2005 SUBARU FORESTER glove box

17
–
CONTINUED –
1
2 3
45
USF031BB
1) Cup holder (page 6-8)
2) Center console (page 6-5)
3) Glove box (page 6-5)
4) Cigarette lighter socket (page 6- 11)
5) Ashtray (page 6-14)

2-2
Keys and doors
Keys and doorsKeys
Vehicle with immobilizer system
A) Master key (Black)
B) Submaster key (Black)
C) Valet key (Gray)
D) Key number plate
E) Security ID plate Vehicle without immobilizer system
A) Master key
B) Submaster key
C) Valet key
D) Key number plate
Three types of keys are provided for your vehicle:
Master key, submaster key and valet key.
The master key and submaster key fit all locks on your vehicle. y Ignition switch
y Driver’s door
y Glove box
AB C
DE
UG2044BD
AB
C
D
HS2011BC

2-3
Keys and doors
– CONTINUED –
The valet key fits only the ignition switch and door lock.
You can keep the glove box locked when you leave
your vehicle and valet key at a parking facility.
Do not attach a large key holder or key case to
either key. If it banged against your knees while
you were driving, it could turn the ignition switch from the ON position to the ACC or OFF
position, thereby stopping the engine.
„ Key number
The key number is stamped on the key number plate
attached to the key set. Write down the key number
and keep it in another safe place, not in the vehicle.
This number is needed to make a replacement key if
you lose your key or lock it inside the vehicle.
For information on making replacement keys for vehi-
cles with the simmobilizer system, refer to the “Immo-
bilizer (if equipped)” in this chapter.
Immobilizer (if equipped)
The immobilizer system is designed to prevent unau-
thorized persons from starting the engine. Only keys
registered with your vehicle’s immobilizer system can
be used to operate your vehicle. Even if an unregis-
tered key fits into the ignition switch and can be turned
to the “START” position, the engine will automatically
stop after several seconds.
Each immobilizer key contains a transponder in which
the key’s ID code is stored. When a key is inserted into
the ignition switch and turned to the “ON” position, the
transponder transmits the key’s ID code to the immo-
bilizer system’s receiver. If the transmitted ID code
matches the ID code registered in the immobilizer sys-
tem, the system allows the engine to be started. Since
the ID code is transmitted and acted upon almost in-
stantly, the immobilizer system does not impede nor-
mal starting of the engine.
If the engine fails to start, pull out the key once before
trying again. (Refer to the “Ignition switch” section
[chapter 3].)
This device complies with Part 15 of the FCC
Rules and with RSS-210 of Industry Canada. Oper- ation is subject to the following two conditions: (1)
This device may not cause harmful interference,

4-19
Climate control
– CONTINUED –
„Replacing an air filter0
1. Remove the glove box.
1) Open the glove box.
2) Remove the nine screws securing the glove box. A) Air filter cover
2. Remove the air filter cover.
HS4024BA
AHS4025BC

4-21
Climate control
– CONTINUED –
5. Reinstall the glove box.
6. Close the glove box. A) Service label
B) Caution label
7. LABEL installation 1) Fill out the information on the service label
(small).
2) Attach the service label to the driver side door pil-
lar and the caution label to the driver side end of the
instrument panel.
Contact your dealer if the following occurs,
even if it is not yet time to change the filter:
– Reduction of the air flow through the vents.
HS4024BA
A
B
US4528BB

6-1
6
Interior equipment
Interior lights ................................................ 6-2 Dome light ......................................................... 6-2
Cargo area light ................................................ 6-2
Map lights ...................................................... 6-3
Sun visors ..................................................... 6-3 Vanity mirror ...................................................... 6-4
Storage compartments ................................ 6-4 Glove box ........................................................... 6-5
Center console .................................................. 6-5
Overhead console ............................................. 6-6
Dashboard storage compartment ................... 6-6
Convenience net ............................................... 6-7
Coin tray ............................................................ 6-7
Cup holders .................................................. 6-8 Front passenger’s cup holder ......................... 6-8
Rear passenger’s cup holder ........................... 6-8
Accessory power outlets ............................. 6-9
Cigarette lighter socket ................................ 6-11 Use with a cigarette lighter .............................. 6-12
Using as an accessory power outlet ............... 6-13
Ashtray .......................................................... 6-14
Floor mat ....................................................... 6-15
Coat hook ...................................................... 6-16
Cargo area cover (if equipped) .................... 6-16 Using the cover ................................................. 6-16
To remove the cover ......................................... 6-17
To install the cover housing ............................ 6-17
Shopping bag hook ...................................... 6-18
Cargo tie-down hooks .................................. 6-18 Under-floor storage compartment ............... 6-19

6-5
Interior equipment
– CONTINUED –
„Glove box
A) Lock
B) Unlock
To open the glove box, pull the handle. To close it,
push the lid firmly upward.
To lock the glove box, insert the key and turn it clock- wise. „
Center console
To open the lid, pull up the lock release.
If the console lid is fully opened when a large cup is put
in the rear passenger’s cup holder, the lid may hit the
cup and beverage may be spilled.
A B
HS6030BCHS6031BA

14-4
Index
Starting ........................................................... 7-9
Stopping ....................................................... 7-12
Exterior care ...................................................... 10-2 F
Flat tires .............................................................. 9-3
Floor mat ........................................................... 6-15Fluid level Automatic transmission .............................. 11-29
Brake .......................................................... 11-36
Clutch (MT vehicles) ................................... 11-37
Power steering ............................................ 11-34
Fog light button ................................................. 3-27
Front differential gear oil (AT vehicles) ............ 11-31
Front seatbelt pretensioners .............................. 1-31
Front seats .......................................................... 1-2 Fore and aft adjustment ........................... 1-3, 1-5
Reclining .................................................. 1-4, 1-7
Fuel ..................................................................... 7-2 Economy hints ................................................ 8-2
Filler lid and cap ............................................. 7-4
Gauge ............................................................. 3-9
Requirements ................................................. 7-2
Fuses .............................................................. 11-60
Fuses and circuits ............................................. 12-6 G
GAWR ............................................................... 8-16
Glove box ............................................................ 6-5
Gross Axle Weight Rating ................................. 8-16
Gross Vehicle Weight Rating ............................ 8-16
GVWR ............................................................... 8-16 H
Hazard warning flasher ....................................... 3-7
Headlight flasher ............................................... 3-24
Headlights ......................................................... 3-23
Headrest adjustment ......................................... 1-12
Heater operation ................................................. 4-6
High beam indicator light ................................... 3-21
Hill holder ............................................... 7-36, 11-40
Horn .................................................................. 3-40 I
Ignition switch ...................................................... 3-3
Illuminated entry ................................................ 2-11
Illumination brightness control ........................... 3-26
Immobilizer indicator light .................................... 2-5
Indicator light ..................................................... 3-12
Inside mirror ...................................................... 3-35
Interior lights ........................................................ 6-2