2005 YAMAHA VX110 light

7-59
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
REMOTE CONTROL SYSTEM
Yamaha Security System indicator
1. Check:
Yamaha Security System indicator
Check that the “SECURITY” indicator
light 1 comes on when the Yamaha
Security System is deactivated (i.e., the
engine can be started).
Does not come on → Measure the
remote control unit output voltage.
2. Measure:
Remote control unit output voltage
Within specification → Replace the mul-
tifunction meter.
Out of specification → Replace the
remote control unit.
Remote control unit output
voltage:
Blue/yellow (L/Y) – ground
11–13 V
Measurement steps:
Disconnect the remote control unit 1
coupler from the multifunction meter.
Measure the remote control unit output
voltage while pushing the unlock button
of the remote control transmitter.
1
1
L/Y
1
Low-rpm mode indicator
1. Check:
Low-rpm mode indicator
Does not come on → Replace the multi-
function meter.
Checking steps:
Press the unlock button 1 of the remote
control transmitter for more than 4 sec-
onds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light 2 comes on.
1
ProCarManuals.com

7-60
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Checking the remote control transmitter
1. Check:
Remote control transmitter
Does not operate → Replace the remote
control transmitter.
Checking steps:
CAUTION:
If the buttons on the remote control
transmitter are pushed but the transmit-
ter does not operate, the battery may be
low.
Press the lock button 1 of the remote
control transmitter. The beeper sounds
once.
Check that the “SECURITY” indicator
light goes off and that the engine cannot
be started.
Press the unlock button 2 of the remote
control transmitter for a short time. The
beeper sounds two or three times.
Check that the “SECURITY” indicator
light comes on and that the engine can
be started.
Press the unlock button for more than 4
seconds to select the low-rpm mode.
Check that the beeper sounds three
times and that the “L-MODE” indicator
light comes on.
Number of
beepsYamaha
Security
System modeEngine
startability
1 beep Lock Unable
2 beepsUnlock
(normal mode)Able
3 beepsUnlock
(low-rpm
mode)Able
12
ProCarManuals.com

7-61
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
NOTE:
If the start switch or the remote control
transmitter is not operated for more than
25 seconds, the multifunction meter dis-
play and the “L-MODE” indicator light will
go off. To change the modes again, press
the lock button for a short time, and then
start the procedures from the lock mode.
While the engine is running, input is not
received from the remote control transmit-
ter.
ProCarManuals.com

7-62
E
–+ELEC
REMOTE CONTROL SYSTEM
(DELUXE MODEL ONLY)
Transmitter registration
1. Register:
Remote control transmitter 1
ID codes can be added or re-registered
by connecting the entry box 2.
Registration steps:
Connect the entry box.
Transmit the ID code from the remote
control transmitter to be registered.
NOTE:
The remote control transmitters can be reg-
istered in any sequence, regardless of
whether they are original equipment or
additional transmitters.
At this time, the system enters the regis-
tration mode to register the first code. All
existing ID codes will be deleted from the
EEPROM.
The “SECURITY” indicator light flashes
when the registration of the ID code has
been completed. (If the registration could
not be completed, the “SECURITY” indi-
cator light comes on. Re-transmit the ID
code.)
After confirming that the registration of
the ID code has been completed using
the “SECURITY” indicator light, transmit
the next ID code.
Register the ID codes for up to five
remote control transmitters.
After ID code registration has been com-
pleted, disconnect the entry box to exit
the registration mode.
Gy
B
12
ProCarManuals.com

9-7
E
TRBL
ANLS
TROUBLE ANALYSIS
Starting system
Start switch 7
Starter relay 7
Starter motor 7
Charging system
Lighting coil 7
Rectifier/regulator 7
Fuses 7
Battery leads—
Battery 3
Remote control system (Deluxe model only)
Remote control unit 7
HULL AND HOOD
Steering column 8
Water lock 8
Exhaust hose 8
Muffler 8
Drain plugs 8 Trouble mode Check elements
ENGINE WILL NOT START
HARD STARTING
ROUGH IDLING
HIGH IDLING
ENGINE STALLS
POOR ACCELERATION
ENGINE WILL NOT STOP
POOR PERFORMANCE
LIMITED ENGINE SPEED
OVERHEATING
LOW OIL PRESSURE
LOOSE STEERING
BILGE INCREASE
IRREGULAR WARNING INDICATION
POOR BATTERY CHARGING
Relative partReference
chapter
ProCarManuals.com

WIRING DIAGRAM
VX110 Sport
1Battery
2Starter motor
3Fuse (30 A)
4Fuse (20 A)
5Fuse (3 A)
6Fuse (10 A)
7Fuse (10 A)
8Starter relay
9Main and fuel pump relay
0Electronic control throttle valve relay
ASlant detection switch
BIgnition coil
CSpark plug
DCam position sensor
ESensor assembly
(intake air pressure and intake air tempera-
ture)
FEngine temperature sensor
GThermoswitch (engine)
HThermoswitch (exhaust)
IOil pressure switch
JFuel injector
KECM
LRectifier/regulator
MThrottle body assembly
NAccelerator position sensor
OPickup coil
PLighting coil
QBuzzer
RElectric fuel pump
SSteering sensor
TFuel sender
USpeed sensor
VMultifunction meter
WStart switch
XEngine stop switch
YEngine shut-off switch
ÈTo tachometerColor code
B: Black
Br : Brown
G: Green
Gy : Gray
L: Blue
O : Orange
P: Pink
R: Red
W: White
Y : Yellow
B/G : Black/green
B/O : Black/orange
B/R : Black/red
B/W : Black/white
B/Y : Black/yellow
G/B : Green/black
G/O : Green/orange
G/R : Green/red
G/Y : Green/yellow
L/R : Blue/red
P/G : Pink/green
P/W : Pink/white
Pu/B : Purple/black
Pu/G : Purple/green
Pu/R : Purple/red
Pu/Y : Purple/yellow
R/W : Red/white
R/Y : Red/yellow
W/B : White/black
W/L : White/blue
W/R : White/red
Y/G : Yellow/green
Y/W : Yellow/white
ProCarManuals.com

WIRING DIAGRAM
VX110 Deluxe
1Battery
2Starter motor
3Fuse (30 A)
4Fuse (20 A)
5Fuse (3 A)
6Fuse (10 A)
7Fuse (10 A)
8Starter relay
9Main and fuel pump relay
0Electronic control throttle valve relay
ASlant detection switch
BIgnition coil
CSpark plug
DCam position sensor
ESensor assembly
(intake air pressure and intake air tempera-
ture)
FEngine temperature sensor
GThermoswitch (engine)
HThermoswitch (exhaust)
IOil pressure switch
JFuel injector
KRemote control unit
LAntenna
MECM
NRectifier/regulator
OThrottle body assembly
PAccelerator position sensor
QPickup coil
RLighting coil
SBuzzer
TElectric fuel pump
USteering sensor
VFuel sender
WSpeed sensor
XMultifunction meter
YStart switch
ZEngine stop switch
[Engine shut-off switch
ÈTo entry box
ÉTo tachometerColor code
B: Black
Br : Brown
G: Green
Gy : Gray
L: Blue
O : Orange
P: Pink
R: Red
W: White
Y : Yellow
B/G : Black/green
B/O : Black/orange
B/R : Black/red
B/W : Black/white
B/Y : Black/yellow
G/B : Green/black
G/O : Green/orange
G/R : Green/red
G/Y : Green/yellow
L/B : Blue/black
L/R : Blue/red
L/Y : Blue/yellow
P/G : Pink/green
P/W : Pink/white
Pu/B : Purple/black
Pu/G : Purple/green
Pu/R : Purple/red
Pu/Y : Purple/yellow
R/W : Red/white
R/Y : Red/yellow
W/B : White/black
W/L : White/blue
W/R : White/red
Y/G : Yellow/green
Y/W : Yellow/white
ProCarManuals.com