5-53
EPOWRCAMSHAFTS
7. Install:
Cylinder head cover gasket
Cylinder head cover
NOTE:
Apply sealant onto the mating surfaces of the
cylinder head cover gasket and cylinder
head.
Tighten the cylinder head cover bolts stages
and in a crisscross pattern.
T R..
Cylinder head cover bolt:
12 N m (1.2 kgf m, 8.7 ft lb)
ProCarManuals.com
5-75
EPOWRCRANKCASE
SERVICE POINTS
Crankcase disassembly
1. Remove:
Oil pan bolts
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
Loosen the bolts in decreasing numerical
order (refer to the numbers in the illustra-
tion).
The numbers embossed on the oil pan indi-
cate the oil pan tightening sequence.
106
24812
15
11
7
3 1 5 9
13 14
2. Remove:
Crankcase bolts
NOTE:
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
Loosen the bolts in decreasing numerical
order (refer to the numbers in the illustra-
tion).
The numbers embossed on the crankcase
indicate the crankcase tightening sequence.
3. Remove:
Lower crankcase
CAUTION:
Tap on one side of the crankcase with a
soft-face hammer. Tap only on reinforced
portions of the crankcase, not on the
crankcase mating surfaces. Work slowly
and carefully and make sure the crankcase
halves separate evenly.
M9
× 105 mm bolts:
1–
0
M6
× 55 mm bolts:
A–
H,
J
M6
× 70 mm bolts:
I
15397
ICAEG
86240
HFBDJ
ProCarManuals.com
