11 - 5 8Maintenance and service
18 February 2004
2. Pull the blade rubber assembly out of the plastic
support.
A) Metal spines3. If the new blade rubber is not provided with two
metal spines, remove the metal spines from the old
blade rubber and install them in the new blade rubber.
USB586BA
A
USB583BC
ProCarManuals.com
11 -5 9
Maintenance and service
– CONTINUED –
11
18 February 2004
4. Align the claws of the plastic support with the
grooves in the blade rubber assembly, then slide the
blade rubber assembly into place.Securely retain both ends of the rubber with the stop-
pers on the plastic support ends. If the rubber is not re-
tained properly, the wiper may scratch the rear win-
dow glass.
5. Install the wiper blade assembly to the wiper arm.
Make sure that it locks in place.
6. Hold the wiper arm by hand and slowly lower it in
position.
USB586CA
USB584BA
ProCarManuals.com
