2005 SUBARU OUTBACK ESP

11 -4 7
Maintenance and service
– CONTINUED –
Replacement of brake pad and lining
If you continue to drive despite the scraping
noise from the audible brake pad wear indica-
tor, it will result in the need for costly brake ro-
tor repair or replacement.
The right front disc brake and the right rear disc brake
have an audible wear indicators on the brake pads. If
the brake pads wear close to their service limit, the
wear indicator makes a very audible scraping noise when the brake pedal is applied.
If you hear this scraping noise each time you apply the
brake pedal, have the brake pads serviced by your
SUBARU dealer as soon as possible. !
Breaking-in of new brake pads and lin- ings
When replacing the brake pad or lining, use only gen-
uine SUBARU parts. After replacement, the new parts
must be broken in as follows: ! Brake pad and lining
While maintaining a speed of 30 to 40 mph (50 to 65
km/h), step on the brake pedal lightly. Repeat this five
or more times. ! Parking brake lining
A safe location and situation should be select-
ed for break-in driving.
Pulling the parking brake lever too forcefully
HS7012BA

11 - 5 0
Maintenance and service
following table shows the required tire pressures that
correspond to various outside temperatures when the
temperature in the garage is 60
°F (15.6 °C).
Standard tire pressures:
Front: 32 psi (220 kPa, 2.2 kgf/cm 2
)
Rear: 30 psi (210 kPa, 2.1 kgf/cm 2
)
Garage temperature: 60 °F (15.6 °C)
If the low tire pressure warning light comes on when
you drive the vehicle in cold outside air after adjusting
the tire pressures in a warm garage, re-adjust the tire
pressures using the method described above. Then,
increase the vehicle speed to at least 20 mph (32 km/
h) and check to see that the low tire pressure warning
light goes off a few minutes later. If the low tire pres-
sure warning light does not go off, the tire pressure
monitoring system may not be functioning normally. In this event, go to a SUBARU dealer to have the system
inspected as soon as possible.
While the vehicle is driven, friction between tires and
the road surface causes the tires to warm up. After il-
lumination of the low tire pressure warning light, any
increase in the tire pressures caused by an increase in
the outside air temperature or by an increase in the
temperature in the tires can cause the low tire pres-
sure warning light to go off.
System resetting is necessary when the wheels are
changed (for example, a switch to snow tires) and new
TPMS valves are installed on the newly fitted wheels.
Have this work performed by a SUBARU dealer fol-
lowing wheel replacement.
It may not be possible to install TPMS valves on cer-
tain wheels that are on the market. Therefore, if you
change the wheels (for example, a switch to snow
tires), use wheels that have the same part number as
the standard-equipment wheels. Without four opera-
tional TPMS valve/sensors on the wheels, the TPMS
will not fully function and the warning light in the instru-
ment panel will flash.
When a tire is replaced, adjustments are necessary to
ensure continued normal operation of the tire pressure
monitoring system. As with wheel replacement, there-
Outside temperature Adjusted pressure
[psi (kPa, kgf/cm2
)]
front rear
30 °F (–1 °C) 35 (240, 2.4) 33 (230, 2.3)
10 °F (–12 °C) 37 (255, 2.55) 35 (245, 2.45)
–10 °F (–23 °C) 39 (270, 2.7) 37 (260, 2.6)

11 -5 3
Maintenance and service
– CONTINUED –
Incorrect tire pressures detract from controllability and
ride comfort, and they cause the tires to wear abnor-
mally. "Correct tire pressure (tread worn evenly)
Roadholding is good, and steering is responsive. Roll-
ing resistance is low, so fuel consumption is also low-er. "
Abnormally low tire pressure (tread worn at
shoulders)
Rolling resistance is high, so fuel consumption is also
higher.
HSB052AA
HSB053AA

11 - 7 0
Maintenance and service
The fuse puller is stored in the main fuse box in the en-
gine compartment.
A) Good
B) Blown
If any lights, accessories or other electrical controls do
not operate, inspect the corresponding fuse. If a fuse
has blown, replace it.
1. Turn the ignition switch to the “LOCK” position and
turn off all electrical accessories.
2. Remove the cover.
(For behind the coin tray: open the coin tray and pull it
horizontally to remove it.)
3. Determine which fuse may be blown. The back side
of each fuse box cover and the “Fuses and circuits”
section in chapter 12 in this manual show the circuit for
UB9569BA
AB
HSB067BB

13-17
Consumer information and Reporting safety defects
– CONTINUED –
tests, and does not include acceleration,
cornering, hydroplaning, or peak traction
characteristics.
! Temperature A, B, C
The temperature grades are A (the highest), B,
and C, representing the tire’s resistance to the
generation of heat and its ability to dissipate heat
when tested under controlled conditions on a
specified indoor laboratory test wheel. Sustained
high temperature can cause the material of the
tire to degenerate and reduce tire life, and exces-
sive temperature can lead to sudden tire failure.
The grade C corresponds to a level of perfor-
mance which all passenger car tires must meet
under the Federal Motor Vehicle Safety Stan-
dards No. 109. Grades B and A represent higher
levels of performance on the laboratory test
wheel than the minimum required by law.
The temperature grade for this tire is es-
tablished for a tire that is properly inflated and not overloaded. Excessive speed, un-
derinflation, or excessive loading, either
separately or in combination, can cause
heat buildup and possible tire failure.