2006 Alfa Romeo 166 warning light

112
AIMING LOW BEAM
HEADLAMPS FOR
LEFT/RIGHT CIRCULATION
(only for versions with gas discharge
headlamps)
On cars fitted with gas discharge head-
lamps (xenon bulbs)(optional for ver-
sions/markets where applicable) with
high lighting power, when passing from a
country with right circulation to one with
left circulation or vice versa it is necessary
to change the aiming of the low beams,
to optimise lighting of the edge of the
road and avoid glaring vehicles met.
IMPORTANT Contact Alfa Romeo Au-
thorised Services to have low beam head-
lamps correctly adjusted.
BEAM AIMING
(excluding versions with gas discharge
headlights)
The adjustment of the headlights is vital
to your safety and comfort and to that of
other road users.
The adjustment of the headlights is also
governed by precise regulations.
Contact Alfa Romeo Authorized Services
to have the headlights correctly adjusted.
When returning to the
country of origin, re-
member to change the low beam
aiming again.
WARNING
To have the position
checked and if neces-
sary adjusted, contact
Alfa Romeo Authorized Services.
ADJUSTING THE FRONT
FOGLIGHTS
(fig. 143)
To adjust the height of the beam of the
front foglight adjust screw (A).
fig. 143
A0D0034m

113
EOBD SYSTEM
(optional for versions/
markets where applicable
)
The EOBD system (European On Board
Diagnosis) allows continuous diagnosis of
the components of the car correlated with
emissions.
This system continuously monitors the
components of the vehicle related to e-
missions; it also indicates, when the
Uwarning light comes on on the instrument
panel, that the components in question
are in poor condition.
IMPORTANTAfter the problem has
been resolved, to completely check the
system, the Alfa Romeo Authorized Ser-
vice Station must carry out tests on a test
bench and, if necessary, road tests that
could be long.If, when the ignition key
is turned to MAR, the
Uwarning light does
not come on or if, when driving, it
lights up and emits a fixed light
or a flashing one, contact an Alfa
Romeo Authorized Service Station
as soon as possible. Warning
light
Uoperation can be checked
by means of special equipment
by traffic agents. Always comply
with the traffic regulations in
force in the country where you
are travelling.
The objective is the following:
– to keep under control the efficiency of
the system;
– to warn when a fault causes emission
levels to increase;
– to indicate the need to replace the
deteriorated components.
The system also has a diagnostic con-
nector that can be interfaced with appro-
priate tools, which makes it possible to
read the error codes stored in the control
unit, together with a series of specific pa-
rameters for engine operation and diag-
nosis. This check can also be carried out
by the traffic police.

114 ABS
The car is fitted with an ABS system
which prevents wheel lock when braking,
better exploits wheel grip and keeps the
vehicle controllable within the limits of
the available grip also during emergency
braking.
The driver can feel that the ABS is oper-
ational by a light pulsing of the brake
pedal, accompanied by noise.
This should not be interpreted as malfunc-
tioning of the brakes, but it is the signal to
the driver that the ABS system is working:
it is the warning that the car is travelling at
the limit of grip and that it is therefore nec-
essary to adapt the speed to the type of
road on which you are travelling.
The ABS system is an additional part of
the basic braking system; in the event of
a fault it is disabled, leaving the braking
system in the same conditions as a car
without ABS.In the event of a failure, though being
unable to rely on the antilock effect,
there is absolutely no adverse effect on
vehicle braking performance in terms of
braking capacity.
If you have never used a car with ABS
before, you are advised to learn how to
use it with a few preliminary trials on a
slippery surface, naturally under safety
conditions and fully adhering to the High-
way Code of the country concerned. You
are also advised to carefully read the fol-
lowing information.
The advantage of the ABS compared
with the conventional system is that it
makes it possible to maintain maximum
vehicle handling performance also in the
case of hard braking under grip limit con-
ditions, avoiding wheel lock.
Do not however expect the braking dis-
tance always to be reduced with the ABS
system: for example, on soft surfaces
such as gravel or fresh snow on slippery
surfaces, the distance might increase.In order to be able to exploit as far as
possible the possibility of the antilock
system in the case of need, it is wise to
follow a few pieces of advice.
The ABS exploits the
available grip in full, but
it cannot increase it; therefore cau-
tion is required on slippery surfac-
es, without running un-necessary
risks.
WARNING

115
Braking on corners always requires the
utmost caution, even with the help of the
ABS.
The most important piece of advice
however, is the following:WARNINGCars fitted with ABS must
only be fitted with wheel rims, tyres and
brake linings of the type and brand ap-
proved by the Manufacturer.
The braking system is completed by the
EBD (Electronic Brake Distributor) which
distributes the braking action through the
ABS control unit and sensors.
Following these instructions you will be
in a condition to obtain peak braking per-
formance at all times.
If the ABS cuts in, it
means that the grip limit
between the tyres and the road
surface has been reached: it is nec-
essary to slow down and adapt
driving to the grip available.
WARNING
In the event of a system
fault, with lighting up of
the
>warning light, have the ve-
hicle checked immediately by Au-
thorized Alfa Romeo Services, driv-
ing slowly to be able to regain full
system performance.
WARNING
When the ABS cuts in and
you feel the pedal pulse,
do not reduce the pressure, but
keep the brake pedal firmly
pressed with no fear; this way you
will stop in the shortest space pos-
sible, compatibly with the condi-
tions of the road surface.
WARNING
The car is fitted with an
electronic brake distrib-
utor (EBD). If the
>andxwarn-
ing lights come on at the same time
when the engine is running, there
is an EBD system fault; in this case,
violent braking may lock the rear
wheels too early, with the possibil-
ity of skidding. Drive extremely
carefully to the nearest Authorized
Alfa Romeo Services to have the
system checked over.
WARNING

116
BRAKE ASSIST (Brake assist in
an emergency)
This system, that cannot be cut out, rec-
ognizes emergency braking on the
ground of the brake pedal operation
speed and allows to speed up the braking
action.
On versions fitted with VDC system,
Brake Assist is deactivated in the event of
VDC system failure (indicated by the
switching on of the relevant warning
light).
The turning on of the>
warning light with the
engine running normally indicates
an ABS system fault. In this case
the braking system preserves its
effectiveness, without however
making use of the antilock device.
Under these circumstances, the EBD
system may fail to give top perfor-
mance. In this case, too, you are
recommended to contact Author-
ized Alfa Romeo Services immedi-
ately driving in such a way as to
avoid abrupt braking, to have the
system checked.
WARNING
If the xlow brake fluid
level warning light comes
on, stop the car immediately and
contact the nearest Authorized Al-
fa Romeo Services. Indeed, any
leak of fluid from the hydraulic
system compromises the effective-
ness of both the conventional
brake system and the system with
antilock system.
WARNING

120
TURNING ON THE ASR
FUNCTION
The ASR function turns on automatically
each time the engine is started.
When travelling it is possible to switch the
system off and on again pressing the switch
(A-fig. 144) on the centre console.
The warning light (B-fig. 144) on the
switch turns on to indicate that the sys-
tem is off.If the function is turned off while travel-
ling, it will turn on again automatically
the next time the engine is started.
IMPORTANTWhen driving on snow,
with snow chains fitted, if may be helpful
to switch off the ASR function: in these
conditions in fact, skidding of the driving
wheels when moving off helps to obtain
better traction.
CUTTING IN OF THE VDC
SYSTEM
The cutting in of the VDC system is indi-
cated by the flashing of the warning light
(A-fig. 145) on the instrument cluster,
to inform the driver that the car is in criti-
cal conditions of stability and grip.
664PGSm
fig. 145
A0D0035m
fig. 144

121
VDC AND ASR SYSTEM
FAILURE WARNINGS
In the event of failures the VDC and ASR
systems switch off automatically and the
warning light (A-fig. 145) on the in-
strument cluster turn on glowing steadily.The table below summarises the indica-
tions given by the warning lights in the d-
ifferent operating conditions.In the event of a failure to the VDC or
ASR systems, the car behaves like the
version not equipped with these systems:
at all events, you are recommended to
contact Authorised Alfa Romeo Services
as soon as possible.
Conditions of use System ASR warning VDC warning light ABS warning light EBD warning light
or fault status light on button on cluster on cluster on cluster
Engine starting Lamp On for about On for about On for about On for about
(turning key to MAR) check 4 seconds 4 seconds 4 seconds 4 seconds
Driving inASR on ASR enabled Off Off Off Off
NormalVDC enabled
Conditions ASR off ASR disabled On Off Off Off
Manually VDC enabled
Driving inASR on ASR active Off Flashing Off Off
ConditionsVDC active
that might
ASR off ASR disabled On Flashing Off Off
cause skidding
Manually VDC active
ASR system fault ASR disabled On On Off Off
Fault VDC VDC disabled Off On Off Off
Fault VDC/ASR VDC/ASR disabled On On Off Off
Fault ABS ABS/VDC/ASR disabled On On On Off
Fault EBD ABS/VDC/ASR/EBD disabled On On On On

127
AUTOMATIC FUEL CUT-OFF SWITCH
The car is equipped with a safety switch
which is triggered in the event of a crash
to interrupt the flow of fuel and stopping
the engine as a consequence. This also
prevents fuel leaks due to fuel lines
breaking.If no leaks or damages to electric de-
vices (e.g.: headlights) are found and the
car can be restarted, reactivate the fuel
cut-off switch. Follow the instructions giv-
en below.
If, after an accident, you
can smell petrol or see
that the fuel feed system is leak-
ing, do not reset the switches to
avoid the risk of fire.
WARNING
After the crash, remember to turn the ig-
nition key to STOPto prevent the bat-
tery running down.