Page 419 of 477
11 - 5 4
Maintenance and service
A) Stopper
Be sure to position the claws at the end of the metal
support between the stoppers on the rubber as shown.
If the rubber is not retained properly, the wiper blade
may scratch the windshield.
6. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
7. Lower the wiper arm. „
Rear window wiper blade
1. Raise the wiper arm off the rear window.
2. Turn the wiper blade assembly counterclockwise.
A
HSB062BC
USB581BA
Page 435 of 477
11 - 7 0
Maintenance and service
6. Remove the bulb socket from the headlight assem-
bly by turning it counterclockwise.
7. Pull the bulb out of the socket. Install a new bulb.
8. Set the bulb socket into the headlight assembly and
turn it clockwise until it locks.
9. Reinstall all the removed parts by following the re-
moval sequence in reverse. „
Front fog light
It may be difficult to replace the bulbs. Have your
SUBARU dealer replace the bulbs if necessary. „ Rear combination lights
1. Remove the upper and lower screws. Then, slide
the rear combination lamp assembly to the rear and
HSB073CAHSB080BA
Page 436 of 477
11 -7 1
Maintenance and service
– CONTINUED –
remove it from the vehicle.
A) Tail/stop light
B) Rear turn signal light
C) Backup light
D) Tail/stop light
2. Remove the bulb holder from the rear combination
light assembly by turning it counterclockwise.
3. Pull the bulb from the holder. Install a new bulb.
4. Set the bulb holder into the rear combination light
assembly and turn it clockwise until it locks.
5. Reinstall the rear combination light assembly.
HSB085BA
C
B
A
D
HSB086BC
Page 448 of 477