2006 CADILLAC XLR V seat adjustment

Front Seats
Power Seats
The power seat controls
are located on the outboard
sides of both the driver’s
and the passenger’s seats.
Move the front of the horizontal control up or down
to adjust the front portion of the cushion.
Move the rear of the horizontal control up or down
to adjust the rear portion of the cushion.
Slide the control forward or rearward to move the
entire seat forward or rearward.
Use the vertical control to recline the seatback.
SeePower Reclining Seatback on page 1-3.
Power Lumbar
The driver’s and
passenger’s seatback
lumbar support switches
are located on the
outboard sides of
the seats.
Use the power seat controls rst to get the proper
position, then continue with the lumbar adjustment.
Use the top lumbar switch to adjust support to the
middle seatback and the bottom lumbar switch to adjust
support to the lower seatback. Press the front of the
switch to increase support and the rear of the switch
to decrease support.
Keep in mind that as your seating position changes,
as it may during long trips, so should the position of
your lumbar support. Adjust the seat as needed.
1-2

Outside Curb View Assist Mirror
The passenger’s side mirror is also capable of
performing the curb view assist feature. This feature
will cause the mirror to tilt to a factory programmed
position when the vehicle is in REVERSE (R).
This feature may be useful in allowing you to view
the curb when you are parallel parking.
If further adjustment is needed after the mirror is tilted,
the mirror switch may be used. The mirror will then
return to this new position when the vehicle is shifted
into REVERSE (R).
When the vehicle is shifted out of REVERSE (R) and
a ve-second delay has occurred, the passenger’s
side mirror will return to its original position.
This feature can be enabled/disabled through the
Driver Information Center (DIC). See “Park Assist”
underDIC Vehicle Personalization on page 3-78
for more information.
Outside Convex Mirror
{CAUTION:
A convex mirror can make things (like other
vehicles) look farther away than they really are.
If you cut too sharply into the right lane, you
could hit a vehicle on your right. Check your
inside mirror or glance over your shoulder
before changing lanes.
The passenger’s side mirror is convex. A convex
mirror’s surface is curved so more can be seen from
the driver’s seat. It also makes things look farther away
than they really are.
2-37

((Heated/Cooled Seat):Press this button to turn the
feature on. The button on the left controls the driver’s
seat and the button on the right controls the passenger’s
seat. Each press of the button will take you to a
different setting. The settings available in order are
HI HEAT, LO HEAT, OFF, HI COOL, LO COOL
and OFF. You will be able to feel the temperature
change in a few minutes.
The feature will automatically turn off when the vehicle
is turned off.
?(Recirculation):Press this button to turn the
recirculation mode on or off. The air-conditioning
compressor also comes on. This mode keeps outside
air from coming in the vehicle. It can be used to prevent
outside air and odors from entering your vehicle or to
help cool the air inside your vehicle more quickly.
Recirculation is not available in defrost or oor/defog
modes.
Using recirculation for long periods of time may cause
the air inside your vehicle to become too dry. To prevent
this from happening, after the air in your vehicle has
cooled, turn the recirculation mode off.
Sensors
There are sensors to measure the temperature and
sun’s effect on passenger comfort.
The solar sensor on your vehicle monitors the solar
radiation then uses the information to maintain the
selected temperature when operating in AUTO mode by
initiating needed adjustments to the temperature, the
fan speed and the air delivery system. The system may
also supply cooler air to the side of the vehicle facing
the sun. The recirculation mode will also be activated, as
necessary. Do not cover the solar sensor located on
the top of the instrument panel near the windshield
or the system will not work properly.
There is also a sensor located behind the front bumper.
This sensor reads the outside air temperature and
helps maintain the temperature inside the vehicle.
The outside temperature will be displayed in the
navigation system only when the engine is running.
Any cover on the front of the vehicle could give a false
reading of the temperature.
3-44

Outlet Adjustment
Use the thumbwheel to open or close the outlets.
Operation Tips

Clear away any ice, snow or leaves from the air
inlets at the base of the windshield that may
block the ow of air into your vehicle.
Use of non-GM approved hood deectors may
adversely affect the performance of the system.
Keep the area around the base of the instrument
panel console and air path under the seats clear
of objects to help circulate the air inside of
your vehicle more effectively.
Passenger Compartment Air Filter
The passenger compartment air lter removes certain
odor and particles from the air including pollen and dust
particles. Reductions in airow, which may occur more
often in dusty areas, indicate that the lter may need to
be replaced early.
The lter should be replaced as part of the routine
scheduled maintenance. SeeScheduled Maintenance
on page 7-4for more information.
To check or replace the air lter, do the following:
1. With the hood open, unlatch and remove the
access panel.
The passenger compartment air lter and access
panel are located on the passenger’s side of
the engine compartment near the battery.
SeeEngine Compartment Overview on page 6-12
for more information on location.
2. Pull the old lter out of the housing.
3. Insert the new lter into the housing. The lter should
be fully inserted with the arrows pointing up.
4. Reinstall the air lter access panel.
3-47

Headlamp Aiming
Your vehicle has a visual optical headlamp aiming
system equipped with horizontal aim indicators.
The aim has been preset at the factory and should need
no further adjustment. This is true even though your
horizontal aim indicators may not fall exactly on the
“0” (zero) marks on their scales.
If your vehicle is damaged in an accident, the headlamp
aim may be affected. Aim adjustment to the low beam
may be necessary if it is difficult to see lane markers
(for horizontal aim), or if oncoming drivers ash
their high beams at you (for vertical aim). If you believe
your headlamps need to be re-aimed, we recommend
that you take your vehicle to your dealer for service.
However, it is possible for you to re-aim your headlamps
as described in the following procedure.Notice:To make sure your headlamps are aimed
properly, read all the instructions before beginning.
Failure to follow these instructions could cause
damage to headlamp parts.
The vehicle should be properly prepared as follows:
The vehicle should be placed so the headlamps are
25 ft. (7.6 m) from a light colored wall or other at
surface.
The vehicle must have all four tires on a perfectly
level surface which is level all the way to the wall
or other at surface.
The vehicle should be placed so it is perpendicular
to the wall or other at surface.
The vehicle should not have any snow, ice or mud
attached to it.
The vehicle should be fully assembled and all other
work stopped while headlamp aiming is being done.
The vehicle should be normally loaded with a
full tank of fuel and one person or 160 lbs (75 kg)
on the driver’s seat.
Tires should be properly inated.
Start the vehicle and rock it to level the suspension.
6-45

The vehicle should be fully assembled and all other
work stopped while headlamp aiming is being
performed.
The vehicle should be normally loaded with a full
tank of fuel and one person or 160 lbs (75 kg)
sitting on the driver’s seat.
Tires should be properly inated.
The spare tire is in its proper location in the vehicle.
Headlamp aiming is done with the vehicle’s low-beam
headlamps. The high-beam headlamps will be correctly
aimed if the low-beam headlamps are aimed properly.
To adjust the vertical aim, do the following:
Notice:Horizontal aiming must be performed
before making any adjustments to the vertical aim.
Adjusting the vertical aim rst will result in an
incorrect headlamp aim.
1. Open the hood. SeeHood Release on page 6-11
for more information.
2. Locate the aim dot on the lens of the low-beam
headlamp.
3. Measure the distance from the ground to the aim
dot on each low-beam headlamp. Record this
distance.4. At the wall or other at surface, measure from the
ground upward (A) to the recorded distance from
Step 3 and mark it.
Notice:Do not cover a headlamp to improve beam
cut-off when aiming. Covering a headlamp may
cause excessive heat build-up which may cause
damage to the headlamp.
5. Draw or tape a horizontal line (B) on the wall or
at surface the width of the vehicle at the height
of the mark in Step 4.
6. Turn on the low-beam headlamps and place a
piece of cardboard or equivalent in front of the
headlamp not being aimed. This should allow
only the beam of light from the headlamp being
aimed to be seen on the at surface.
6-47

Cigarette Lighter.............................................3-41
Cleaning
Aluminum or Chrome-Plated Wheels..............6-82
Exterior Lamps/Lenses.................................6-81
Fabric/Carpet..............................................6-78
Finish Care.................................................6-81
Inside of Your Vehicle..................................6-76
Instrument Panel, Vinyl, and Other
Plastic Surfaces.......................................6-79
Leather......................................................6-79
Speaker Covers..........................................6-79
Tires..........................................................6-83
Underbody Maintenance...............................6-83
Washing Your Vehicle...................................6-80
Weatherstrips..............................................6-80
Windshield and Wiper Blades........................6-81
Wood Panels..............................................6-79
Climate Control System
Air Filter, Passenger Compartment.................3-47
Dual ..........................................................3-41
Outlet Adjustment........................................3-47
Collision Damage Repair..................................8-10
Competitive Driving, Racing or Other.................5-18
Control of a Vehicle.......................................... 5-6
Convenience Net............................................2-46Coolant
Engine Temperature Gage............................3-57
Heater, Engine............................................2-24
Surge Tank Pressure Cap.............................6-25
Cooled Seats................................................... 1-3
Cooling System..............................................6-28
Courtesy Lamps.............................................3-33
Cruise Control................................................3-12
Cruise Control, Adaptive..................................3-15
Cupholder(s)..................................................2-45
Customer Assistance Information
Courtesy Transportation.................................. 8-7
Customer Assistance for Text
Telephone (TTY) Users............................... 8-4
Customer Assistance Offices........................... 8-4
Customer Satisfaction Procedure..................... 8-2
GM Mobility Reimbursement Program............... 8-5
Reporting Safety Defects to
General Motors........................................8-14
Reporting Safety Defects to the
Canadian Government..............................8-14
Reporting Safety Defects to the
United States Government.........................8-13
Roadside Service.......................................... 8-6
Service Publications Ordering Information........8-14
3

O
Odometer......................................................3-50
Odometer, Trip...............................................3-50
Off-Road Recovery..........................................5-15
Oil
Engine.......................................................6-15
Engine Oil Pressure Gage............................3-61
Life Indicator...............................................3-82
Oil, Engine Oil Life System..............................6-18
Older Children, Restraints................................1-18
Online Owner Center........................................ 8-3
OnStar
®System.............................................4-47
OnStar®System, see OnStar®Manual...............2-38
Ordering
Map DVDs .................................................4-50
Other Warning Devices...................................... 3-6
Outlet Adjustment............................................3-47
Outlet(s), Accessory Power...............................3-40
Outside
Automatic Dimming Mirror.............................2-36
Convex Mirror.............................................2-37
Curb View Assist Mirror................................2-37
Power Heated Mirrors..................................2-36
Overheated Engine Protection Operating Mode.....6-27
Owner Checks and Services.............................. 7-8
Owners, Canadian............................................... ii
P
Paint, Damage...............................................6-83
Park Aid........................................................3-38
Park (P)
Shifting Into................................................2-30
Shifting Out of............................................2-32
Parking
Assist........................................................3-38
Brake........................................................2-29
Over Things That Burn.................................2-33
Passenger Airbag Status Indicator.....................3-52
Passenger Compartment Air Filter.....................3-47
Passenger Position, Safety Belts.......................1-17
Passenger Sensing System..............................1-40
Passing.........................................................5-16
Plan Route....................................................4-18
Power
Accessory Outlet(s)......................................3-40
Door Locks.................................................2-11
Electrical System.........................................6-86
Lumbar Controls........................................... 1-2
Reclining Seatback........................................ 1-3
Retained Accessory (RAP)............................2-22
Seat............................................................ 1-2
Steering Fluid.............................................6-33
Tilt Wheel and Telescopic Steering Column....... 3-6
Windows....................................................2-16
9