2005 YAMAHA RHINO 660 clock

4-13 1. Speedometer 2.“H” button
3.“M” button 4. Clock/Hour meter
5. Odometer/Tripmeter A/Tripmeter B
6.“TRIP/ODO” button 7. Clock/Hour button “”/“”
1. Compteur de vitesse 2. Bouton “H”
3. Bouton “M”4. Montre/compteur horaire
5. Compteur kilométrique/totalisateur journalier A/
totalisateur journalier B
6. Bouton “TRIP/ODO”
7. Bouton de la montre/du temps “”/“”
1. Velocímetro 2. Botón “H”
3. Botón “M”4. Reloj/Cuentahoras
5. Cuentakilómetros/Cuentakilómetros parcial A/
Cuentakilómetros parcial B
6. Botón “TRIP/ODO”
7. Botón Reloj/Cuentahoras “”/“”
EVU01171
Multi-function meter unit
The multi-function meter unit is equipped with the
following:

a speedometer (which shows the riding speed)


an odometer (which shows the total distance
traveled)


two tripmeters (which show the distance trav-
eled since they were last set to zero)


a clock


an hour meter (which shows the total time the
key has been turned to “ON”)
U5UG61.book Page 13 Monday, September 6, 2004 9:00 AM

4-15 1. Speedometer 2.“H” button
3.“M” button 4. Clock/Hour meter
5. Odometer/Tripmeter A/Tripmeter B
6.“TRIP/ODO” button 7. Clock/Hour button “”/“”
1. Compteur de vitesse 2. Bouton “H”
3. Bouton “M”4. Montre/compteur horaire
5. Compteur kilométrique/totalisateur journalier A/
totalisateur journalier B
6. Bouton “TRIP/ODO”
7. Bouton de la montre/du temps “”/“”
1. Velocímetro 2. Botón “H”
3. Botón “M”4. Reloj/Cuentahoras
5. Cuentakilómetros/Cuentakilómetros parcial A/
Cuentakilómetros parcial B
6. Botón “TRIP/ODO”
7. Botón Reloj/Cuentahoras “”/“”
Odometer and tripmeter modes
Pushing the “TRIP/ODO” button switches the dis-
play between the odometer mode “ODO” and the
tripmeter modes “A” and “B” in the following order:
ODO
→TRIP A
→TRIP B
→ODO
To reset a tripmeter, select it by pushing the “TRIP/
ODO” button, and then push the “TRIP/ODO” but-
ton for at least three seconds. The tripmeters can
be used to estimate the distance that can be trav-
eled with a full tank of fuel. This information will en-
able you to plan future fuel stops.NOTE:_ Holding in the “TRIP/ODO” button and then turning
the key to “ON” switches the display between
“mph” and “km/h”. _
U5UG61.book Page 15 Monday, September 6, 2004 9:00 AM

4-17 1. Speedometer 2.“H” button
3.“M” button 4. Clock/Hour meter
5. Odometer/Tripmeter A/Tripmeter B
6.“TRIP/ODO” button 7. Clock/Hour button “”/“”
1. Compteur de vitesse 2. Bouton “H”
3. Bouton “M”4. Montre/compteur horaire
5. Compteur kilométrique/totalisateur journalier A/
totalisateur journalier B
6. Bouton “TRIP/ODO”
7. Bouton de la montre/du temps “”/“”
1. Velocímetro 2. Botón “H”
3. Botón “M”4. Reloj/Cuentahoras
5. Cuentakilómetros/Cuentakilómetros parcial A/
Cuentakilómetros parcial B
6. Botón “TRIP/ODO”
7. Botón Reloj/Cuentahoras “”/“”
Clock mode
Pushing the “”/“” button switches the dis-
play between the clock mode “CLOCK” and the
hour meter mode “HOUR” in the following order:
CLOCK
→HOUR
→CLOCK
To set the clock1. Set the display to the clock mode.
2. Push the “”/“” button until the clock
starts flashing.
3. Set the hours by pushing the “H” button.
4. Set the minutes by pushing the “M” button.
5. Push the “”/“” button, and then re-
lease it to start the clock.
U5UG61.book Page 17 Monday, September 6, 2004 9:00 AM

4-18
Montre
Appuyer sur le bouton “”/“” pour alterner l’affi-
chage de la montre “CLOCK” et du compteur horaire
“HOUR” comme suit :
CLOCK→HOUR→CLOCK
Réglage de la montre1. Afficher la montre à l’écran.
2. Appuyer sur le bouton “”/“” jusqu’à ce
que l’affichage de la montre se mette à clignoter.
3. Régler les heures en appuyant sur le bouton “H”.
4. Régler les minutes en appuyant sur le bouton “M”.
5. Appuyer sur le bouton “”/“”, puis le relâ-
cher afin d’activer la montre.
Reloj
Pulsando el botón “”/“” la indicación cambia
entre reloj “CLOCK” y cuentahoras “HOUR” en el or-
den siguiente:
CLOCK
→HOUR
→CLOCK
Para poner el reloj en hora1. Seleccione la función de reloj.
2. Pulse el botón “”/“” hasta que el reloj
empiece a parpadear.
3. Ajuste las horas pulsando el botón “H”.
4. Ajuste los minutos pulsando el botón “M”.
5. Pulse el botón “”/“” y luego suéltelo
para poner en funcionamiento el reloj.
U5UG61.book Page 18 Monday, September 6, 2004 9:00 AM

4-39 1. Drive select lever
1. Sélecteur de marche
1. Palanca selectora de marcha
1. Fuel tank cap
1. Bouchon de réservoir de carburant
1. Tapón del depósito de gasolina
EVU00290
Drive select lever
The drive select lever is used to shift your vehicle
into the low, high, neutral and reverse positions.
(Refer to pages 6-15–6-19 for the drive select le-
ver operation.)
EVU00300
Fuel tank cap
Remove the fuel tank cap by turning it counter-
clockwise.
U5UG61.book Page 39 Monday, September 6, 2004 9:00 AM

8-115 1. Main fuse 2. Spare main fuse
3. Headlight fuse 4. Ignition fuse
5. Auxiliary DC jack fuse 6. Four-wheel-drive fuse
7. Signaling system fuse
8. Backup fuse (for odometer and clock)
9. Carburetor heater fuse 10. Spare fuse (× 3)
1. Fusible principal 2. Fusible principal de rechange
3. Fusible des phares 4. Fusible d’allumage
5. Fusible de la prise pour accessoires
6. Fusible du système quatre roues motrices
7. Fusible du système de signalisation
8. Fusible de sauvegarde (pour le compteur kilométrique et la montre)
9. Fusible du réchauffeur de carburateur
10. Fusible de rechange (× 3)
1. Fusible principal 2. Fusible principal de repuesto
3. Fusible de los faros 4. Fusible del encendido
5. Fusible de la toma de corriente continua
6. Fusible de la tracción integral
7. Fusible del sistema de intermitencia
8. Fusible de repuesto (cuentakilómetros y reloj)
9. Fusible del calentador del carburador
10. Fusible de repuesto (× 3)
3. Remove the blown fuse, and then install a
new fuse of the specified amperage.
4. Turn the key to “ON” and turn on the electrical
circuit in question to check if the device oper-
ates.
5. If the fuse immediately blows again, have a
Yamaha dealer check the electrical system.
6. Install the battery compartment cover.
7. Close the hood.Specified fuses:
Main fuse: 30.0 A
Headlight fuse: 15.0 A
Ignition fuse: 10.0 A
Auxiliary DC jack fuse: 10.0 A
Signaling system fuse: 10.0 A
Carburetor heater fuse: 10.0 A
Four-wheel-drive fuse: 3.0 A
Backup fuse: 10.0 A
U5UG61.book Page 115 Monday, September 6, 2004 9:00 AM

8-119 1. Headlight bulb holder cover
1. Cache du porte-ampoule de phare
1. Tapa del portabombillas del faro
1. Headlight bulb holder
1. Porte-ampoule de phare
1. Portabombillas del faro
EVU01520
Replacing a headlight bulb
If a headlight bulb burns out, replace it as follows.
1. Lift the hood up. (See pages 8-17–8-19 for
hood opening and closing procedures.)
2. Remove the bulb holder cover at the rear of
the headlight by pulling it off.
3. Remove the headlight bulb holder by turning
it counterclockwise.
U5UG61.book Page 119 Monday, September 6, 2004 9:00 AM

8-121 1. Headlight bulb holder tab (× 2)
1. Languette de porte-ampoule de phare (× 2)
1. Lengüeta del portabombillas del faro (×2)
1. Do not touch the glass part of the bulb.
1. Ne pas toucher le verre de l’ampoule.
1. No tocar la parte de cristal de la bombilla.
4. Remove the defective bulb by unhooking the
headlight bulb holder tabs.
WARNING
A headlight bulb is hot when it is on and imme-
diately after it is turned off. Wait for the bulb to
cool before touching or removing it. You can
be burned or a fire could start if the bulb touch-
es something flammable.5. Insert a new headlight bulb into the bulb hold-
er, and then hook the headlight bulb holder
tabs.
6. Install the headlight bulb holder by turning it
clockwise.
7. Install the headlight bulb holder cover at the
rear of the headlight.
8. Close the hood.
U5UG61.book Page 121 Monday, September 6, 2004 9:00 AM