2005 SUBARU LEGACY keyless entry

26
Function settings
A SUBARU dealer can change the settings of the functions shown below to meet your personal requirements. Con-
tact the nearest SUBARU dealer for details.Item Function Possible settings Default set- tingPage
Alarm system Alarm system Operation / Non-operation Operation 2-23 Monitoring start delay time (after
closure of doors) 0 second / 30 seconds 30 seconds 2-25
Impact sensor operation
(only vehicles with shock sensors
(dealer option)) Operation / Non-operation Non-opera-
tion2-29
Passive arming Operation / Non-operation Non-opera- tion2-27
Remote keyless entry sys-tem Hazard warning flasher Operation / Non-operation Operation 2-12
Audible signal Operation / Non-operation Operation 2-15
Key lock-in prevention Key lock-in prevention Operation / Non-operation Operation 2-11
Rear window defogger Rear window defogger Operation for 15 min. / Continuous operationOperation for
15 min.3-57

27
–
CONTINUED –
Windshield wiper deicer (if
equipped) Windshield wiper deicer Operation for 15 min. / Continuous
operationOperation for15 min.3-56
Dome light Operation in interlock with remote keyless entry system OFF / Short / Normal / Long Normal 6-2
Battery drainage prevention
function Battery drainage prevention func-tion Operation / Non-operation Operation 2-9
Item Function Possible settings Default set-
tingPage

2-1
2
Keys and doors
Keys ............................................................... 2-2 Key number ....................................................... 2-3
Immobilizer (if equipped) ............................. 2-4 Security ID plate ................................................ 2-5
Security indicator light ..................................... 2-5
Key replacement ............................................... 2-6
Door locks ..................................................... 2-6 Locking and unlocking from the outside ........ 2-6
Locking and unlocking from the inside .......... 2-8
Battery drainage prevention function ............. 2-9
Power door locking switches ...................... 2-10 Key lock-in prevention function ...................... 2-11
Remote keyless entry system (if equipped) .............................................. 2-12Locking the doors ............................................. 2-13
Unlocking the doors ......................................... 2-14
Unlocking the trunk lid/rear gate ..................... 2-14
Illuminated entry ............................................... 2-15
Vehicle finder function ..................................... 2-15
Sounding a panic alarm ................................... 2-15
Selecting audible signal operation .................. 2-15
Replacing the battery ....................................... 2-16
Replacing lost transmitters .............................. 2-17
Alarm system ................................................ 2-23 System alarm operation ................................... 2-23
Activating and deactivating the alarm system ............................................................. 2-23
If you have accidentally triggered the alarm
system ............................................................. 2-24
Arming the system ............................................ 2-24
Disarming the system ....................................... 2-26 Valet mode ......................................................... 2-27
Passive arming ................................................. 2-27
Tripped sensor identification .......................... 2-29
Shock sensors (dealer option) ........................ 2-29
Child safety locks ......................................... 2-30
Windows ........................................................ 2-31 Power windows ................................................. 2-31
Trunk lid (Sedan) ........................................... 2-35 To open and close the trunk lid from outside ............................................................ 2-35
To open the trunk lid from inside .................... 2-36
To lock and unlock the trunk lid release lever ................................................................. 2-36
Internal trunk lid release handle ...................... 2-37
Rear gate (Station wagon) ............................ 2-39
Moonroof (if equipped) ................................. 2-41 Tilting/sliding moonroof (Sedan) .................... 2-42
Moonroof (Station wagon) ............................... 2-44

2-12
Keys and doors
Remote keyless entry system (if
equipped)
"
Do not expose the transmitter to severe
shocks, such as those experienced as a result
of dropping or throwing. " Do not take the transmitter apart except when
replacing the battery. " Do not get the transmitter wet. If it gets wet,
wipe it dry with a cloth immediately.
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Oper-
ation is subject to the following two conditions: (1)
This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved
by the party responsible for compliance could
void the user’s authority to operate the equipment.
Two transmitters are provided for your vehicle.
The keyless entry system has the following functions. "
Locking and unlocking the doors (and rear gate on
the Station wagon) without a key " Locking and unlocking the doors (and trunk lid on
the Sedan) without key" Unlocking the rear gate on the Station wagon with-
out key " Unlocking the trunk lid on the Sedan without key
" Sounding a panic alarm
" Arming and disarming the security system (if your
vehicle is equipped with an optional security system).
See the next section “Alarm system” for detailed infor-mation.
The operable distance of the keyless entry system is
approximately 30 feet (10 meters). However, this dis-
tance will vary depending on environmental condi- tions. The system’s operable distance will be shorter
in areas near a facility or electronic equipment emitting
strong radio waves such as a power plant, broadcast
station, TV tower, or remote controller of home elec-
tronic appliances.
The keyless entry system does not operate when the
key is inserted in the ignition switch.

2-17
Keys and doors
– CONTINUED –
2. Remove the old battery from the holder. A) Negative (–) side facing up
3. Replace with a new battery (Type CR2025 or
equivalent) making sure to install the new battery with
the negative (–) side facing up.
4. Refit the removed half of the transmitter case. After the battery is replaced, the transmitter must
be synchronized with the keyless entry system’s
control unit. Press either the “ ” or “ ” but- ton six times to synchronize the unit.
! Replacing lost transmitters
If you lose a transmitter or want to purchase additional
UB2209BA
A
UB2210BB

2-18
Keys and doors
transmitters (up to four can be programmed), you
should re-program all of your transmitters for security
reasons. It is recommended that you have your dealer
program all of your transmitters into your system. !
Programming the transmitters
The keyless entry system is equipped with a special
code learning feature that allows you to program new
transmitter codes into the system or to delete old
ones. The system can learn up to four unique transmit-
ter codes. The four transmitter codes may be the same or different.
Programming transmitter codes into system:
Bag containing transmitter Transmitter circuit board
To register a new transmitter with the keyless entry system, it is necessary to program the transmitter’s
code (identification number) into the system. A label
showing the code is affixed to the bag containing the
transmitter, and another is affixed to the circuit board
inside the transmitter. If there is no bag, open the
transmitter case and make a note of the eight-digit
number. Program the number into the system in ac-
cordance with the following procedure:
1. Firmly close the doors and the rear gate or trunk lid.
2. Open the driver’s door, sit on the driver’s seat, and
close the door.
UB2223BA
UB2224BA

2-22
Keys and doors
NOTE
If the code entered the second time is not identical to the code entered the first time, an error will oc-
cur. In this event, perform the procedure again be-
ginning with part 5. If an error occurs five times,
perform the procedure again starting with part 3.
10.If you wish to program another transmitter code
into the system (up to four transmitter codes can be
programmed into the system), perform the procedure
beginning with part 4. When you have finished pro-
gramming all of the necessary transmitter codes into
the system, remove the key from the ignition switch.
11.Test every registered transmitter to confirm correct
operation. !
Deleting old transmitter codes
The control unit of the keyless entry system has four
memory locations to store transmitter codes, giving it
the ability to operate with up to four transmitters. When
you lose a transmitter, the lost transmitter’s code re-
mains in the memory. For security reasons, lost trans-
mitter codes should be deleted from the memory.
To delete old transmitter codes, program four trans-
mitter codes into the system. If you have only one cur-
rent transmitter, program it four times. If you have two
current transmitters, program each one twice. If you
have three current transmitters, program two of them once and the third one twice. This process will leave
only current transmitter codes in the system’s memo-ry.
NOTE
Make sure no one else is operating their keyless
entry system within range of your vehicle when
programming transmitters. If someone else were
to operate their remote transmitter while you are
programming your transmitters, it is possible that
their transmitter code will be programmed into
your system, allowing them unauthorized access
to your vehicle.

2-35
Keys and doors
– CONTINUED –
Rear passengers’ window switches
A) Open
B) Close
To close the window, pull the switch up and hold it until
the window reaches the desired position.
When the lock switch on the power window switch
cluster, located on the driver’s side door, is in the
“LOCK” position, the passengers’ windows cannot be
operated with the passengers’ switches.
Trunk lid (Sedan)
" To prevent dangerous exhaust gas from en-
tering the vehicle, always keep the trunk lid
closed while driving. " Help prevent young children from locking
themselves in the trunk. When leaving the vehi-
cle, either close all windows and lock all doors
or cancel the inside trunk lid release. Also make
certain that the trunk is closed. On hot or sunny
days, the temperature in the trunk could quickly
become high enough to cause death or serious
heat-related injuries including brain damage,
particularly for small children.
! To open and close the trunk lid from
outside
The trunk lid can be opened using the remote keyless entry system. Refer to “Remote keyless entry system
(if equipped)” section in this chapter.
To close the trunk lid, lightly press the trunk lid down
until the latch engages.
A B
UB2216BB