Page 363 of 464

363 Practical hints
What to do if …
Display symbol
Display message
Possible cause
Possible solution
.
3rd brake light
The high mounted brake lamp is
malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Tail lamp / brake lamp
left
Back-up lamp on
The left tail lamp/brake lamp is
malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.
A backup bulb has been brought
into use.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Tail lamp / brake lamp
right
Back-up lamp on
The right tail lamp/brake lamp is
malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.
A backup bulb has been brought
into use.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Brake lamp
Visit workshop
Brake lamp illumination is delayed
or lamp is permanently on.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Front foglamp, L
The left front fog lamp is malfunc-
tioning.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Front foglamp, R
The right front foglamp is malfunc-
tioning.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Page 364 of 464

364 Practical hintsWhat to do if ….
Rear foglamp
Back-up lamp on
The rear fog lamp on the driver’s
side is malfunctioning. A backup
bulb has been brought into use.
Replace the bulb as soon as possible.
High beam, left
The left high beam lamp (halogen
headlamps)/high beam flasher
lamp (Bi-Xenon* headlamps) is mal-
functioning.
Replace the bulb as soon as possible.
High beam, right
The right high beam lamp (halogen
headlamps)/high beam flasher
lamp (Bi-Xenon* headlamps) is mal-
functioning.
Replace the bulb as soon as possible.
Lamp sensor
Drive to workshop
The light sensor is malfunctioning.
The headlamps switch on automati-
cally.
In the control system, set lamp operation to
manual (
page 137).
Switch on headlamps using the exterior
lamp switch (
page 106).
Visit an authorized Mercedes-Benz Center
as soon as possible.
Left license plate
lamp malfunction
The left license plate lamp is mal-
functioning.
Replace the bulb as soon as possible.
Right license plate
lamp malfunction
The right license plate lamp is mal-
functioning.
Replace the bulb as soon as possible.
Display symbol
Display message
Possible cause
Possible solution
Page 365 of 464

365 Practical hints
What to do if …
.
Low beam, left
The left low beam lamp is malfunc-
tioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:
Visit an authorized Mercedes-Benz Center
as soon as possible.
Low beam, right
The right low beam lamp is malfunc-
tioning.
Halogen headlamp:
Replace the bulb as soon as possible.
Bi-Xenon* headlamp:
Visit an authorized Mercedes-Benz Center
as soon as possible.
Park. light,
front left
The left front parking lamp is mal-
functioning.
Replace the bulb as soon as possible.
Park. light,
front right
The right front parking lamp is mal-
functioning.
Replace the bulb as soon as possible.
Remove key
You have forgotten to remove the
SmartKey.
Remove the SmartKey from the starter
switch.
Side marker lamp,
front left
The left front side marker lamp is
malfunctioning.
Replace the bulb as soon as possible.
Side marker lamp,
front right
The right front side marker lamp is
malfunctioning.
Replace the bulb as soon as possible.
Display symbol
Display message
Possible cause
Possible solution
Page 366 of 464

366 Practical hintsWhat to do if ….
Rear left side marker
lamp malfunction
The left rear side marker lamp is
malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Rear right side marker
lamp malfunction
The right rear side marker lamp is
malfunctioning. This message will
only appear if a critical number of
LEDs have stopped working.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Tail light, left
Back-up lamp on
The left tail lamp is malfunctioning.
This message will only appear if a
critical number of LEDs have
stopped working. A backup bulb
has been brought into use.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Tail light, right
Back-up lamp on
The right tail lamp is malfunction-
ing. This message will only appear if
a critical number of LEDs have
stopped working. A backup bulb
has been brought into use.
Visit an authorized Mercedes-Benz Center
as soon as possible.
Turn off
lights
You have forgotten to switch off the
headlamps when exiting the vehicle
and no SmartKey is in the starter
switch.
Switch off the headlamps.
Display symbol
Display message
Possible cause
Possible solution
Page 373 of 464
373 Practical hints
Where will I find...?
In the case of a flat tire, you may
temporarily use the spare wheel with col-
lapsible tire when observing the following
restrictions:
Do not exceed a vehicle speed of
50 mph (80 km/h).
Drive to the nearest tire repair facility
to have the flat tire repaired or
replaced as appropriate.
Do not operate vehicle with more than
one spare wheel with collapsible tire
mounted.
For more information, see “Rims and tires”
(
page 413).
Spare wheel bolts
1Wheel bolt for light alloy rims
2Wheel bolt for spare wheel with
collapsible tire (located in trunk with
vehicle tool kit)
!Wheel bolts2 must be used when
mounting the spare wheel with
collapsible tire. The use of any wheel
bolts other than wheel bolts2 for the
spare wheel with collapsible tire will
physically damage the vehicle’s
brakes. Warning!
G
Make sure to use the original length wheel
bolts when remounting the original wheel
after it has been repaired.
Page 380 of 464
380 Practical hintsReplacing bulbsSafe vehicle operation depends on proper
exterior lighting and signaling. It is there-
fore essential that all bulbs and lamp as-
semblies are in good working order at all
times.
Correct headlamp adjustment is extremely
important. Have headlamps checked and
readjusted at regular intervals and when a
bulb has been replaced. See an authorized
Mercedes-Benz Center for headlamp ad-
justment.
Bulbs
iIf the headlamps are fogged up on the
inside as a result of high humidity,
driving the vehicle a short distance with
the lights on should clear up the
fogging.iBackup bulbs will be brought into use
when lamps malfunction. Observe the
messages in the multifunction display
(page 363).
Page 382 of 464
382 Practical hintsReplacing bulbsNotes on bulb replacement
Only use 12-volt bulbs of the same type
and with the specified watt rating.
Switch lights off before changing a bulb
to prevent short circuits.
Always use a clean lint-free cloth when
handling bulbs.
Your hands should be dry and free of oil
and grease.
If the newly installed bulb does not
come on, visit an authorized
Mercedes-Benz Center.Have the LEDs and bulbs for the following
lamps replaced by an authorized
Mercedes-Benz Center:
Additional turn signal lamps in the
exterior rear view mirrors
Bi-Xenon* lamps
Front fog lamps
High mounted brake lamp
Brake lamps
Front and rear side marker lamps
Parking/standing lamps in the tail
lamp assemblies
Replacing bulbs for front lamps
Before you start to replace a bulb for a
front lamp, do the following first:
Turn the exterior lamp switch to
positionM (
page 106).
Open the hood (
page 287) (except
for side marker lamps).
iHave the headlamp adjustment
checked regularly.
Page 383 of 464
383 Practical hints
Replacing bulbs
1Housing cover for low beam (halogen
headlamps only)
Housing cover for Bi-Xenon* head-
lamps. Do not remove.
2Bulb socket for turn signal lamp
3Bulb socket for high beam/high beam
flasher lamp
4Bulb socket for parking and standing
light lamp
5Bulb socket for low beam bulb (Halo-
gen headlamps only)Low beam bulb (Halogen headlamps
only)
Turn housing cover1 counterclock-
wise and remove.
Turn bulb socket5 with the bulb
counterclockwise and remove.
Pull the bulb out of bulb socket5.
Press the new bulb into bulb socket5.
Place bulb socket5 back into the
lamp and turn it clockwise.
Reinstall housing cover1.
Warning!
G
Do not remove the cover1 for the Bi-Xe-
non* headlamp. Because of high voltage in
Bi-Xenon lamps, it is dangerous to replace
the bulb or repair the lamp and its compo-
nents. We recommend that you have such
work done by a qualified technician.