2006 Acura TSX reset

This shows how much f uel you
have. It may show slightly more
or less than the actual amount.
The needle returns to the
bottom after you turn off the
ignition.
This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, such as
very hot weather or a long period of
uphill driving, the pointer may rise to
the upper zone. If it reaches the red (Hot) mark, pull saf ely to the side of
the road. See page f or
instructions and precautions on
checking the engine’s cooling
system.
321
Gauges
Temperature Gauge Fuel Gauge
68
TACHOMETER
SPEEDOMETER
FUEL GAUGE
TEMPERATURE
GAUGE
U.S. Model is shown. INFO KNOB
SELECT/RESET KNOB
Avoid driving with an extremely low
f uel level. Running out of f uel could
cause the engine to misf ire, damaging
the catalytic converter.
——y
y
(y
y

The multi-inf ormation display
consists of two segments: an upper
segment and a lower segment.
In normal display mode, the upper
segment displays trip computer. The
lower segment displays the
odometer, Trip A/B, outside
temperature, and engine oil lif e and
maintenance message.The primary display always shows its
def ault setting, ‘‘INST. MPG’’ (U.S.
models) or ‘‘INST. L/100 km’’
(Canadian models) even if you press
the INFO button. It only changes the
secondary display. You can
customize this setting to your liking
(see page ).
Messages in the trip computer
include:
The upper segment is divided into
two displays; primary and secondary.
After you turn the ignition switch to
the ON (II) position, press the INFO
button on the steering wheel or the
INFO knob in the instrument panel.
What you last selected appears on
the secondary display of the trip
computer. Pressing the INFO
button/knob repeatedly changes the
display as shown in the example on
the next page. INST.MPG(U.S.models)/
INST.L/100 km (Canadian
models): Your vehicle’s current
f uel mileage.
AVG. FUEL A/AVG. FUEL B:
Your vehicle’s average fuel
economy since you last reset the
Trip A or Trip B. When you select
Trip B in the lower segment by
pressing the SEL/RESET button
on the steering wheel or select/
reset knob in the instrument panel,
the AVG. FUEL B appears in the
secondary display.101
Multi-Inf ormation Display
70
INFO KNOB
INFO BUTTON
SECONDARY DISPLAY
LOWER SEGMENT
PRIMARY DISPLAY
UPPER SEGMENT
—
—y

y
(yy

RANGE: The estimated distance
you can travel on the fuel
remaining in the tank. This
distance is estimated from the fuel
economy you received over the
last several miles, so it will vary
with changes in speed, traf f ic, etc.
ELAPSED TIME: The time
traveled since you last reset the
trip computer.
When you turn the ignition switch
to the ON (II) position, ELAPSED
TIME is reset.
AVG. SPEED: The average speed
you are traveling.
Multi-Inf ormation Display
Inst rument s and Cont rols
71
U.S. model is shown: Press SEL/RESET Button.
: Press INFO Button.
——y

y
(yy

You can also change the display by
pushing the Select/Reset knob in the
instrument panel.
When you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.While a trip meter is displayed, you
can change the display between
‘‘TRIP A’’ and ‘‘TRIP B’’ by pressing
the SEL/RESET button on the
steering wheel, or the Select/Reset
knob in the instrument panel.
In the lower segment, each time you
press the SEL/RESET button on the
steering wheel, the display changes
f rom ‘‘Trip A/Odometer’’ to ‘‘Trip A/
Outside Temperature’’ to ‘‘Trip B/
Outside Temperature’’ to ‘‘Engine
Oil Lif e’’, and then back to the ‘‘Trip
A/Odometer’’ as shown in the next
column. Trip Meter
Multi-Inf ormation Display
72
U.S.model is shown
SELECT/RESET
KNOB
SEL/RESET
BUTTON
LOWER SEGMENT
: Press the INFO Button.
——y

y
(yy

To reset a trip meter, display it, and
press and hold the SEL/RESET
button or Select/Reset knob until the
number resets to ‘‘0.0.’’ When you
reset ‘‘Trip B’’ , ‘‘AVG. FUEL B’’ is
also reset. If you reset ‘‘Trip A’’,
‘‘AVG. FUEL A’’ and ‘‘AVG. SPEED’’
willberesetatthesametime.
In the customizing mode, you can set
‘‘Trip A’’ and ‘‘AVG. FUEL A’’ to
reset at the same time when you
ref uel your vehicle (see page ).This shows the outside Fahrenheit
temperature in U.S. models, and
Centigrade temperature in Canadian
models.The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
You can adjust the outside
temperature display (see page ).
97
95
Multi-Inf ormation Display
Outside Temperature
Inst rument s and Cont rols
73
U.S.model is shownOUTSIDE TEMPERATURE
——y
y
(yy

This shows the remaining lif e of the
engine oil. It shows 100% af ter the
engine oil is replaced and the display
is reset. The engine oil lif e is
calculated based on engine operating
conditions and accumulated engine
revolutions. For more inf ormation,
see page .When the engine oil lif e reaches 15 %,
the display shows ‘‘SERVICE DUE
SOON’’ and the code f or the
maintenance items to be perf ormed.
When the engine oil lif e reaches 5 %,
the display shows ‘‘SERVICE DUE
NOW’’ along with the same
maintenance items.Have your dealer do the indicated
maintenance as soon as you see this
message, and have them reset the
display af ter completing the service.
If you do not perf orm the indicated
maintenance or do not reset the
display, the message changes to
‘‘SERVICE PAST DUE’’ when the
engine oil lif e becomes 0 %.
266
Engine Oil L if e
Maintenance Messages
Multi-Inf ormation Display
74
U.S.model is shown U.S.model is shown
ENGINE OIL LIFE
——y
y
(yy

To change the settings, stop the
vehicle, and make sure to set the
parking brake and put the
transmission in Park (A/T) or
neutral (M/T). If you try to enter the
customizing mode while the vehicle
is moving, the above message
appears and you cannot change the
settings.The f irst customizing menu is:
DEFAULT ALL CHANGE SETTING
EverytimeyoupresstheINFO
button, the display cycles from
‘‘CHANGE SETTING,’’ ‘‘DEFAULT
ALL,’’ ‘‘EXIT’’ and then back to
‘‘CHANGE SETTING.’’ Press the
SEL/RESET button to enter your
selection.
If you want the settings as they were
when the vehicle lef t the f actory,
select ‘‘DEFAULT ALL,’’ as
described on page . If you want to change any vehicle
control settings, select ‘‘CHANGE
SETTING,’’ and f ollow the
instructions on page .
You can also use the Select/Reset
knob in the instrument panel. Turn
the knob to select a setting and press
it to enter your selection. If you do not make any changes,
select ‘‘EXIT,’’ the display returns to
normal display.
89 91
Multi-Inf ormation Display
86
AT model MT model
——y
y
(yy

ÎÎÎ
Î Î
Î
Î
µ™¶Ã™´
µ™¶Ã™´
Î
Here are the settings you can
customize in this mode:
Ref er to pages in the next column
about the settings you want to
customize.
CONT INUED
CUST OMIZE GROUP
MET ER SET UP
POSITION SETUP LANGUAGE
SELECTION
ADJUST OUTSIDE TEMP.
DISPLAY
TRIP A & AVG. FUEL
RESET with REFUEL
ELAP. TIME RESET
CONDITION
PRIMARY DISP
SELECTION
MEMORY POSIT ION
LINK CUST OMIZE SET UP
ENGLISH
FRENCH
SPANISH 5°F 0 F 5°F
3°C 0 C 3°C
ON
OFF
IGN RESET
TRIP A RESET
TRIP B RESET
INST. FUEL
AVG. FUEL
RANGE
ELAPSED TIME
AVG. SPEED
ON
OFF See page
93
See page 95
See page 97
See page 99
See page 101
See page 103
CUST OMIZE MENU
: Default setting
Multi-Inf ormation Display
Inst rument s and Cont rols
87
——y
y
(yy