2006 BMW MOTORRAD K 1200 GT sensor

ably an authorised BMW Mo-
torrad dealer.Roll the rear wheel into po-
sition at the rear-wheel ad-
apter.
Seat the rear wheel on the
rear-wheel adapter.
Install wheel studs 5and
tighten to the specified
torque in diagonally
opposite sequence. Rear wheel to wheel
flange
Tightening sequence:
Tighten in diagonally op-
posite sequence
60 Nm
Turn the end silencer to its
initial position.
Install screw 4for the
bracket of the end silencer
in the rear footrest, but do
not tighten it at this point. Align clamp
3on the end
silencer with mark A(arrow)
on oxygen sensor B.
Tighten clamp 3on the end
silencer to the specified
tightening torque.
Silencer to manifold
35 Nm
7116zMaintenance

front wheel with the BMW
Motorrad front-wheel stand.Fit the front-wheel standPlace the motorcycle on
centre stand ( 83)
Slacken adjusting screws1.
Push the two pins 2apart
until the front suspension
fits between them.
Use locating pins 3to set
the front wheel stand to the
desired height.
Centre the front wheel stand
relative to the front wheel and push it against the front
axle.
Push both mounting pins
2
through the triangles of the
brake caliper anchorages
just far enough to allow
the front wheel to be rolled
between them.
There is a risk of dam-
aging the ABS sensor
ring of the BMW Integral ABS.
Push the pin in just far
enough to ensure that it
clears the sensor ring of the
BMW Integral ABS. Tighten adjusting screws
1.
If the motorcycle is
raised too far the centre
stand will lift clear of the
ground and the motorcycle
could topple to one side.
When raising the motorcycle,
make sure that the centre
stand remains on the
ground.
Apply uniform pressure to
push the front wheel stand
down and raise the motor-
cycle.
7118zMaintenance

H
Handlebar fittingsGeneral view, left side, 16
General view, right side, 17
Handlebars Adjusting, 59
Hazard warning flashers, 16, 17
Switching off, 46
Switching on, 45
Headlight Adjusting headlight beam
throw, 61
High-beam headlight, 19
Low-beam headlight, 19
Side lights, 19
Helmet holder, 15, 68
High-beam headlight, 16 Telltale light, 23
Horn, 16
I
Idle Telltale light, 23 Ignition
Switching off, 43
Switching on, 43
Immobiliser Warning, 27
Instrument cluster Overview, 18
Sensor for lighting, 18
J
Jump start, 127
L
Laying up, 136
Lights Switch on the high-beam
headlight, 60
Switching off parking
lights, 61
Switching on parking
lights, 60
Switching on the low-beam
headlight, 60
Switching on the side
lights, 60 M
Maintenance
General instructions, 102
Intervals, 155
Multifunction display, 18 Adjust the dimmer, 47
Overview, 22
O
Odometer and tripmeters Odometer, 46
Resetting tripmeter, 47
Select the tripmeter, 46
On-board computer, 17 Oil level, 52
Range, 50
Reset average consump-
tion, 52
Resetting average
speed, 51
Selecting readings, 49
P
Parking, 82
Power socket, 11, 94
Pre-ride check, 79
11166zIndex