.
1. Remove the cargo panel(s) from the storage strap
system.
You can either leave the strap system attached to the
side of the cargo area while it is not in use, or you
can store it inside the top box compartment. See
Top-Box Storage on page 2-82for more information.
2. Starting with cargo panel 1, place the latches in the
unlocked position. Place cargo panel 1 on the cargo
area rails while holding the back of the cargo
panel up.Push the panel forward until it is snug against the
midgate and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-73
Page 150 of 532
3. Push both left latches away from you to lock the
latches. Remember that there are two latches on
each side for panel 1. You should hear a click when
each latch locks. Lock the remaining two right
latches on panel 1.
For any cargo cover panel you must lock the left
latch in place before you can lock the right latch. If
you do not follow this exactly, the cargo cover
panels may not lock in place correctly.4. Install cargo cover 2 next. Place the latches in the
unlocked position. Place the cargo cover panel on
the cargo area rails while holding the back of
the cargo panel up.
Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-74
Page 151 of 532
5. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks correctly.
6. Install cargo cover 3 next. Place the latches in the
unlocked position. Place the cargo cover panel on
the cargo area rails while holding the back of
the cargo panel up.Push the panel forward until it is snug against the
other panel and then let the back of the panel down
being sure that the pegs align with the receivers.
Left Side Shown, Right Side Similar
2-75
Page 152 of 532
7. Push the latches away from you, starting with the
left latch, to lock the panel in place. You should
hear a click when each latch locks.
Folding and Storage of Straps
To store the folding straps do the following:
1. Extend the six strap ends on a at surface.
2. Fold the four strap ends towards the center as
shown.
2-76
Page 155 of 532
Maintenance and Cleaning
To ensure that the water management system performs
properly, be sure that the midgate, tailgate, and cover
system are fully closed and that each part of the
water management system is clean and not blocked
with debris. Follow the instruction given next in
this section for the proper procedures on cleaning each
part of the water management system.
Top Drain Grates – Removal and
Cleaning
The top drain grates are located near the rear glass on
both sides of the vehicle. You may need to clean the
grates and drains if there seems to be a blockage.To remove each drain grate, do the following:
1. Remove the cargo panels or tonneau cover. See
Cargo Cover Panels on page 2-65orTonneau
Cover on page 2-83for more information.
2. Grasp the edges of the grate and pull it out from
the vehicle. Flush the drain with clean water.
2-79
Page 158 of 532