2005 PORSCHE CAYENNE TURBO engine

324
Practical Tips, Minor Repairs
Jump lead startingAlways observe the sequence below:
1. Remove cover A.
2. Open the cap of the positive terminal for jump
starting(+).
3. Attach the positive lead first to the positive
terminal for jump starting (+), then to the posi-
tive terminal of the donor battery.
4. Connect the negative lead first to the negative
terminal of the donor battery, then to the
grounding point for jump starting (–).
+ = Positive terminal for jump starting
– = Grounding point for jump starting5. Run the engine of the donor car at a higher
speed.
6. Start the engine.
An attempted start using jumper cables should
not last more than 15 seconds. Then allow a
waiting period of at least one minute.
7. Disconnect the negative jumper cable from the
ground point for jump starting (–) first, then
from the negative terminal of the donor bat-
tery.8. Disconnect the positive jumper cable from the
positive terminal of the donor battery first,
then from the positive terminal for jump start-
ing (+).
9. Close the cap of the positive terminal for jump
starting (+).

Practical Tips, Minor Repairs
325
Charging the batteryYour authorized Porsche dealer will be pleased to
advise you about a suitable charger.
1. Always observe the instructions of the charger
manufacturer.
2. When charging the battery, ensure adequate
ventilation.
3. Check the acid level of a low-maintenance bat-
tery.
4. Connect charger to the jump starting points.
Only plug into the mains and switch the charg-
er on when it has been correctly connected up.
5. After charging, disconnect the charger.
6. Check the acid level of a low-maintenance bat-
tery.
After charging the battery After the battery is connected or the completely
discharged battery is charged, the PSM warning
light lights up on the instrument panel and a mes-
sage appears on the multi-purpose display of the
instrument panel to indicate a fault.
This fault can be remedied with a few simple
steps:
1. Start the engine.
To do this, turn the ignition key or the control
unit (on vehicles that have Porsche Entry &
Drive) to ignition lock position 2 twice.
2. Perform a few steering movements to the left
and to the right when vehicle is standing and
drive a short distance in a straight line until the
PSM warning light goes out and the message
is erased from the memory of the multi-pur-
pose display of the instrument panel.
3. If the warnings does not go out, then:
Drive carefully to the nearest authorized
Porsche dealer.
Have the fault remedied by an authorized
Porsche dealer.
4. After the warnings disappear:
Stop the vehicle in a suitable place.
5. Perform adaptation of the power windows:
Please observe the chapter “STORING FINAL
POSITION OF THE DOOR WINDOWS” on
Page 31.6. On vehicles with tire pressure monitoring sys-
tem:
Please observe the chapter “TIRE PRESSURE
MONITORING SYSTEM LEARNING PROCESS”
on Page 87.

Practical Tips, Minor Repairs
327
Bulb Chart
Type, rating Type, rating
Exterior lights Interior lights
Xenon low beam and high beam D1S Interior light, front W5W
Side marker light, rear P21/5W Reading light W5W
Side marker light, front W5W Engine compartment light W5W
Turn signal light, rear P21W Footwell light W3W
Turn signal light, front PY21W Glove compartment light W3W
Brake light P21W Center console W3W
License plate light C5W Luggage compartment light K12V10W
Fog light H11 Curb lights (doors) W3W
Rear fog light P21/4W Warning lights (doors) W3W
Back up light P21W Kerb light (rear lid) W5W
Side indicator light W5W Curb lights (rear lid) W5W
Additional high beam H7
Cornering light H3

Practical Tips, Minor Repairs
339
Height adjustment for low beam/
high beam and additional high beam1. Push down cover in the engine compartment
and remove.
2. Switch ignition on.
3. Switch on low beam and/or high beam.
4. Adjust low beam in direction of the arrow.
Changing Headlights from Left to
Right-Hand TrafficIf you travel to a corresponding country where traf-
fic uses the other side of the road, the headlights
must be partially masked with films when you
cross the border.
fYou can obtain the films and a set of instruc-
tions from an authorized Porsche dealer.

Vehicle Identification, Technical Data
343 Vehicle Identification, Technical Data
Vehicle Identification ................................... 344
Engine Data ............................................... 346
Transmission ............................................. 347
Tires, Rims, Tracks .................................... 348
Tire Pressures, Cold ................................... 350
Capacities ................................................. 351
Weights ..................................................... 352
Driving Performance ................................... 353
Dimensions ................................................ 354
Ground Clearance ...................................... 355

344
Vehicle Identification, Technical Data
Vehicle IdentificationWhen ordering spare parts or making inquiries,
please always quote the vehicle identification num-
ber.Data bankThe data bank is located in the passenger com-
partment below the steering wheel. It contains all
important data about your car.This label contains the following information:
1. Vehicle Identification No.
2. Type/Type description
3. Engine code/Transmission code
4. Paint No./Interior
5. Optional equipment
A duplicate of this label is in your Maintenance
Booklet.
Note
The data bank cannot be reordered when lost or
damaged.
Vehicle identification numberIn accordance with Federal Safety Regulations,
the vehicle identification number of your car is lo-
cated at the bottom left of the windshield frame
and can be seen from the outside and in the lug-
gage compartment on the right in front of the tool
box.

346
Vehicle Identification, Technical Data
Engine DataTy p e
Four-cycle spark-ignition
engine
Number of cylinders 8
Bore
3.66 in. (93 mm)
Stroke 3.27 in. (83 mm)
Displacement
275 cu. in. (4511 cm
3)
Compression ratio 9.5 : 1
Net-horsepower, SAE J 1349
450 HP (331 kw)
at engine speed 6000 rpm
Net. torque, SAE J 1349
460 ftlb. (620 NM)
at engine speed 2250 - 4750 rpm
Maximum permitted engine speed
6500 rpm

Vehicle Identification, Technical Data
351
CapacitiesUse only fluids and fuels authorized by Porsche. Your authorized Porsche dealer will be pleased to advise you.
Your Porsche has been designed so that it is not necessary to mix any additives with oils or fuels.1 Depending on equipment levelEngine oil change quantity without oil filter
approx. 8.5 quarts (8.0 liters)
Engine oil change quantity with oil filter approx. 9.0 quarts (8.5 litres)
Reference indication is the level on the oil dipstick.
Please observe the chapter “ENGINE OIL LEVEL” on Page 236.
Coolant
1)
approx. 4.8 – 5.5 U.S. gallons (18 - 21 liters)
Automatic transmission with torque converter approx. 10.6 quarts (10.1 liters)
Transfer box
approx. 0.9 quarts (0.85 liter)
Front-axle differential approx. 1.1 quarts (1.0 liter)
Rear-axle differential
approx. 1.5 quarts (1.4 liters)
Locking rear differential approx. 1.7 quarts (1.6 liters)
Fuel tank
approx. 26.4 U.S. gallons (100 liters),
including approx. 3.1 U.S. gallons (12 liters) reserve
Fuel quality The engine is designed to provide optimum performance and fuel consumption if unleaded premi-
um fuel with 98 RON/88 MON is used.
If unleaded premium fuels with octane numbers of at least 95 RON/85 MON are used, the engine's
“Electronic Oktane™ knock control“ automatically adapts the ignition timing.
Power steering
approx. 1.6 quarts (1.5 liters) Pentosin CHF 11 S
®
Brake fluid approx. 1.0 quart (0.95 liter)
Use only Original Porsche brake fluid.Window/headlight washer system
approx. 7.9 quarts (7.5 liters)