Page 199 of 272

198IN THE EVENT
OF AN ACCIDENT
– It is important to keep calm.
– If you are not directly involved, stop
at a distance of at least ten metres from
the accident.
– On the motorway stop without ob-
structing the emergency lane.
– Turn off the engine and switch on the
hazard warning lights.
– At night, light the place of the acci-
dent with your headlights.
– Take care not to put yourself in dan-
ger of being run over.
– Signal the accident placing the reflect-
ing triangle plainly in view at the regula-
tion distance.
– Call the rescue organisation giving in-
formation as exact as possible. On motor-
ways use the special call boxes.
– In motorway pileups, especially with
poor visibility, the risk exists of being in-
volved in other crashes. Leave the vehi-
cle immediately and go over the guard
rail. The car is to be lifted
positioning the jack or
the workshop lift arm
plate only in the points shown
(1-2 fig. 100).
Between the lift plate and the
body interpose a rubber pad
with a maximum size of 60x60
mm and maximum thickness of
30 mm. The pad should insert in
the special recess on the under
door panel, without interfering
with it.
USING AN ARM LIFT OR
WORKSHOP LIFT
The vehicle must only be lifted laterally
positioning the ends of the arms or the
workshop lift in the areas (1-2) illustrat-
ed, approx. 30 cm from the profile of the
wheelhouse (fig. 100).
A0D0040m
fig. 100
Page 205 of 272

204
PROGRAMMED MAINTENANCE SCHEDULE
thousands of kilometres
Check tyre conditions/wear and adjust pressure if required
Check light system operation (headlights, direction indicators, hazard lights, boot lights,
passenger compartment lights, glovebox lights, warning lights, etc.)
Check windscreen wiper/washer operation, adjust nozzles if required
Check windscreen/rear window blade position/wear
Check front disk brake pad conditions and wear and wear indicator operation
Check rear disk brake pad conditions and wear
Sight inspect the conditions of: body external parts, underbody protection, pipes and hoses
(exhaust - fuel - brakes), rubber parts (boots, sleeves, bushes, etc.)
Check cleanness of locks, bonnet and boot and lever cleanness and lubrication
Check condition of timing drive belt
Sight check for conditions of Poly-V accessory drive belt
Check and adjust handbrake lever stroke
Check engine exhaust emissions (petrol versions)
Check exhaust emissions/smoke (diesel versions)
Check antievaporation system (petrol versions)20 40 60 80 100 120 140 160 180
● ●●● ● ● ● ● ●
● ●●● ● ● ● ● ●
● ●●● ● ● ● ● ●
● ●●● ● ● ● ● ●
● ●●● ● ● ● ● ●
●● ● ●
● ●●● ● ● ● ● ●
● ●●● ● ● ● ● ●
●●
●●
●● ● ●
●● ● ●
●● ● ●
●●
Page 228 of 272

227
IMPORTANT The vehicle should be
washed with the engine cold and the igni-
tion key turned to STOP. After washing
make sure that the various protections
(e.g. rubber caps and recess covers) have
not been damaged or removed. When drying off take particular care to
cover the less visible parts like the bonnet
and boot lids and around the headlights
where water may stagnate. The vehicle
should not be taken to an enclosed area
immediately but left in the open so that
the residual water can evaporate. Do not
wash the vehicle after it has been left in
the sun or when the bonnet is hot as this
may alter the shine of the paintwork.
Plastic parts must be cleaned in the same
way as the rest of the vehicle. Specific
products need only be used when dirt is
particularly resistant.
IMPORTANT Bird droppings must be
washed off immediately as the acid con-
tained in them is particularly aggressive.
To better protect the paint, occasionally
polish with special products (silicone
wax) which leave a protective layer on
the body.WINDOWS
Use specific products to clean the win-
dows. Clean cloths should be used to
avoid scratching or altering the trans-
parency of the glass.
ENGINE COMPARTMENT
At the end of the winter the engine
compartment should be carefully washed.
Contact a specialised workshop to have
this done.The inside of the rear
windscreen should be
wiped gently with a
cloth in the direction of the fila-
ments to avoid damaging the
heating device.
Detergents cause water
pollution. The car should
therefore be washed in
areas equipped for the collection
and purification of the liquid used
in the washing processes.
For washing the engine
compartment, you are
recommended to use
“FULCRON” available in Alfa
Romeo Lineaccessori. In any
case, only use soda-free deter-
gent solutions preferably alka-
lined with metasilicates.After
washing the engine compartment
it must be accurately rinsed with
a specific operation and dried. In
fact the normal passage of the
body washing tunnel is unable to
rinse the engine compartment
adequately.
Page 256 of 272

255
1Air ducts for side window outlets.
2Side air vents.
3Light switch lever (high beam, flash-
ing, direction indicators) and controls
for Cruise Control (automatically
keeping a set speed, if present).
4Instrument cluster.
5Outlets for windscreen.
6Upper outlet.
7Oddments compartment.
8Centre air vents.
9Passenger’s air bag.
10Manual passenger’s side Air bag
deactivation switch.
11Glove box.
12Boot opening button (in glove box).13Button for rearscreen defrosting,
door mirrors and resistances at base
of windscreen (if present).
14Button for windscreen/front side
windows and door mirrors
defrosting, rearscreen heating,
resistances at base of windscreen (if
present).
15Cigar lighter.
16Alfa Romeo I.C.S. (INTEGRATED
CONTROL SYSTEM): RDS radio,
computer on board (TRIP), climate
control, clock and outside/inside
temperature, GSM phone and
navigation system (if present).
17Buttons for central locking, fuel flap
opening, switching off the ASR
function of the VDC system switching
on the STR system (if present).
18Rear fog guard switch.
19Front fog light switch.
20Hazard warning light switch.21Inside temperature sensor.
22Windscreen wiper/washer control
lever and rain sensor (if present).
23Ignition switch (ignition device).
24Driver’s air bag and horn.
25Lever for releasing/locking adjustable
steering wheel.
26Instrument lighting adjustment.
27Headlamp aiming device control
(except versions with gas discharge
headlights).
28Outside lights switch.
29Bonnet opening lever.
30Front floor air outlets.
Page 258 of 272

257
A -Speedometer
B -Mileage recorder with double meter
display (total and trip)
C -Check panel
D -Rev. counter
E -Fuel gauge and reserve warning light
F -Engine coolant temperature gauge
and maximum temperature warning
light
G -Warning lights
H -Electronic automatic gearbox display
IMPORTANT Depending on the trim
levels, the dial of the instruments may be
either light grey or black, with green or
red light.CONTROLS
LIGHTS SWITCH (fig. 3)
The device and services controlled by
the levers on the steering wheel can only
be activated when the ignition key is in
theMARposition (except the parking
lights which can always be switched on).Lights switched off
When the pointer on the knurled ring
(A) is opposite the symbol O, the exter-
nal lights are switched off.
Sidelights
The sidelights are switched on by turn-
ing the knurled ring (A) from Oto
6.
The
3warning light on the instru-
ment panel will come on at the same
time.
Dipped-beam headlights
These are switched on by turning the
knurled ring (A) from
6to2.
Parking lights
When the pointer of the switch (A) cor-
responds with the
Fsymbol, the side
lights stay on regardless of the position of
the ignition key.
fig. 3
A0D0148m