2005 SUBARU OUTBACK brake light

11 -4 5
Maintenance and service
– CONTINUED –
Brake pedal
Check the brake pedal free play and reserve distance
according to the maintenance schedule in the “War-
ranty and Maintenance Booklet”. !Checking the brake pedal free play
A) 0.02 – 0.08 in (0.5 – 2.0 mm)
Stop the engine and firmly depress the brake pedal
several times. Lightly pull the brake pedal up with one
finger to check the free play with a force of less than 2
lbs (10 N, 1 kg).
If the free play is not within proper specification, con- tact your SUBARU dealer. !
Checking the brake pedal reserve dis-
tance
A) More than 2.56 in (65 mm)
Depress the pedal with a force of approximately 66 lbs
(294 N, 30 kg) and measure the distance between the
upper surface of the pedal pad and the floor.
When the measurement is smaller than the specifica-
tion, or when the pedal does not operate smoothly,
contact with your SUBARU dealer.
A
HSB049BC
A
HSB050BC

11 -4 7
Maintenance and service
– CONTINUED –
Replacement of brake pad and lining
If you continue to drive despite the scraping
noise from the audible brake pad wear indica-
tor, it will result in the need for costly brake ro-
tor repair or replacement.
The right front disc brake and the right rear disc brake
have an audible wear indicators on the brake pads. If
the brake pads wear close to their service limit, the
wear indicator makes a very audible scraping noise when the brake pedal is applied.
If you hear this scraping noise each time you apply the
brake pedal, have the brake pads serviced by your
SUBARU dealer as soon as possible. !
Breaking-in of new brake pads and lin- ings
When replacing the brake pad or lining, use only gen-
uine SUBARU parts. After replacement, the new parts
must be broken in as follows: ! Brake pad and lining
While maintaining a speed of 30 to 40 mph (50 to 65
km/h), step on the brake pedal lightly. Repeat this five
or more times. ! Parking brake lining
A safe location and situation should be select-
ed for break-in driving.
Pulling the parking brake lever too forcefully
HS7012BA

11 -5 1
Maintenance and service
– CONTINUED –
fore, you should have the work performed by a SUBA-
RU dealer.
If the low tire pressure warning light does not
come on briefly after the ignition switch is
turned ON or the light is flashing, you should
have your Tire Pressure Monitoring System
checked at a SUBARU dealer as soon as possi-
ble.
If this light comes on while driving, never brake
suddenly and keep driving straight ahead while
gradually reducing speed. Then slowly pull off
the road to a safe place. Otherwise an accident
involving serious vehicle damage and serious
personal injury could occur.
If this light still comes on while driving after ad-
justing the tire pressure, a tire may have signif-
icant damage and a fast leak that causes the
tire to lose air rapidly. If you have a flat tire, re-
place it with a spare tire as soon as possible.
When a spare tire is mounted or a wheel rim is
replaced without the original pressure sensor/
transmitter being transferred, the low tire pres-
sure warning light will flash. This indicates the
TPMS is unable to monitor all four road wheels.
Contact your SUBARU dealer as soon as possi- ble for tire and sensor replacement and/or sys-
tem resetting. If the light flashes, promptly con-
tact a SUBARU dealer to have the system in-
spected.
! Tire inspection
Check on a daily basis that the tires are free from se-
rious damage, nails, and stones. At the same time,
check the tires for abnormal wear.
Contact your SUBARU dealer immediately if you find
any problem.
NOTE " When the wheels and tires strike curbs or are
subjected to harsh treatment as when the vehicle
is driven on a rough surface, they can suffer dam-
age that cannot be seen with the naked eye. This
type of damage does not become evident until
time has passed. Try not to drive over curbs, pot-
holes or on other rough surfaces. If doing so is un-
avoidable, keep the vehicle’s speed down to a
walking pace or less, and approach the curbs as
squarely as possible. Also, make sure the tires are
not pressed against the curb when you park thevehicle. " If you feel unusual vibration while driving or find

11 - 7 4
Maintenance and service
!
Headlight
Halogen headlight bulbs become very hot while
in use. If you touch the bulb surface with bare
hands or greasy gloves, finger prints or grease
on the bulb surface develop into hot spots,
causing the bulb to break. If there are finger
prints or grease on the bulb surface, wipe them
away with a soft cloth moistened with alcohol.
NOTE "If headlight aiming is required, consult your
SUBARU dealer for proper adjustment of the head-
light aim.
Wattage Bulb No.
1) High beam headlight 12V-60W 9005 (HB3)
2) Low beam headlight 12V-55W H7
3) Front turn signal/Park- ing and front side
marker light 12V-27/8W 3157A
4) Map light 12V-8W –
5) Dome light 12V-8W –
6) Door step light 12V-3.5W –
7) Fog light Except OUTBACK 12V-55W H3
OUTBACK 12V-51W 9006 (HB4)
8) Trunk room light (Sedan) 12V-5W –
9) High mount stop light (Sedan) 12V-21W (W21W)
10) Rear turn signal light (Sedan) 12V-21W (W21W)
11) Backup light (Sedan) 12V-16W 921
12) Brake/tail and rear side marker light (Sedan) 12V-21/5W (W21/5W)
13) Cargo area light 12V-13W –
14) Brake/tail light (Station wagon) 12V-21/5W (W21/5W) 15) Rear side marker light
(Station wagon) 12V-5W 168
16) Rear turn signal light (Station wagon) 12V-21W (W21W)
17) Backup light (Station wagon) 12V-16W 921
18) Licence plate light 12V-5W 168 Wattage Bulb No.

11 -7 7
Maintenance and service
– CONTINUED –
A) Rear turn signal light
B) Backup light
C) Brake/tail and rear side marker light
2. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
3. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
4. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
5. Securely lock the cover against the trunk trim by
using the screwdriver to turn the top knob clockwise. !
Station wagon
1. Using a Phillips screwdriver, remove the upper andlower screws.
A
B
CUBB206BB
UBB533BA

11 -7 9
Maintenance and service
– CONTINUED –
A) Brake/tail light
B) Rear turn signal light
C) Rear side marker light
4. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
5. Remove the bulb from the socket by pushing it and
turning counterclockwise. Install a new bulb.
6. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
7. Close the cover and latch the lock.
8. Reinstall the rear combination light assembly and
its side cover. !
Backup light (Station wagon)
1. Use a flat-head screwdriver to remove the light cov-
er from the top of the left hand rear gate trim.
C A
B
UBB201BB
UBB536BA

12-10
Specifications
Bulb chart
Description Wattage Bulb No.
Headlight
Low beam 12V-55W H7
High beam 12V-60W 9005 (HB3)
Fog light
Except OUTBACK 12V-55W H3
OUTBACK 12V-51W 9006 (HB4)
Front turn signal/parking
and front side marker 12V-27/8W 3157A
Rear combination light Rear turn signal light
(Sedan) 12V-21W (W21W)
Brake/tail and rear
side marker (Sedan) 12V-21/5W (W21/5W)
Brake/tail (Station
wagon) 12V-21/5W (W21/5W)
Rear side marker
(Station wagon) 12V-5W 168
Rear turn signal light
(Station wagon) 12V-21W (W21W )
Backup light 12V-16W 921
High mount stop light
(Sedan) 12V-21W (W21W) License plate light 12V-5W 168
Trunk room light 12V-5W W5W
Cargo area light 12V-13W –
Front ashtray light 12V-1.4W –
Dome light 12V-8W –
Map light 12V-8W –
Door step light 12V-3.5W –
Description Wattage Bulb No.

14-2
Index
A
ABS (Anti-lock Brake System) ........................... 7-38
Warning light ........................................ 3-28, 7-39
Accessories ..................................................... 11-72
Accessory power outlet ..................................... 6-14
Active head restraint ............................................ 1-8
Air cleaner element ......................................... 11-24
Air conditioner ..................................................... 4-9
Air filtration system ............................................ 4-19
Air flow selection ................................................. 4-2
Alarm system ..................................................... 2-23
All-wheel drive warning light (AT vehicles) ........ 3-31
Aluminum wheels ............................................ 11-57
Antenna system .................................................. 5-2
Anti-lock Brake System (ABS) ........................... 7-38
Arming the system ............................................. 2-24
Armrest .............................................................. 1-14
Ashtray .............................................................. 6-19
AT OIL TEMPerature warning light ................... 3-27
Audio control button .......................................... 5-56
Audio set ............................................................. 5-3
Auto-dimming mirror/compass .......................... 3-59
Automatic climate control system ...................... 4-10
Automatic transmission 4 speed ......................................................... 7-16
5 speed ......................................................... 7-25
Capacities ..................................................... 12-4 Fluid ............................................................ 11-33
Manual mode ....................................... 7-20, 7-30
Selector lever ...................................... 7-17, 7-26
Shift lock release ................................. 7-24, 7-35
Temperature warning light (AT OIL TEMP) .. 3-27
Automatic/Emergency Locking Retractor (A/ELR) .......................................................... 1-18
B
Battery ............................................................. 11-67 Jump starting ................................................ 9-17
Replacement (Remote keyless entry system) ...................................................... 2-16
Brake Booster ....................................................... 11-44
Fluid ............................................................ 11-42
Pad and lining ............................................. 11-47
Pedal .......................................................... 11-45
Brake pedal
Free play .................................................... 11-45
Reserve distance ........................................ 11-45
Brake system .................................................... 7-37
Warning light ................................................ 3-29
Braking .............................................................. 7-37
Breaking-in of new brake pads and linings ....................................................... 11-47
Tips ............................................................... 7-37